Canon Maxify Ib4020 User Guide

Important•
To save the page size, orientation, and number of copies that was set in each sheet, click Options...,
and check each item.
Note
•
When you re-install the printer driver or upgrade the printer driver version, the print settings that are already registered will be deleted from  Commonly Used Settings.
Registered print settings cannot be saved and preserved. If a profile is deleted, register the print settings again.
Deleting Unnecessary Printing Profile
1.
Select the printing profile to be...

Managing the Printer PowerThis function allows you to manage the printer power from the printer driver.
The procedure for managing the printer power is as follows:
 Power Off
The  Power Off  function turns off the printer. When you use this function, you will not be able to turn the
printer on from the printer driver.
1.
Open the printer driver setup window
2.
Execute power off
Click  Power Off  on the Maintenance  tab. When the confirmation message appears, click  OK.
The printer power switches off, and...

Click OK. When the confirmation message appears, click  OK.
The  Maintenance  tab is displayed again.
The setting is enabled after this. When you want to disable this function, select  Disable from the list
according to the same procedure.
Note
•
When the printer is turned off, the Canon IJ Status Monitor message varies depending on the  Auto
Power On  setting.
When the setting is  Enable, "Printer is standing by" is displayed. When the setting is  Disable,
"Printer is offline" is...

Reducing the Printer NoiseThe silent function allows you to reduce the operating noise of this printer. Select when you wish to reduce
the operating noise of the printer at night, etc.
Using this function may lower the print speed.
The procedure for using the quiet mode is as follows:
 Quiet Settings
1.
Open the printer driver setup window
2.
Click  Quiet Settings  on the Maintenance  tab
The  Quiet Settings  dialog box opens.
Note
•
If the printer is off or if communication between the printer and the...

Changing the Printer Operation ModeIf necessary, switch between various modes of printer operation.
The procedure for configuring  Custom Settings is as follows:
 Custom Settings
1.
Open the printer driver setup window
2.
Make sure that the printer is on, and then click  Custom Settings on the Maintenance
tab
The  Custom Settings  dialog box opens.
Note
•
If the printer is off or if communication between the printer and the computer is disabled, an
error message may appear because the computer cannot...

Ink Drying Wait TimeYou can set the length of the printer rest time until printing of the next page begins. Moving the
slider to the right increases the pause time, and moving the slider to the left decreases the time. If the paper gets stained because the next page is ejected before the ink on the printed page
dries, increase the ink drying wait time. Reducing the ink drying wait time speeds up printing.4.
Apply the settings
Click  OK and when the confirmation message appears, click  OK.
The printer...

Changing the Machine Settings on the LCD
Changing the Printer Settings on the LCD
Output settings
LAN settings
Dev. user settings
Firmware update
Cassette settings
Reset setting
About Quiet setting
Turning on/off the Printer Automatically
Using the Printer with the Access Point Mode
197
 

Changing the Printer Settings on the LCDThis section describes the procedure to change the settings in the  Device settings screen, taking the steps
to specify  Prevent abrasion  as an example.
Note
•
The * (asterisk) on the LCD indicates the current setting.
1.
Make sure that the printer is turned on.
2.
Press the Setup button.
The  Setup menu  screen is displayed.
3.
Use the  button to select  Device settings, then press the OK button.
The  Device settings  screen is displayed.
4.
Use the  button to...

About Quiet setting
199
 

Output settings•
Prevent abrasion
Use this setting only if the print surface becomes smudged.
Important
•
Be sure to set this back to  OFF after printing since it may result in lower printing speed or lower
print quality.
200