Canon printer FAXPHONE L170 User Manual

Setting Up Your Machine
2
The Toner Cartridge2-16
•Do not expose the cartridge to direct sunlight or bright light for longer than 5 minutes.•Do not store the cartridge in direct sunlight.•Avoid locations subject to high temperature, high humidity, or rapid changes in temperature. Store the cartridge between 
32° and 95°F ( 0° and 35°C).
•Hold the cartridge as shown so that your hand is not touching the drum’s protective shutter.•Store the cartridge in its protective bag. Do not open the bag until you are...

Setting Up Your Machine
2
The Toner Cartridge2-17
4Gently rock the cartridge several times to evenly distribute the toner inside.
NOTE
Always hold the cartridge as shown so that the side with the instructions are facing upward. Do not forcefully move or push the protective 
shutter of the drum in any way.
5Hold the cartridge on a flat stable surface with one hand, and break the tab and pull out the seal completely with the other hand.
6Open the printer cover.
NOTE
If you are replacing the old cartridge...

Setting Up Your Machine
2
The Toner Cartridge2-18
7Hold the cartridge and position the arrow mark on the cartridge towards the inside of the machine as shown below.
8Align the projections   on both sides of the cartridge to the guides   in the machine and slide the cartridge completely into 
the machine.
9Close the printer cover. 

CHAPTER
Guidelines for Entering Information3-1
3
Registering Information in the 
Machine 
This chapter describes how to enter information in your machine.
Guidelines for Entering Information
The following section explains how to enter user information into the machine.
NOTE
If you pause while entering information and do not make an entry for more than 60 seconds, the machine returns to standby mode and 
loses all information you had entered up to that point. You will then have to start again.
The time...

Registering Information in the Machine
3
Guidelines for Entering Information3-2
1Press [ ] to switch to the letter mode (:A) or the number mode (:1).
You can see what mode you are in by the character indicated on the top right corner of the LCD display.
2Use the numeric buttons to enter the letter or number. 
Press the button repeatedly until the letter or number you want appears.
●To enter two letters or symbols that are under the same button:
❑
Press the numeric button ➞ [ (+)] ➞ press the same numeric...

Registering Information in the Machine
3
Personalizing Your Machine3-3
Personalizing Your Machine
Registering Required Sender Information
In the United States, FCC rules governing the use of facsimile equipment state that the following sender information must 
be printed on every facsimile transmission:
•Your fax number•Your personal name or company name
•The time and date of transmission
Your machine has been designed to print this information at the top of every fax you send. You must therefore...

Registering Information in the Machine
3
Personalizing Your Machine3-4
Entering the Date and Time
Follow this procedure to enter the date and time: 
1Press [Menu].
2Press [ (-)] or [ (+)] to select  ➞ press [Set] twice.
3Use the numeric buttons to enter the date (month/day/year) and time (in 24-hour format) ➞ press [Set].
Enter only the last 2 digits of the year.
4Press [Stop/Reset] to return to standby mode.
Registering Your Fax Number and Name
Follow this procedure to register your fax/telephone number...

Registering Information in the Machine
3
Personalizing Your Machine3-5
Setting the Telephone Line Type
Use this procedure if you need to change the telephone line setting.  is set as the default setting.
If you are unsure which setting to use, contact your local telephone company.
Follow this procedure to set the telephone line type:
1Press [Menu].
2Press [ (-)] or [ (+)] to select  ➞ press [Set] three times.
3Press [ (-)] or [ (+)] to select  ➞ press [Set].
4Press [ (-)] or [ (+)] to select the...

Registering Information in the Machine
3
Personalizing Your Machine3-6
7Press [ (-)] or [ (+)] to select the week in which the daylight saving time starts ➞ press [Set] twice.
You can select from the following:
-<
FIRST WEEK>
-
-
-
- (fourth or fifth week depending on the selected month)
8Press [ (-)] or [ (+)] to select the day of the week on which the daylight saving time starts ➞ press [Set] twice.
9Use the numeric buttons to enter the time at which the daylight saving time compensation is made ➞...

CHAPTER
Print Media Requirements4-1
4Paper Handling
This chapter describes how to select and prepare the print media for the different functions your machine can perform. 
Print Media Requirements
For high-quality printing, we recommend using paper and transparencies recommended by Canon. Some types of paper 
available at office supply stores may not be suitable for the machine. If you have any questions about paper and 
transparencies, contact the Canon Customer Care Center.
■Paper StorageIn order to...