Canon Projector WUX4000 User Manual

11
Safety Instructions
Safety Instructions
Safety Precautions
WARNING:
• THIS APPARATUS MUST BE GROUNDED.
• TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS 
APPLIANCE TO RAIN OR MOISTURE.
 This projector produces intense light from the projection lens. Do not stare directly into  the lens, otherwise eye damage could result.  Be especially careful that children do not 
stare directly into the beam.
 Install the projector in a proper position. Otherwise it may result in a fire hazard....

Safety Instructions
12
■READ AND KEEP THIS OWNER’S MANUAL FOR LATER USE.
All the safety and operating instructions shou ld be read before beginning to operate the 
product.
Read all of the instructions given here and reta in them for later use. Unplug this projector 
from the AC power supply before cleaning. Do not use liquid or aerosol cleaners on the 
projector. Use a damp cloth for cleaning.
Follow all warnings and instructions marked on the projector.
 
For added protection of the projector during  a...

13
Safety Instructions
Safety Instructions
Never push objects of any kind into this projector through cabinet slots as they may touch 
dangerous voltage points or short out parts that could result in a fire or electric shock. 
Never spill liquid of any kind onto the projector.
Do not install the projector near the ventil ation duct of air-conditioning equipment.
This projector should be operated using only  the type of power source indicated on the 
marking label. If you are not sure of the  type of...

Safety Instructions
14
AC Power Cord Requirement
The AC Power Cord supplied with this projector meets the requirements for use in the 
country you purchased it.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EAS-
ILY ACCESSIBLE.
AC Power Cord for the United States and Canada:
The AC Power Cord used in the United States and Canada is 
listed by the Underwriters Labora tories (UL) and certified by the 
Canadian Standard Association (CSA).
The AC Power Cord has a grounding-type AC line plug....

15
Safety Instructions
Safety Instructions
Federal Communication Commission Notice
Multimedia Projector, Model: WUX5000 / WUX4000
This device complies with Part 15 of the FCC Rules.  Operation is subject to the follow-
ing two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and foun d to comply with the limits for a Class B 
digital...

Safety Instructions
16
Precautions for Use
As this section contains important safety-related information, be sure to read the following
carefully beforehand in order to use your projector correctly and safely.
If the following situations occur, turn the power off, remove the power plug from the 
power outlet and contact the Canon Customer Support Center. Failure to do so could 
cause a fire or result in an electric shock. 
• If smoke is emitted
 If an unusual smell or noise is emitted
 If a loud noise is...

17
Safety Instructions
Safety Instructions
Precautions for Installation
Pay attention to the following points regarding the power source, power plug and han-
dling of the connector. Failure to do so could result in a fire, electric shock or personal 
injury. 
 Do not use any power source with a voltage  other than the voltage indicated (AC 100 
– 240 V).
 Do not pull the power cord and be sure to hold the power plug or connector when  removing. The cord could be damaged as a result.
 Do not insert any...

Safety Instructions
18
Pay attention to the following points regarding installation and handling of the projector. 
Failure to do so may cause a fire, electric shock or personal injury.
• Do not move the projector until you have  switched off the power, removed the power 
plug from the power outlet and  unplugged any other cables.
 Before installing or replacing a lens unit, make sure to remove the power plug from  the outlet. Failure to do so could result in an electric shock or injury.
 Do not remove...

19
Safety Instructions
Safety Instructions
Precautions on the lamp
Pay attention to the following points regarding installation and handling of the projector.
• Do not place any heavy objects on top of the  projector or sit / stand on it. Pay partic-
ular attention to prevent small children fr om doing so. The projector may be knocked 
over and this could result in damage or a personal injury. 
 Do not place the projector on an unstable or slanted surface. Doing so may cause  the projector to fall or be...

Safety Instructions
20
Precautions for the batteries of the remote control
When handling the lamp, pay attention to the following points.
 Be sure not to handle the lamp immediately  after it has been used. Be sure to switch 
off the power and wait for approximately 1 ho ur for the lamp and the projector to cool 
down sufficiently. Failure to do so could result in a burn or personal injury due to heat 
from the lamp or projector.
 When an instruction to replace the lamp  has been displayed (LAMP...