Canon Laser Shot Lbp5970 User Guide

30
Step4
Installing the Toner 
Cartridges
For details on how to handle the toner cartridges, see Chapter 6 Routine 
Maintenance in   Users Guide.
CAUTION
T ake care not to allow the toner to come into contact with your hands 
or clothing, as this will dirty your hands or clothing. If they become 
dirty, wash them immediately with cold water. Washing with warm 
water will set the toner and make it impossible to remove the toner 
stains.
IMPORTANT
When handling a toner cartridge, hold the tabs (A) as shown...

31
Step4
3Take the toner cartridge out of the package, and then take it 
out of the protective pack.
While holding the center portion on the top of the protective pack, open it to left 
and right.
IMPORTANT
K eep the protective pack for the toner cartridge. It may be required after 
taking out the toner cartridge for printer maintenance.
4Hold the toner cartridge so that the tab (A) is at the bottom, 
and then shake it up and down 10 times each as shown in 
the figure to evenly distribute the toner inside...

32
Step4 Insert the toner cartridge so that the orientation of the character on the toner 
cartridge and that on the toner cover match.6Tilt the lock release lever (A) to the position of   to lock 
the toner cartridge.
Align the triangular mark on the lock release lever with that on the toner cartridge.
7After installing all the toner cartridges, close the toner 
cover.
IMPORTANT
•If you cannot close the toner cover, check if the toner cartridges are 
installed properly. If you try to close the toner...

33
Step5
Loading Paper in the 
Paper Cassette
For details on handling the multi-purpose tray or paper 
cassette, see Chapter 3 Loading and Outputting Paper in 
 
Users Guide.
By default, this printer feeds paper from two paper sources: the 
paper cassette (Cassette 1) and multi-purpose tray. Also, 
paper can be fed from up to 5 paper sources by installing the 
optional paper feeders (Cassette 2, Cassette 3, and Cassette 
4).
This section only describes the procedure for loading plain or 
paper of...

34
Step5
1Pull out the paper cassette.
Pull the paper cassette out until it stops a.
● After lifting the paper cassette up a little b, pull it out while supporting 
it with the other hand in the figure c.
CAUTION
Be sure to take the paper cassette out of the printer before loading 
paper. If paper is loaded while the paper cassette is partially pulled 
out, the paper cassette may drop or the printer may become 
damaged resulting in personal injury.
IMPORTANT
The paper cassette cannot be pulled out...

35
Step5
● While holding the lock release lever of the rear paper guide a, slide the 
guide to the mark for the size of the paper to be loaded b.
● While holding the lock release lever of the side paper guides 
a, slide 
the guides to the mark for the size of the paper to be loaded b.
The side paper guides move together.
3Load the paper stack so that the rear edge is aligned with 
the paper guide.
CAUTION
When loading paper, take care not to cut your hands with the edges 
of the paper.
IMPORTANT
•Be sure...

36
Step5 -W
hen loading paper in landscape orientation, such as when loading A4,
B5, A5, Letter, or Executive size paper, load the paper so that the
printing side is facing up as shown in the following figures.
(:  Feeding direction)
-W hen loading paper in portrait orientation, such as when loading A3, B4,
Ledger (11 x 17), or Legal size paper, load the paper so that the printing
side is facing up as shown in the following figures.
(:  Feeding direction)
4Press down the paper stack so that it is loaded...

37
Step5
The default is A4.
IMPORTANT
Make sure that the size of the loaded paper matches that of the paper size 
setting switch before setting the paper cassette in the printer. If the paper 
size setting switch is not set to the proper position, this may result in 
printer malfunction.
7Set the paper cassette in the printer.
While holding the paper cassette with both hands, insert it until it stops a as 
shown in the figure. After lifting the front of the paper cassette up a little 
b, push the paper...

38
Step6
Connecting to a 
Computer
This section describes how to connect the printer to a computer and 
network.
This printer is equipped with a LAN connector and USB connector.
Using a LAN Cable
By connecting the printer to a network such as Ethernet to be shared on the 
network, you can use the printer from a computer on the network. You can use 
UNIX, Windows, Mac OS, and other operating systems.
This printer includes a print server that supports 10BASE-T/100BASE-TX and 
is compatible with the TCP/IP,...

39
Step6
2Connect the LAN cable to the LAN connector.
Connect a LAN cable that is compatible with the LAN connector of the net\
work 
board according to the network.
3Connect the other end of the LAN cable to the hub.
IMPORTANT
The supplied CD-ROM does not include the printer driver for Macintosh. 
Download the printer driver for Macintosh that supports this printer from 
the Canon website. If you cannot find the printer driver for Macintosh that 
supports this printer on the Canon website, contact your...