Christie Projector Mirage 4K35 User Manual

   Troubleshooting
Mirage 4K35 User Manual81
020-101377-03 Rev. 1 (07-2015)
• Ensure no heat sources are exhausting into the  projectors intake, or move the projector to a 
cooler environment.
• Verify the number of hours the lamp has operated . A lamp nearing the end of its operational life 
should be replaced.
• Check for a cross-connected condition. A cross-connection hazard can occur when installin g multiple projectors at once. A fire hazard 
exists if a lamp power supply interlock cable is...

   Troubleshooting
Mirage 4K35 User Manual82
020-101377-03 Rev. 1 (07-2015)
• Make sure that any test pattern (other than a full black test pattern or test pattern = none) 
displays properly.
Cannot communicate with projector
• Make sure the computer and the projector are both connected to the network.
• Make sure that all input devices have the same subnet mask and unique IP addresses.
Inaccurate display colors
• Adjust the color, tint, color space, and co lor temperature settings of the input source....

   Troubleshooting
Mirage 4K35 User Manual83
020-101377-03 Rev. 1 (07-2015)
Incoming signal(s) problems
The Status tab > Signal group contains information about all the signals that the projector receives. 
A properly configured system shows the frequency an d a status of Master or Locked for each input 
in the selected channel.
• If one or more of the signals are listed as No  signal, verify that the source is properly 
configured and the cables are secure between the source and the projector.
• If one...

   Troubleshooting
Mirage 4K35 User Manual84
020-101377-03 Rev. 1 (07-2015)
MCPU board power LED behavior
• Solid yellow—The MCPU board must be replaced . Indicate that the MCPU board failed to 
initialize.
• Blinking red—The MCPU board must be replaced. Indicate that the MCPU board failed to  initiate the control FPGA.
• Blinking yellow/green—The MCPU board is running in recovery mode and needs a software  upgrade followed by a AC cycle of the projector head.
Touch panel controller does not connect
If...

   Troubleshooting
Mirage 4K35 User Manual85
020-101377-03 Rev. 1 (07-2015)
With 3D mode enabled, Mirage 4K35 projecto rs apply the following multiplication rules:
• Incoming ~48Hz => Outgoing ~144Hz (triple)
• Incoming ~50Hz => Outgoing ~150Hz (triple)
• Incoming ~60Hz => Outgoing ~120Hz (double)
For more details, refer to the TDM–3D Mode (Mirage 4K) section in the  Christie D4K and Mirage 4K 
Serial API Commands Technical Reference (P/N: 020-101258-XX) .
Run the projector interrogator
The interrogator...

Mirage 4K35 User Manual86
020-101377-03 Rev. 1 (07-2015)
Specification
This section provides detailed Mirage 4K35 specific ations. Due to continuing research, specifications 
are subject to change without notice.
Display
Panel Resolution and refresh rate
Pixel format (H x V square pixels) 4096 x 2160
Processing path 23.97 - 60Hz
Achievable brightness (measured at screen center)
Nominal
2.0 kW (CDXL-20) 10,000 lumens
2.0 kW (CDXL-20SP) 10,000 lumens
3.0 kW (CDXL-30) 18,000 lumens
3.0 kW (CDXL-30SP) 19,000...

   Specification
Mirage 4K35 User Manual87
020-101377-03 Rev. 1 (07-2015)
White point
Nominal white 
(full white, after calibration) y 
= 0.351 ± 0.002
x =  0.314 ± 0.002
Gamma
Nominal 2.6 ± 5% 

   Specification
Mirage 4K35 User Manual88
020-101377-03 Rev. 1 (07-2015)
Mirage signal connectivity2D/
3D
Input 
Configuration
3D 
Type
Input 
Format
Frame 
Rate 
(Hz)
Interface
Cards
Cables
RGB/
4:4:4 
8-bit
RGB/
4:4:4 
10-bit
RGB/
4:4:4 
12-bit
4:2:
2 8-
bit
4:2:
2 
10-
bit
4:2:
2 
12-
bit
3D Four-Port Direct 4K, QHD 120 DisplayPort  1.1a4x TDPIC 4 X X
3D Four-Port Direct 4K, QHD 120 DVI (Dual) 4x DDIC 4 X
3D Four-Port Dual- Input4K, QHD 60 DisplayPort 
1.1a4x TDPIC 8 X X X X X
3D Four-Port Dual-...

   Specification
Mirage 4K35 User Manual89
020-101377-03 Rev. 1 (07-2015)
3D Two-Port Direct 4K, QHD 48, 50 DVI 2x DDIC 2 X
3D One-Port Dual-
Input 2K, HD 60 DisplayPort 
1.1a1x TDPIC 2 X X
X X X
3D One-Port Dual-
Input 2K, HD 60 HDMI 1.4a 1x THIC 2 X X X X X X
3D One-Port Dual-
Input 2K, HD 60 3G-SDI 1x 3GIC 2
X
3D One-Port Dual-
Input 2K, HD 60 DVI (Single) 2x DDIC 2 X
3D One-Port Direct 2K, HD 120 DisplayPort 
1.1a1x TDPIC 1 X X
3D One-Port Direct 2K, HD 120 DVI (Dual) 1x DDIC 1 X
3D One-Port Direct...

   Specification
Mirage 4K35 User Manual90
020-101377-03 Rev. 1 (07-2015)
• 4K = 4096 x 2160 • QHD = 3840 x 2160
• 2K = 2048 x 1080 • HD = 1920 x 1080