Brother MFC J430W User Manual

Making copies27
7
Making N in 1 copies or a 
poster (Page Layout)7
The N in 1 copy feature can help you save 
paper by letting you copy two or four pages 
onto one printed page.
You can also produce a poster. When you 
use the poster feature your machine divides 
your document into sections, then enlarges 
the sections so you can assemble them into a 
poster. If you want to print a poster, use the 
scanner glass.
IMPORTANT
• Make sure the paper size is set to Letter, 
A4 or Executive.
• Poster copy is...

Chapter 7
28
Place the document face down in the 
direction shown below:  2in1(P)
 
2in1(L)
 
4in1(P)
 
4in1(L)
 
Poster (2x1)
 
Poster (2x2)
 
Poster (3x3)
 
2 in 1 ID Copy7
You can copy both sides of your identification 
card onto one page, keeping the original card 
size. Make sure the paper size is set to Letter 
or A4.
Note
You can copy an identification card to the 
extent permitted under applicable laws. 
(uuProduct Safety Guide:  Legal 
limitations for copying )
 
aPress (COPY ).
bPlace...

Making copies29
7
dPress aor b to choose  Page Layout . 
Press  OK.
ePress  aor b to choose  2in1 (ID) .
Press  OK.
fPress  Black Start  or Color Start .
The machine starts scanning the first 
page.
gAfter the machine has scanned one 
side, press 1 . Turn over the 
identification card and press  OK to scan 
the other side.
Note
• Sort and  Enlarge/Reduce  are not 
available with  2in1 (ID).
• If you are producing multiple color copies,  2 in 1 (ID) copy is not available.
 
Sorting copies using the ADF7...

Chapter 7
30
Restoring all settings to the 
factory settings7
You can restore the copy settings that you 
have changed to the factory settings, such as 
Quality , Enlarge/Reduce , Density, 
and  Page Layout .
aPress ( COPY).
bPress aor b to choose 
Factory Reset .
Press  OK.
cPress  1 to choose  Yes.
dPress Stop/Exit.
 

31
A
A
Cleaning and checking 
the machine
A
Cleaning the outside of the 
machineA
Clean the outside of the machine as 
follows:
IMPORTANT
• Use neutral detergents. Cleaning with volatile liquids such as thinner or benzine 
will damage the outside surface of the 
machine.
• DO NOT use cleaning materials that  contain ammonia.
• DO NOT use isopropyl alcohol to remove  dirt from the control panel. It may crack the 
panel.
 
aPull the paper tray (1) completely out of 
the machine.
 
bWipe the outside of the...

32
Cleaning the machine’s 
printer platenA
WARNING 
Be sure to unplug the machine from the AC 
power outlet before cleaning the printer 
platen to avoid an electrical shock.
 
aUsing both hands, grasp the plastic tabs 
on both side of the machine to lift the 
scanner cover into the open position.
bClean the machine’s printer platen (1) 
and the area around it, wiping off any 
scattered ink with a dry, soft lint-free 
cloth.
 
cUsing both hands, grasp the plastic tabs 
on both sides of the machine and...

Routine maintenance33
A
cOpen the Jam Clear Cover (1) at the 
back of the machine.
 
dClean the Paper Pick-up Rollers (1) with 
a soft lint-free cloth moistened with 
water.
Slowly turn the rollers so that the whole 
surface is cleaned.
After cleaning, wipe the rollers with a 
dry, soft lint-free cloth to remove all 
moisture.
 
eClose the Jam Clear Cover.
Make sure the cover is closed 
completely.
fPut the paper tray firmly back in the 
machine.
gRe-connect the power cord.
Checking the ink volumeA...

34
Packing and shipping 
the machine
A
When you transport the machine, use the 
packing materials that came with your 
machine. If you do not pack the machine 
properly, any damage that may occur in 
transit may not be covered by your warranty.
IMPORTANT
It is important to allow the machine to 
“park” the print head after a print job. 
Listen carefully to the machine before 
unplugging it to make sure that all 
mechanical noise has stopped. Not 
allowing the machine to finish this parking 
process may...

Routine maintenance35
A
eUnplug the machine from the telephone 
wall jack and take the telephone line 
cord out of the machine.
fUnplug the machine from the AC power 
outlet.
gUsing both hands, use the plastic tabs 
on both sides of the machine to lift the 
scanner cover into the open position. 
Then unplug the interface cable from the 
machine, if it is connected.
hUsing both hands, grasp the plastic tabs 
on both sides of the machine and gently 
close the scanner cover.
 
iWrap the ink cartridges in...

36
kPack the machine and the printed 
materials in the original carton with the 
original packing material as shown 
below.
Note
If you are returning your machine to 
Brother as part of the Exchange Service, 
pack only the machine. Keep all separate 
parts and printed materials to use with 
your “Exchange” machine.
 
 
lClose the carton and tape it shut.