Home > Christie > Projector > Christie Projector Mirage M Series User Manual

Christie Projector Mirage M Series User Manual

Here you can view all the pages of manual Christie Projector Mirage M Series User Manual. The Christie manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 131

Section 7: Specifications
Mirage M Series User Manual7-3020-100575-02  Rev. 1  (11-2010)
7.1.10 Convergence
Convergence zones A, B, C are as defined in Figure 2. Zone A has a diameter ¼ of the image height. Zone B has a diameter 
of full image height. All specified convergence errors are between any two colors after a minimum warm-up of 30 minutes. 
Convergence is specified with a 1.4-1.8 HD lens (part number 118-100112-01) in the 1.4:1 position with zero offset. Bore-
sight alignment must be adjusted...

Page 132

7-4Mirage M Series User Manual020-100575-02  Rev. 1   (11-2010)
Section 7: Specifications
7.1.14 Picture Centering (with 1.4-1.8:1 HD lens)
7.2 Feature Set
7.2.1 Airflow 
7.2.2 Air Filters (Optional)
7.2.3 Dust Sealing
7.2.4 ILS (Intelligent Lens System)
7.2.5 Projection Lens Compatibility
HD (1920x1080p) centering error ±5% of vertical offset (±32 pixels)
SXGA+ centering error ±5% of vertical offset (±26 pixels)
WUXGA centering error ±5.5% of vertical offset (±32 pixels)
Air intakes                Right...

Page 133

Section 7: Specifications
Mirage M Series User Manual7-5020-100575-02  Rev. 1  (11-2010)
Lens Throw Ratio
7.2.6 Iris 
7.2.7 Automatic Fans
7.2.8 Constant Lamp Output Management
7.2.9 Shutter 
Lens DescriptionPart NumberWUXGA Throw Ratio
FixedLens ILS 0.73:1SX+/0.67:1HD118-100110-xx 0.67
Lens ILS 1.2SX+/1.1HD 118-100117-xx 1.1
ZoomLens ILS 1.25-1.6SX+/1.16-1.49HD
118-100111-xx 1.16-1.49
Lens ILS 1.5-2.0SX+/1.4-1.8HD118-100112-xx 1.4-1.8
Lens ILS 2.0-2.8SX+/1.8-2.6HD118-100113-xx 1.8-2.6
Lens ILS...

Page 134

7-6Mirage M Series User Manual020-100575-02  Rev. 1   (11-2010)
Section 7: Specifications
7.2.10 Lamps
7.2.11 Status LED
7.2.12 Electronics/SW 
Dual Mercury lamp system               Lamps are accessed from side of projector
Lamps are individually swappable while the 
projector is running 
Status LED’s               Located at back of projector
LED STATES
Lamp 1, Lamp 2Off – Lamps are off
Yellow – Lamp time has expired and lamp should be replaced
Green – Lamp is on and operating correctly
Flashing red –...

Page 135

Section 7: Specifications
Mirage M Series User Manual7-7020-100575-02  Rev. 1  (11-2010)
7.3 Image Processor Performance
7.4 Input (Source Signal) Compatibility 
7.4.1 Analog (Only) Input
7.4.2 Twin HDMI Input
7.4.3 Dual Link DVI Input
Min input pixel rate 13 Mpix/s
Max input pixel rate 330MHz over dual link DVI-D
Max input resolution 2048x1536 (QXGA)
Min input resolution 640x400
Max input frame rate with 
Standard Image Processor 
Card59Hz at 2560x1600 (QXGA) * * With sources that can output minimum...

Page 136

7-8Mirage M Series User Manual020-100575-02  Rev. 1   (11-2010)
Section 7: Specifications
7.4.4 Video Decoder Input
7.4.5 Dual SD/HD-SDI
7.5 Control Signal Compatibility 
7.5.1 Projector Control
7.5.2 Control Receiver
7.5.3 RS-232
Connectors 2 S-Video 4-pin miniature DIN
4 BNC, 75 Ohm 
2 independent decoder channels for PIP
Color space/Signal types Composite video
Component video (SD and ED only)
S-video
Video Standards NTSC, NTSC 4.43, PAL, PAL M, PAL N, PAL 60, 
SECAM
A/D conversion 10 bits
Connectors...

Page 137

Section 7: Specifications
Mirage M Series User Manual7-9020-100575-02  Rev. 1  (11-2010)
7.5.4 RS-422
7.5.5 Ethernet
7.5.6 USB 2.0 Device Port 
7.5.7 GPIO
7.5.8 Built-In Keypad and Display
7.5.9 AMX/Crestron Support
7.6 Power Requirements
Number of ports 1
Connector 1 female 9-pin Dsub
Max bit rate 115.2 kbps
Power output 12 V ±5% @ 400mA maximum
Number of ports 1
Standard 10/100 Base-T
Connector Female RJ-45
Number of ports 1
Standard Supports: mass storage device type, Ethernet 
device type, and/or...

Page 138

7-10Mirage M Series User Manual020-100575-02  Rev. 1   (11-2010)
Section 7: Specifications
7.6.1 Lamp Specification
7.7 Physical Specifications
7.7.1 Size
Maximum Power Consumption Dual Lamp Single Lamp
370W 1080p 1320W 831W
350W 1080p 1267W 805W
300W 1080p 1135W 739W
200W 1080p 871W 607W
150W 1080p 739W 541W
370W SXGA+ 1320W 831W
350W SXGA+ 1267W 805W
300W SXGA+ 1135W 739W
200W SXGA+ 871W 607W
150W SXGA+ 739W 541W
370W WUXGA+ 1320W 831W
350W WUXGA+ 1267W 805W
300W WUXGA+ 1135W 739W
200W WUXGA+ 871W...

Page 139

Section 7: Specifications
Mirage M Series User Manual7-11020-100575-02  Rev. 1  (11-2010)
7.7.2 Adjustment
7.7.3 Weight
7.7.4 Operating Position
7.8 Reliability and Serviceability
7.8.1 Reliability
7.8.2 Serviceability
7.9 Environment
7.9.1 Temperature/Humidity/Altitude
Product Alignment 2” of vertical adjustment on 2 front feet
1” of vertical adjustment on single rear foot
Maximum product weight (with lens removed) 25kg (55lb.) 
Maximum shipping weight (includes packaging) 40kg (87lb.)
Horizontal ±20...

Page 140

7-12Mirage M Series User Manual020-100575-02  Rev. 1   (11-2010)
Section 7: Specifications
7.10 Accessories and Service Components
7.10.1 Service Components
7.11 Regulatory 
This product conforms to the following regulations related to product safety, environmental requirements and 
electromagnetic compatibility (EMC).
• FCC Part 15, Subpart B Class A; CISPR22/EN55022; CISPR24/EN55024
• UL 60950-1 First Edition; CAN/CSA-C22.2 No. 60950-1-03 First edition;
• IEC60950-1:2001
• 2002/95/EC RoHS
Product...
Start reading Christie Projector Mirage M Series User Manual

Related Manuals for Christie Projector Mirage M Series User Manual

All Christie manuals