Canon Wux450, Wx520 Multimedia Projector Users Manual

21
Safety Instructions
Safety Instructions
Federal Communication Commission Notice
Multimedia Projector, Model: WUX450 / WX520
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a 
Class B digital device,...

Safety Instructions
22
This section describes the safety symbols used in this manual. Important projector 
safety information is identified by the following symbols. Always observe the safety 
information by these symbols.
Safety Symbols in this Manual
Denotes the risk of death or serious injury from improper 
handling if the information is not observed. To ensure safe use, 
always observe this information.
Denotes the risk of injury from improper handling if the 
information is not observed. To ensure...

23
Safety Instructions
Safety Instructions
Precautions for Use
As this section contains important safety-related information, be sure to read the 
following carefully beforehand in order to use your projector correctly and safely.
If the following situations occur, turn the power off, remove the power plug from the 
power outlet and contact the Canon Customer  Support Center. Failure to do so could 
cause a fire or result in an electric shock.
•If smoke is emitted
• If an unusual smell or noise is...

Safety Instructions
24
Precautions for Installation
Pay attention to the following points regarding the power source, power plug and 
handling of the connector. Failure to do so may cause a fire, electric shock or personal 
injury.
•Do not use any power source with a voltage other than the voltage indicated 
(AC 100–240 V).
•Do not pull the power cord and be sure to hold the power plug or connector 
when removing. The cord could be damaged as a result.
• Do not insert any metal objects into the contact...

25
Safety Instructions
Safety Instructions
Pay attention to the following points regarding installation and handling of the projector. 
Failure to do so may cause a fire, electric shock or personal injury.•Do not move the projector until you have switched off the power, removed 
the power plug from the power outlet and unplugged any other cables.
• Do not remove the cabinet from the projector or disassemble it. The interior 
of the projector contains high-voltage components as well as parts that are...

Safety Instructions
26
Precautions on the lamp
Pay attention to the following points regarding installation and handling of the projector.•Do not place any heavy objects on top of the projector or sit / stand on it. Pay 
particular attention to prevent small  children from doing so. The projector 
may be knocked over and this could result in damage or a personal injury.
• Do not place the projector on an unstab le or slanted surface. Doing so may 
cause the projector to fall or be knocked over and could...

27
Safety Instructions
Safety Instructions
Precautions for the batteries of the remote 
control
When handling the lamp, pay attention to the following points.•Be sure not to handle the lamp immediately after it has been used. Be sure 
to switch off the power and wait for approximately 1 hour for the lamp and 
the projector to cool down sufficiently. Failure to do so could result in a burn 
or personal injury due to heat from the lamp or projector.
• When an instruction to replace the la mp has been...

28
For Safe Use
Pay attention to the following points when carrying or transporting the projector.•This projector is a precision instrument.  Do not knock it over or subject it to 
impacts. Doing so ma y cause a malfunction.
• Do not reuse any packaging or shock-absorbent materials that were 
supplied with the projector at the time of purchase for transporting or 
shipping the projector. Protection of  the projector cannot be guaranteed if 
used packaging or shock-absorbent ma terials are reused....

29
For Safe Use
For Safe Use
Pay attention to the following points when installin g or using the projector.
• Do not touch the lens with bare hands.  Doing so may result in deterioration 
of image quality.
• If the projector is suddenly moved from a location where the temperature is 
low to a location where the temperature  is high, or if the temperature in the 
location where the projecto r is installed increases suddenly, moisture in the 
air could cause condensation to form on  the projector lens or...

30