Brother DCP 8020 User Manual

							TROUBLESHOOTING AND ROUTINE MAINTENANCE   14 - 26
Caution
■Place the drum unit on a drop cloth or large piece of disposable 
paper to avoid spilling and scattering the toner.
■To prevent damage to the DCP from static electricity, do not 
touch the electrodes shown below.
2Hold down the lock lever on the right and pull the toner cartridge 
out of the drum unit.
Caution
Handle the toner cartridge carefully. If toner scatters on your hands 
or clothes, immediately wipe it off or wash it with cold water.
Lock Lever
 
						

							14 - 27   TROUBLESHOOTING AND ROUTINE MAINTENANCE
3Unpack the new toner cartridge. Place the used toner cartridge 
into the aluminum bag and discard it according to local 
regulations. 
Caution
■Wait to unpack the toner cartridge until immediately before you 
install it in the DCP. If a toner cartridge is left unpacked for a long 
period of time, the toner life is shortened.
■Brother strongly recommends that you do not refill the toner 
cartridge provided with your DCP. We also strongly recommend 
that you continue to use only Genuine Brother Brand 
replacement toner cartridges. (TN-530 and TN-560).
Using or attempting to use potentially incompatible toner and/or 
toner cartridges in your DCP may cause damage to the machine 
itself and/or it may result in unsatisfactory print quality. Our 
warranty coverage does not apply to any problem that was 
caused by the use of unauthorized third party toner and toner 
cartridges. To protect your investment and guarantee your print 
quality please continue to replace consumed toner cartridges 
with only Genuine Brother Branded Supplies.
 
						

							TROUBLESHOOTING AND ROUTINE MAINTENANCE   14 - 28
4Gently rock the toner cartridge from side to side five or six times 
to distribute the toner evenly inside the cartridge.
5Remove the protective cover. 
6Insert the new toner cartridge in the drum unit until it clicks into 
place. If you put it in properly, the lock lever will lift automatically.
Toner CartridgeDrum Unit
 
						

							14 - 29   TROUBLESHOOTING AND ROUTINE MAINTENANCE
7Clean the primary corona wire inside the drum unit by gently 
sliding the blue tab from right to left several times. Return the 
blue tab to the Home position (
▼) before reinstalling the drum 
unit and toner cartridge assembly.
8Reinstall the drum unit and toner cartridge assembly and close 
the front cover.
Corona Wire Tab
Home Position(▼)
 
						

							TROUBLESHOOTING AND ROUTINE MAINTENANCE   14 - 30
Replacing the drum unit
The DCP uses a drum unit to create print images on paper. If the 
LCD shows 
Change Drum Soon, the drum unit is near the end of 
its life and it is time to purchase a new one.
Even if the LCD shows 
Change Drum Soon, you may be able to 
continue printing without having to replace the drum unit for a while. 
However, if there is a noticeable deterioration in the output print 
quality (even before 
Change Drum Soon appears), then the drum 
unit should be replaced. You should clean the DCP when you 
replace the drum unit. (See Cleaning the drum unit
 on page 14-23.)
Caution
When removing the drum unit, handle it carefully because it contains 
toner. If toner scatters and your hands or clothes get dirty, 
immediately wipe or wash with cold water.
The drum unit is a consumable item, and it is necessary to 
replace it periodically. There are many factors that determine 
the actual drum life, such as temperature, humidity, type of 
paper and how much toner you use for the number of pages per 
print job. The estimated drum life is up to 20,000 pages. The 
actual number of pages your drum will print may be significantly 
less than these estimates. Because we have no control over the 
many factors that determine the actual drum life, we cannot 
guarantee a minimum number of pages that will be printed by 
your drum.
 
						

							14 - 31   TROUBLESHOOTING AND ROUTINE MAINTENANCE
WARNING
Just after you have used the DCP, some internal parts of the DCP 
are extremely HOT! So please be careful.
Follow these steps to replace the drum unit:
1Press the cover release button and then open the front cover.
2Remove the old drum unit and toner cartridge assembly. Place 
it on a drop cloth or disposable paper to avoid scattering toner.
HOT!
 
						

							TROUBLESHOOTING AND ROUTINE MAINTENANCE   14 - 32
Caution
To prevent damage to the printer from static electricity, do not touch 
the electrodes shown below.
3Hold down the lock lever on the right and pull the toner cartridge 
out of the drum unit. (See Replacing the toner cartridge
 on page 
14-24.)
Discard the used drum unit according to local regulations, 
keeping it separate from domestic waste. Be sure to seal the 
drum unit tightly so toner powder does not spill out of the unit. If 
you have questions, call your local waste disposal office.
Lock Lever
 
						

							14 - 33   TROUBLESHOOTING AND ROUTINE MAINTENANCE
4Wait to unpack the new drum unit until immediately before 
installing it. Place the old drum unit into the plastic bag and 
discard it according to local regulations.
5Reinstall the toner cartridge into the new drum unit. (See 
Replacing the toner cartridge
 on page 14-24.)
6Reinstall the new drum unit, keeping the front cover open.
7Press Clear/Back.
8Press 1 and when the LCD shows 
Accepted, and close the front 
cover.
Caution
If toner scatters and your hands or clothes get dirty, immediately 
wipe off or wash with cold water.
Replace Drum
▲ 1.Yes▼ 2.No
Select 
▲▼ & Set
 
						

							TROUBLESHOOTING AND ROUTINE MAINTENANCE   14 - 34
Checking the drum life
You can see the percentage of the drum’s life that remains available.
1(DCP-8020)
Press 
Menu, 1, 6.
(DCP-8025D)
Press 
Menu, 1, 7.
—OR—
If you have the optional tray #2, press 
Menu, 1, 8.
2For five seconds, the LCD shows the available percentage of 
drum life.
Page Counter
You can see number of total pages, copy pages, print pages and List 
(total list print) pages that your DCP has printed.
1(DCP-8020)
Press 
Menu, 1, 7.
(DCP-8025D)
Press 
Menu, 1, 8.
—OR—
If you have the optional tray #2, press 
Menu, 1, 8.
2The LCD shows number of pages for Total and Copy.
Press   to see 
Print and List.
3Press Stop/Exit.
Even if the remaining drum life is 0%, you may continue to use 
the drum unit until you have a print quality problem.
17.Drum Life
Remaining:100%
18.Page Counter
▲Total    :123456
▼Copy     :120002
 
						

							15 - 1   OPTIONAL ACCESSORIES
15
 
Memory board
The memory board is installed on the main controller board inside the 
DCP. When you add the optional memory board, it increases the 
performance for printer operations.
Optional accessories
Model Name Optional Memory
DCP-8020 (32 MB Standard Memory) 32MB   TECHWORKS 12457-0001
DCP-8025D (32 MB Standard Memory) 64MB   TECHWORKS 12458-0001
128MB   TECHWORKS 12459-0001
In general, the DIMM must have the following specifications:
Type: 100 pin and 32 bit output
CAS Lantency: 2 or 3
Clock Frequency: 100MHz or more
Capacity: 32, 64, 128MB
Height: 35mm (1.4 inches) or less
Parity: NONE
DRAM Type: SDRAM 4 Bank
Some DIMMs might not work with this DCP. For the latest 
information from Brother visit:
http://solutions.brother.com