Brother Hl4570cdw Owners Manual

Routine Maintenance 
125
5
Cleaning the drum unit5
If your printout has colored spots at 94 mm (3.7 in.) intervals, the drum may have foreign material, such as 
glue from a label stuck on the drum surface. Follow the steps below to solve the problem.
aMake sure the machine is in the ready state.
bPress + or - to choose Machine Info.. Press OK.
cPress + or - to choose Drum Dot Print. Press OK to print out the drum dot check sheet. 
dTurn off the machines power switch. Disconnect all interface cables, and...

Routine Maintenance 
126
5
gTurn the green lock lever (1) at the left of the machine counterclockwise to the release position. Holding 
the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.
 
IMPORTANT
• Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.
 
• We recommend that you place the drum unit and/or toner cartridge on a clean, flat surface with a piece of 
disposable paper underneath it in case you...

Routine Maintenance 
127
5
hHold the handle of the toner cartridge and slightly push it to unlock. Then pull it out of the drum unit. 
Repeat this for all the toner cartridges.
 
iTurn the drum unit over by holding the green handles. Make sure that the drum unit gears (1) are on the 
left hand side.
 
jRead following information from the drum dot check sheet.
Dot Color problem: The color of printed dots is the color of the drum you should clean.
Dot location: The sheet has eight numbered columns. The...

Routine Maintenance 
128
5
kConfirm suspected area of the appropriate color drum by using the numbers beside the drum which 
relate to the numbers of column.
 
lTurn the drum unit gear toward you by hand while looking at surface of the suspected area. 
mWhen you have found the mark on the drum that matches the drum dot check sheet, wipe the surface 
of the drum gently with a cotton swab until the mark on the surface comes off.
 
IMPORTANT
DO NOT clean the surface of the photosensitive drum with a sharp...

Routine Maintenance 
129
5
nHold the handle of the toner cartridge and slide it into the appropriate colored section of the drum unit 
until it clicks into place.
oMake sure the green lock lever (1) is in the release position as shown in the illustration.  
pMatch the guide ends (2) of the drum unit to the c marks (1) on both sides of the machine, then gently 
slide the drum unit into the machine until it stops at the green lock lever.
    
C - Cyan
M - Magenta
Y - Yellow
K - Black
C
M
Y
K
1
1
2 

Routine Maintenance 
130
5
qTurn the green lock lever (1) clockwise to the lock position. 
rPush the drum unit in until it stops. 
sClose the front cover of the machine.
tConnect interface cables and then plug the machine back in. Turn on the power switch.
1 

Routine Maintenance 
131
5
Cleaning the paper pick-up roller5
aTurn off the machines power switch. Disconnect all interface cables, and then unplug the AC power 
cord.
bPull the paper tray completely out of the machine.
cTightly wring out a lint-free cloth soaked in lukewarm water, and then wipe the separator pad (1) of the 
paper tray with it to remove dust.
 
dWipe the two pick-up rollers (1) inside of the machine to remove dust. 
ePut the paper tray back in the machine.
fConnect interface cables and...

Routine Maintenance 
132
5
Shipment of the machine5
WARNING 
This machine is heavy and weighs approximately 21.0 kg (46.3 lb). To prevent possible injuries at least two 
people should lift the machine. Be careful not to pinch your fingers when you put the machine down.
 
 
 
If you use a Lower Tray, carry it separately from your machine.
 
IMPORTANT
When shipping the machine, the waste toner box must be removed from the machine and put in a plastic 
bag, and then sealed. Failure to remove it and put it...

Routine Maintenance 
133
5
aTurn off the machines power switch. Disconnect all interface cables, and then unplug the AC power 
cord.
bPress the front cover release button and then open the front cover. 
cHold the green handle of the drum unit. Pull the drum unit out until it stops. 
dTurn the green lock lever (1) at the left of the machine counterclockwise to the release position. Holding 
the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.
 
1 

Routine Maintenance 
134
5
IMPORTANT
• Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.
 
• We recommend that you place the drum unit on a clean, flat surface with a piece of disposable paper 
underneath it in case you accidentally spill or scatter toner.
• Handle the toner cartridge and the waste toner box carefully. If toner scatters on your hands or clothes, 
wipe or wash it off with cold water at once.
• To prevent damage to the machine from static...