Brother Laserprinter Hl 1435 User Guide

CONTROL PANEL   3 - 7
Control panel buttons 
The control panel buttons have the following functions:
Cancel printing
If you press the Control panel button while printing, the printer will immediately stop printing and will 
then eject the paper.
Wake-up 
If the printer is in Sleep mode, press the Control panel button to wake the printer up and go to the Ready 
state. It will take up to 25 seconds for the printer to reach the Ready state.
Form feed
If the orange Data LED is on, press the Control panel...

3 - 8   CONTROL PANEL
Print a test page
You can use the Control panel button or the printer driver to print a test page.
Using Control panel button
1Turn off the printer.
2Make sure that the front cover is closed and the power cord is plugged in.
3Hold down the Control panel button as you turn on the power switch. All the LEDs light up and then 
go off again. Keep the Control panel button pressed down until the Drum LED comes on. When 
the Drum LED comes on, release the Control panel button.
4Press the...

OPTIONS   4 - 1
4
Print server (NC-2100p) (For Windows® only)
An optional network print server (NC-2100p) allows you to connect to your network through the parallel 
interface. 
To install the print server, please see the instructions supplied with the NC-2100p. For more information, 
see Network User’s Guide on the supplied CD-ROM with the NC-2100p.
■TCP/IP, NetBIOS and AppleTalk protocols
■Superior network and printer management:
■BRAdmin Professional Windows
®-based Management utility. 
■SNMP MIB I...

4 - 2   OPTIONS
Ir-DA Interface (IR-1000) (For Windows ®
 only)
IR-1000 connects to any printer and prints  data without using connecting cables.
■ Supports IrDA1.1 infrared communication standard.
■ Fully compatible with Windows
® 95/98/Me, Windows NT® 4.0 and Windows® 2000 infrared printer 
device.
■ Transmits and receives data at up to 4 Mbits/sec.
■ Connects to the PC parallel port and connects to  the Centronics parallel port on the printer.
■ Allows a printer to communicate with an...

5 - 1   ROUTINE MAINTENANCE
5
You will need to replace certain parts and clean the printer on a regular basis. 
You can see the maintenance video in the Maintenance Tutorial section of the CD-ROM we have 
provided with the printer.
1You can see how to replace the toner cartridge.
2You can see how to replace the drum unit.
3You can see how to clean the scanner window.
4You can see how to clean the corona wire in the drum unit.
5You can see how to clean the surface of the OPC in the drum unit.
These...

ROUTINE MAINTENANCE   5 - 2
Toner cartridge 
A new toner cartridge contains enough toner to print up to 3,000 (TN-standard cartridge) or up to 6,000 
(TN-high yield cartridge) A4 or Letter-size single-sided pages at about 5% coverage. 
Toner Low message
Blinking every 5 seconds.
Figure 5-1
If the LED shows this message, the toner cartridge has nearly run out of toner. Buy a new toner cartridge 
and have it ready before you get a Toner Empty message. To put in the toner cartridge, see Replacing 
the toner...

5 - 3   ROUTINE MAINTENANCE
Toner Empty message
If the LED shows the message below, the printer has run out of toner or the toner is not evenly distributed 
inside the cartridge. 
Figure 5-2
Replacing the toner cartridge
Follow these steps to replace the toner cartridge. You can also view the toner cartridge replacement 
method in the instructional video on the supplied CD-ROM: 
1Open the front cover of the printer.
2Pull out the drum unit assembly.
Figure 5-3
To make sure you get high quality print, use...

ROUTINE MAINTENANCE   5 - 4
Caution
■We recommend that you place the drum unit assembly on a piece of disposable paper or cloth 
in case you accidentally spill or scatter toner.
■To prevent damage to the printer from static electricity, do not touch the electrodes shown in 
Figure 5-4.
Figure 5-4
3Hold down the blue lock lever and take the toner cartridge out of the drum unit assembly.
Figure 5-5
Caution
Handle the toner cartridge carefully. If toner scatters on your hands or clothes, immediately wipe or...

5 - 5   ROUTINE MAINTENANCE
Caution
■Wait to unpack the toner cartridge until immediately before you put it in the printer. If toner 
cartridges are left unpacked for a long time the toner life will be shortened.
■If an unpacked drum unit is put in direct sunlight or room light, the unit may be damaged.
■Brother strongly recommends that you don not refill the toner cartridge provided with your 
printer. We also strongly recommend that you continue to use only Genuine Brother Brand 
replacement toner...

ROUTINE MAINTENANCE   5 - 6
Caution
Put the toner cartridge in the drum unit immediately after you have removed the protective cover. Do 
not touch the shaded parts shown in Figure 5-8 and Figure 5-9 to prevent any degradation to the print 
quality.
6Put the new toner cartridge firmly into the drum unit until you hear it lock into place. If you put it in 
properly, the lock lever will lift automatically.
Figure 5-10
Caution
Make sure you fit the toner cartridge properly or it may separate from the drum...