Canon Lbp 3300 User Guide

3-6Installing the CAPT Software
Setting Up the Printing Environment
3
NOTE
•For details on the procedure for installing the software when installing the optional 
network board and connecting the printer to the computer with LAN, see Network 
Guide.
•For details on the procedure for installing the software when sharing this printer on a 
network and printing from a computer on the network, see Printing from a Network 
Computer by Sharing the Printer on a Network, on p. 3-58.
•A USB cable is only supplied...

3-7Installing the CAPT Software
Setting Up the Printing Environment
3
3Connect the B-type (square) end of the USB cable to the USB 
connector on the printer, then close the expansion slot cover.
4Connect the A-type (flat) end of the USB cable to the USB port 
on the computer.
 

3-8Installing the CAPT Software
Setting Up the Printing Environment
3
5Turn the computer on and start up Windows.
IMPORTANT
If a Wizard appears by the Plug and Play automatic setup, click [Cancel], and then 
install the CAPT software using this procedure.
6Insert the supplied LBP3300 User Software CD-ROM into 
the CD-ROM drive.
If the CD-ROM is already in the drive, eject the disk and re-insert it into the drive.
IMPORTANT
If CD-ROM Setup does not appear, select [Run] from the [Start] menu, enter...

3-9Installing the CAPT Software
Setting Up the Printing Environment
3
8Click [Install].
If you selected [Custom Installation] in Step 7, clear the [Online Manuals] check 
box, and then click [Install].
9Click [Next].
 

3-10Installing the CAPT Software
Setting Up the Printing Environment
3
10Confirm the contents and select [I accept the terms in the 
license agreement], and then click [Next].
11Select [Manually Set Port to Install], then click [Next].
 

3-11Installing the CAPT Software
Setting Up the Printing Environment
3
12Select the [Install Printer Driver through a USB Connection] 
check box, then click [Next].
Depending on the system environment, a message that prompts you to restart the 
computer may appear. In this case, restart the computer and continue the 
installation.
If you are using Windows XP Service Pack 2 or another operating system 
equipped with Windows Firewall, the following screen is displayed. Specify 
whether to configure Windows...

3-12Installing the CAPT Software
Setting Up the Printing Environment
3
NOTE
•If you are using Windows 2000 and the [Digital Signature Not Found] dialog box 
appears, click [Yes].
•If you are using Windows XP/Server 2003 and the [Hardware Installation] dialog 
box appears, click [Continue Anyway].
14When the following screen is displayed, turn the printer ON.
Press   of the power switch to turn the printer ON.
Installation of the USB class driver and the printer driver starts automatically.
NOTE
•If the...

3-13Installing the CAPT Software
Setting Up the Printing Environment
3
15The screen that informs you of the completion of the printer 
driver installation is displayed. Click [Exit].
16If [Easy Installation] is selected in Step 7, the manuals are 
installed.
 

3-14Installing the CAPT Software
Setting Up the Printing Environment
3
17Confirm the installation results, then click [Next].
NOTE
If the printer driver is not installed properly, see Installation Problems, on p. 7-38.
18Select the [Restart Computer Now (Recommended)] check 
box, then click [Restart].
Windows restarts.
The installation of the USB class driver and the printer driver is completed.
 

3-15Installing the CAPT Software
Setting Up the Printing Environment
3
Installing with Plug and Play
For Windows 98/Me
The screen shots used in this section are from Windows Me.
1Make sure that the printer and computer are OFF.
2Open the expansion slot cover.