Brother Hl 5130 User Manual

							
APPENDIX (FOR EUROPE AND OTHER COUNTRIES)   B - 2
Important information: Regulations
Radio interference (220 to 240 volt model only)
This printer follows EN55022 (CISPR Publication 22)/Class B.
Before you use this product, make sure that you use the following interface cables.
1. A shielded parallel interface cable with twisted-pair conductors and that it is marked IEEE 1284 
compliant.
2. A USB cable.
The cable must not be more than 2 meters long.
International ENERGY STAR® Compliance Statement
The purpose of the International ENERGY STAR® Program is to promote the development and 
popularization of energy-efficient office equipment.
As an E
NERGY STAR® Partner, Brother Industries, Ltd. has determined that this product meets the ENERGY 
S
TAR® guidelines for energy efficiency.
 
						

							B - 3   APPENDIX (FOR EUROPE AND OTHER COUNTRIES)
IEC 60825 specification (220 to 240 volt model only)
This printer is a Class 1 laser product as defined in IEC 60825 specifications. The label shown below is 
attached in countries where it is needed.
This printer has a Class 3B laser diode which produces invisible laser radiation in the scanner unit. You 
should not open the scanner unit under any circumstances. 
Caution: Use of controls or adjustments or performance of procedures other than those specified in this User’s 
Guide may result in hazardous radiation exposure. 
Varoitus!   Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän 
turvallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle. 
Varning  Om apparaten används på annat sätt än i denna Bruksanvisning specificerats, kan användaren 
utsättas för osynlig laserstrålning, som överskrider gränsen för laserklass 1.
Internal laser radiation
Maximum radiation power: 5 mW
Wave length: 760 - 810 nm
Laser class: Class IIIb (Accordance with 21 CFR Part 1040.10)
Class 3B (Accordance with IEC 60825)
For Finland and Sweden
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT
 
						

							APPENDIX (FOR EUROPE AND OTHER COUNTRIES)   B - 4
IMPORTANT - For Your Safety
To ensure safe operation the supplied three-pin plug must be inserted only into a standard three-pin 
power outlet that is properly grounded through the standard electrical wiring. 
Extension cords used with this printer must be three-pin plug type and correctly wired to provide proper 
grounding. Incorrectly wired extension cords may cause personal injury and equipment damage. 
The fact that the equipment operates satisfactorily does not imply that the power is grounded and that 
the installation is completely safe. For your safety, if in any doubt about the effective grounding of the 
power, call a qualified electrician. 
Disconnect device
You must install this printer near a power outlet that is easily accessible. In case of an emergency, you 
must disconnect the power cord from the power outlet to shut off the power completely.
Caution for LAN connection
Connect this product to a LAN connection that is not subjected to overvoltages.
IT power system (For Norway only)
This product is also designed for an IT power system with phase-to-phase voltage 230V.
Geräuschemission / Acoustic noise emission (for Germany only)
Lpa < 70 dB (A) DIN 45635-19-01-KL2
 
						

							B - 5   APPENDIX (FOR EUROPE AND OTHER COUNTRIES)
Wiring information (for UK)
Important
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the same rating 
as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with the following code:
Green and Yellow:  Earth
Blue: Neutral
Brown: Live
If in any doubt, call a qualified electrician.
 
						

							
APPENDIX (FOR EUROPE AND OTHER COUNTRIES)   B - 6
“EC” Declaration of Conformity
Manufacturer
Brother Industries Ltd.,
15-1, Naeshiro-cho, Mizuho-ku,
Nagoya 467-8561, Japan
Plant
Brother Technology (Shenzhen) Ltd.
NO6 Gold Garden Ind. Nanling Buji, 
Longgang, Shenzhen, China
Herewith declare that:
Product description : Laser Printer
Product Name : HL-5130, HL-5140, HL-5150D, HL-5170DN
Model Number : HL-51
are in conformity with provisions of the Directives applied  : Low Voltage Directive 73/23/EEC (as 
amended by 93/68/EEC) and the Electromagnetic Com patibility Directive 89/336/EEC ( as amended by 
91/263/EEC and 92/31/EEC and 93/68/EEC).
Standards applied:
Harmonized Safety : EN60950:2000
EMC : EN55022:1998 Class B EN55024:1998
   EN61000-3-2:1995 + A14:2000
  EN61000-3-3:1995
Year in which CE marking was first affixed : 2003
Issued by : Brother Industries, Ltd.
Date : 1 August, 2003
Place : Nagoya, Japan
Signature :
Takashi Maeda
Manager
Quality Management Group
Quality Management Dept.
Information & Document Company
 
						

							C - 1   APPENDIX (FOR USA AND CANADA)
C
Brother Numbers
IMPORTANT: For technical and operational help, you must call the country where you bought the 
printer. Calls must be made  from within that country. 
Register your product
By registering your product with Brother International  Corporation, you will be recorded as the original 
owner of the product.
Your registration with Brother:
■ may serve as a confirmation of the purchase date of your product should you lose your receipt;
■ may support an insurance claim by you in the event of product loss covered by insurance; and,
■ will help us notify you of enhancements to your product and special offers.
Please complete the Brother Warranty Registration or, for your convenience and most efficient way to 
register your new product, register on-line at
http://www.brother.com/registration/
Frequently asked questions (FAQs)
The Brother Solutions Center is our one-stop resource for all your Printer needs. You can download the 
latest software and utilities, read FAQs and troubleshooting tips to learn how to get the most from your 
Brother product.
http://solutions.brother.com
You can check here for the Brother driver updates.
Customer Service
In USA: 1-800-276-7746
In Canada: 1-877-BROTHER
If you have comments or suggestions, please write us at: In USA: Printer Customer Support
Brother International Corporation
15 Musick
Irvine, CA 92618
In Canada: Brother International Corporation (Canada), Ltd.
- Marketing Dept.
1, rue Hotel de Ville
Dollard-des-Ormeaux, PQ, Canada H9B 3H6
Appendix (For USA and Canada)
 
						

							APPENDIX (FOR USA AND CANADA)   C - 2
Service center locator (USA only)
For the location of a Brother authorized service center, call 1-800-284-4357.
Service center locations (Canada only)
For the location of a Brother authorized service center, call 1-877-BROTHER
Brother fax back system (USA only)
Brother has installed an easy to use fax back system so you can get instant answers to common 
technical questions and product information. This is available 24 hours a day, 7 days a week. You can 
use the system to send the information to any fax machine.
Call the number below and follow the recorded instructions to receive a fax about how to use the system 
and an index of fax back subjects.
In USA only:1-800-521-2846
Internet Addresses
Brother Global Web Site: http://www.brother.com
For Frequently Asked Questions (FAQs), Product Support and Technical Questions, and Driver 
Updates and Utilities: http://solutions.brother.com
(In USA Only) For Brother Accessories & Supplies: http://www.brothermall.com
 
						

							C - 3   APPENDIX (FOR USA AND CANADA)
Important information: Regulations
Federal Communications Commission (FCC) Declaration of 
Conformity (For USA)
Responsible Party: Brother International Corporation
100 Somerset Corporate Boulevard
P.O. Box 6911
Bridgewater, NJ 08807-0911
USA
Telephone: (908) 704-1700
Important
A shielded interface cable should be used in order to ensure compliance with the limits for a Class B 
digital device.
Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user’s 
authority to operate the equipment. 
declares, that the products
Product name: Laser Printer 5140, 5150D and HL-5170DN
Model number: HL-51
Product options:  Lower Tray Unit LT-5000, DIMM
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may 
not cause harmful interference, and (2) this device must accept any interference received, including interference 
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of the following measures: 
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and receiver. 
■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
■Consult the dealer or an experienced radio/TV technician for help. 
 
						

							
APPENDIX (FOR USA AND CANADA)   C - 4
Industry Canada Compliance Statement (For Canada)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est  conforme à la norme NMB-003 du Canada.
International ENERGY STAR® Compliance Statement
The purpose of the International ENERGY STAR® Program is to promote the development and 
popularization of energy-efficient office equipment.
As an E
NERGY STAR® Partner, Brother Industries, Ltd. has determined that this product meets the ENERGY 
S
TAR® guidelines for energy efficiency. 
 
						

							
C - 5   APPENDIX (FOR USA AND CANADA)
Laser Notices
Laser Safety (100 to 120 volt model only)
This printer is certified as a Class I laser product under the U.S. Department of Health and Human 
Services (DHHS) Radiation Performa nce Standard according to the Radiation Control for Health and 
Safety Act of 1968. This means that the printer does not produce hazardous laser radiation. 
Since radiation emitted inside the printer is complete ly confined within protective housings and external 
covers, the laser beam cannot escape from the machine during any phase of user operation. 
FDA Regulations (100 to 120 volt model only)
U.S. Food and Drug Administration (FDA) has implem ented regulations for laser products manufactured 
on and after August 2, 1976. Compliance is mandatory  for products marketed in the United States. One 
of the following labels on the back of the printer indi cates compliance with the FDA regulations and must 
be attached to laser products marketed in the United States.
Caution:  Use of controls, adjustments or performance of pr ocedures other than those specified in this User’s 
Guide may result in hazardous radiation exposure. 
MANUFACTURED:
Brother Industries, Ltd., 
15-1 Naeshiro-cho Mizuho-ku Nagoya, 467-8561 Japan
This product complies with FDA radiation performance standards, 21 CFR subchapter J.
MANUFACTURED:
Brother Technology (Shenzhen) Ltd.
NO6 Gold Garden Ind. Nanling Buji, Longgang, Shenzhen, CHINA
This product complies with FDA radiation performance standards, 21 CFR Subchapter J