ATT Merlin Classic Mail Issue 1 System Reference Guide
Here you can view all the pages of manual ATT Merlin Classic Mail Issue 1 System Reference Guide. The ATT manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 11
The Control Unit is a small, breadbox-sized piece of equipment that is located somewhere in your office building, normally in a closet, back room, attic, or some other out-of-the-way location. You will need to locate your Control Unit to install the CLASSIC MAIL system. Outside lines from the telephone company, and all of your telephones, plug into jacks (plugs) on your Control Unit. Outside lines plug into line jacks; telephones plug into voice terminal jacks. The CLASSIC MAIL system will plug into both...
Page 12
Because the CLASSIC MAIL system has been designed to plug into unused voice terminal jacks, the electronic circuits in the CLASSIC MAIL system are recognized by the Control Unit as additional Merlin telephones. Figure 1B shows the CLASSIC MAIL system unit plugged into voice terminaljacks 16 and 17 of a Merlin Control Unit. The CLASSIC MAIL systems unique ability to emulate a Merlin telephone is referred to as a telephone emulation*. Telephone emulation gives the CLASSIC MAIL system the ability to answer...
Page 13
Merlin Control Unit Compatibility There are many different models and versions of Merlin Control Units. The CLASSIC MAIL system is designed to work with the most common. These models are: lMerlin System 206, all versions lMerlin System 410, all versions lMerlin System 820, all versions lMerlin System Plus, all versions lMerlin System 1030, or 3070, withFeature Modules 1, 2, 4, or 5 Note: The CLASSIC MAIL system will not work with Merlin 1030/3070 Feature Module 3 Other models of Merlin Control Units may...
Page 14
Chapter 2: Getting Started Getting started requires that you gather some information about your Merlin Control Unit. Remove the Control Unit’s front cover, if it has one. Figure 2A shows the various types of Control Units. Completing the Installation Data Form Record your information on the Installation Data Form in Appendix A. If you are installing a CLASSIC MAIL system with a Merlin 1030/3070 Control Unit, skip the instructions that immediately follow. Instead, use the Installation Data Gathering...
Page 15
CLASSIC MAIL System Reference Guide 2. 3. 4. 5. 6. If your Control Unit is a Merlin system 206, 410, or 820, determine the type of feature package it has. Feature packages are cartridges that plug into the opening on the upper right front side of the Control Unit. See Figure 2A. If your Control Unit has a cartridge installed, (some do not) and if this cartridge is labeled “Feature Package 2,” record this information on the Installation Data Form. See Appendix A. If your Control Unit is a Merlin Plus...
Page 16
Voice Terminal JacksLine Jacks Cartridge Voice Terminal Jacks LineCartridge Jacks Merlin 206Merlin 1030/3070 Line Jacks Voice Terminal Jacks 820 Voice Terminal Jacks Line Jacks Voice Terminal Jacks 410 Cartridge Figure 2A: Merlin Control Units Merlin Plus Line Jacks Chapter 2. Getting Started15
Page 17
7. 8. CLASSIC MAIL System Reference GuideIf you have any outside lines that are WATS lines, Foreign Exchange (FX) lines, or 800 lines, check the corresponding block on the Installation Data Form and see the recommended installation options. Determine the intercom number (often 0 or 10) of the person who normally answers your incoming calls. If you don’t have a person who does this, use the intercom number of the person you designate as the CLASSIC MAIL system attendant. Record this number in the...
Page 18
Status IndicatorsEmulation Jacks. 1-4 Line Jacks. 1-4 Line Jacks. 1-4Optional RS-232 Connector Optional Expansion Key Connector Diagnostic Button Message Waiting Panel Plug DC Power Plug Figure 2B The CLASSIC MAIL System Chapter 2: Getting Started17
Page 19
FCC Information This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communica- tions. Operation of...
Page 20
Chapter 3: Standard Installation This chapter provides step-by-step instructions for the standard CLASSIC MAIL system installation. If you are installing a CLASSIC MAIL system with a Merlin 1030/ 3070 Control Unit, skip the instructions that immediately follow. Instead, follow the instructions in the CLASSIC MAIL System Control Unit Upgrade Kit Installation Guide. The standard installation is referred to as an interposed configuration, because the CLASSIC MAIL system is interposed between your incoming...