Apple macbook pro 15 inch mid 2009 User Manual
Have a look at the manual Apple macbook pro 15 inch mid 2009 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Display 81 2010-12-15 Mechanical/Physical Damage Quick Check SymptomQuick Check Mechanical/Physical Damage • Broken glass • Broken hinge • Stripped screw/head • Stripped screw boss • Dent or scratch to chassis 1. Determine damage caused by user/technician environment, accidental damage, or abuse. 2. Inform user/technician the failures are not covered by Apple warranties. Refer to http://www.apple.com/legal/warranty Cosmetic Defects Quick Check SymptomQuick Check Cosmetic Defects • Cracked LCD • Scorched or melted LCD • LCD impact damage 1. Determine damage caused by user/technician environment, accidental damage, or abuse. 2. Inform user/technician the failures are not covered by Apple warranties. Refer to http://www.apple.com/legal/warranty Uncategorized Symptom Quick Check SymptomQuick Check Uncategorized Symptom Unable to locate appropriate symptom code Verify whether existing symptom code applies to the issue reported by the user. If not, document reported symptom and send feedback to smfeedback@apple. com stating that a suitable symptom code could not be found.
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 82 2010-12-15 Mass Storage Hard Drive Read/Write Issue Unlikely cause: LCD, speakers, fan, camera, microphone Quick Check SymptomQuick Check Hard Drive Read/Write Issue Bad Sector/Defective Drive Formatting Issue • Cannot save documents • Read/Write error message • Hang when accessing or saving data 1. Boot from Install DVD. Verify S.M.A.R.T. status of drive using Disk Utility. 2. Repair disk using Disk Utility. 3. Erase disk and reinstall Mac OS using Installer. Deep Dive CheckResultActionCode 1. Start up from Restore DVD and launch Disk Utility. Is hard drive available for Disk Utility to repair? YesGo to step 2. NoGo to step 3. 2. Did Disk Utility mount and repair hard drive successfully? Reseat hard drive if necessary. YesRestart computer. Go to step 6. NoIf computer has not been verified with a known-good hard drive, go to step 3; otherwise, go to step 7. 3. Substitute a known-good bootable hard drive, does system start up to desktop? YesReinstall user’s drive, go to step 2. NoContinue to use known- good bootable hard drive to determine root cause. Go to step 4.
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 83 2010-12-15 4. After reseating hard drive SATA and logic board connections, does known-good hard drive boot to desktop? YesReinstall user’s drive, go to step 2 NoSuspect hard drive SATA cable, go to step 5. 5. Replace hard drive SATA cable and retest with known-good hard drive. YesReinstall user’s drive, go to step 2. X03 NoReplace logic board.M19 6. Did user’s hard drive start up successfully? YesIssue resolved. NoRepair or replace hard drive, go to step 7. 7. Partition, erase & install Mac OS on user’s hard drive. Did install complete without error and start up successfully? YesIssue resolved NoHard drive appears to be defective, go to step 8. 8. Replace user’s hard drive. Does drive format correctly with a GUID partition map and install Mac OS without errors? YesIssue resolved. H01 NoSATA cable verified or replaced and new hard drive installed, replace logic board. M19 Hard Drive Not Recognized/Not Mounting Unlikely cause: LCD, speakers, fan, camera, microphone, AirPort Quick Check SymptomQuick Check Hard Drive Not Recognized/ Mount Drive No Boot • Flashing question mark • Boots to grey screen • Boots to blue screen 1. Use a known-good mouse. Stuck mouse button will not allow boot. 2. Boot from Install DVD. Verify S.M.A.R.T. status of drive using Disk Utility. 3. Repair disk using Disk Utility. 4. Erase disk and reinstall Mac OS using Installer.
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 84 2010-12-15 Deep Dive CheckResultActionCode 1. Boot from Restore DVD and launch Disk Utility. Is hard drive available for Disk Utility to repair? YesGo to step 2. NoGo to step 3. 2. Did Disk Utility mount and repair hard drive successfully? Reseat hard drive if necessary. YesRestart computer, go to step 6. NoIf computer has not been verified with a known-good hard drive, go to step 3; otherwise, go to step 7. 3. Substitute a known-good bootable hard drive, does computer start up to desktop? YesInstall user drive, go to step 2. NoContinue to use known- good bootable hard drive to determine root cause. Go to step 4. 4. After reseating SATA and logic board connections, does known-good hard drive start up to desktop? YesInstall user drive, go to step 2. NoSuspect hard drive SATA cable, go to step 5. 5. Replace hard drive SATA cable and retest with known-good hard drive. YesInstall user drive, go to step 2.X03 NoReplace logic board.M19 6. Did user’s hard drive start up successfully? YesIssue resolved. NoRestore or replace user’s hard drive, go to step 7. 7. Partition, erase & install Mac OS on user’s hard drive. Did install complete without error and start up successfully? YesIssue resolved. NoHard drive appears to be defective. Go to step 8. 8. Replace user’s hard drive. Does drive format correctly with a GUID partition map and install Mac OS without errors? YesIssue resolved. H01 NoSATA cable verified or replaced and new hard drive installed, replace logic board. M19
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 85 2010-12-15 Hard Drive Noisy Unlikely cause: LCD, speakers, fan, camera, microphone Quick Check SymptomQuick Check Hard Drive Noisy • Noise during start up • Noise during operation • Noise when drive is copying or saving data 1. Start up from Install DVD. Verify S.M.A.R.T. status of hard drive using Disk Utility. 2. Repair disk using Disk Utility. 3. Check for reported noise and compare with Knowledge Base article “Apple Portables: Hard Drives and Noise “ http://support.apple.com/kb/TS2354 Deep Dive CheckResultActionCode 1. Boot from Restore DVD and launch Disk Utility. Is hard drive available for Disk Utility to repair? YesGo to step 2. NoReplace hard drive or go to H01 Drive not recognized/ mount. 2. Repair disk using Disk Utility and verify it completed successfully YesRestart computer. Go to step 3. NoGo to step 4. 3. Is hard drive still noisy?YesRemove hard drive and start up from external drive to test fan noise. Go to step 6. NoIssue resolved. 4. Erase disk and reinstall Mac OS using Installer. Did process complete? YesRestart computer. Go to step 3. NoReplace hard drive. Go to step 5. H06
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 86 2010-12-15 5. After installing new hard drive, do you still have drive noise? YesRemove hard drive and start up from external drive to test fan noise. Go to step 6. NoIssue resolved. 6. After removing hard drive, verify if the system is still noisy. YesFan noise or optical drive noise likely to be the cause. See ODD Noisy table and Fan failures/Thermal issues table. NoGo to step 7. 7. Install a known-good hard drive and verify if the noise level is similar to user’s hard drive. YesHard drive noise level is similar to a known-good drive and does not require replacement. NoReplace hard drive. Go to step 5. H06 Optical Drive Won’t Accept/Reject Media Unlikely cause: LCD, speakers, fan, camera, microphone Quick Check SymptomQuick Check Optical Drive Won’t Accept/ Reject Media • Cannot insert a disc into the drive • Cannot eject a disc placed into the drive 1. Use Apple System Profiler ATA section to see if the optical drive appears. If not, see Optical Drive Not Recognized., 2. Restart computer and hold down mouse button or keyboard eject key to cycle optical drive. 3. Inspect optical drive slot for obstructions
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 87 2010-12-15 Deep Dive CheckResultActionCode 1. Is optical drive listed in the device tree for serial-ATA devices in System Profiler? YesOptical drive has power, inspect disc acceptance. Go to step 5. NoInspect hardware. Go to step 2 2. Verify all connections between logic board, flex cable, and optical drive are secure. Visually inspect cables and connectors for any debris, damage, or bent pins. Is optical drive now listed in System Profiler? YesOptical drive has power, inspect disc acceptance. Go to step 5. NoReplace any damaged cables and retest. If connections are good and with no visible cable damage, go to step 3. X03 3. Disconnect user’s optical drive by lifting SATA cable at logic board and connecting a known good optical drive assembly. Is optical drive now listed in System Profiler? YesSATA port functional, reconnect user’s optical drive & SATA cable. Go to step 4. NoReplace logic board. M19 4. Install and test user’s optical drive with replacement SATA flex cable. Is optical drive now listed in System Profiler? YesCable change resolved issue.X03 NoReplace the optical drive. (Mechanical damage to optical drive, if found) J03 (J06) 5. Inspect optical drive slot for disc insert/eject. Is there clearance for disc use? YesGo to step 6. NoReplace damaged optical drive or system top case that interferes with disc use. J01 (J05) X13 6. Insert known-good disc and test user’s optical drive for acceptance of disc. Does disc auto eject? YesReplace the optical drive. (Mechanical damage to optical drive, if found) J03 (J06) NoGo to step 7. 7. Does disc mount to desktop?YesGo to Eject Test step 8. NoGo to Optical Drive Read/Write Data Error troubleshooting page.
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 88 2010-12-15 8. Does disc eject properly from optical drive? YesIssue resolved. NoReplace optical drive or top case that interferes with disc ejection. J02 X13 9. With replacement flex cable and interconnect board, is disc now recognized? YesIssue resolved. NoReplace optical drive. If drive has already been replaced, then replace logic board. J03 Optical Drive Read/Write Data Error Unlikely cause: LCD, speakers, fan, camera, microphone Quick Check SymptomQuick Check Optical Drive Read/Write Data Error • Errors when writing optical media. • Errors when reading optical media. • Hang when accessing or preparing to write data. 1. Test optical media in another drive of the same type in same type of machine to rule out media issue. 2. Check with known-good discs like the Install discs that came with the computer. 3. For write issues, check with known-good media that performs well in another computer and optical drive of the same type. 4. Check both CD and DVD media. If only one type of media is producing errors, there is a laser issue. (J99) Deep Dive CheckResultActionCode 1. Is media free to spin without optical drive scraping edge or surface of media? YesGo to step 2. NoReplace optical drive.J03
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 89 2010-12-15 2. Can optical drive read both CD and DVD known-good media? YesGo to step 6 NoReading CD only or DVD only indicates laser issue, replace optical drive. J03 Optical drive cannot read any media reliably, go to step 3. 3. Reseat cable connections at logic board and optical drive. Verify that media is now recognized and reads reliably. YesReseat resolved issue.X03 NoGo to step 4. 4. Disconnect optical drive by lifting SATA cable at logic board and connecting a known-good optical drive. Verify that media is now recognized and reads reliably. YesSATA port functional, reconnect user’s optical drive & SATA cable. Go to step 5. NoReplace logic board.M19 5. Install and test with replacement optical drive SATA flex cable. Verify that media is now recognized and reads reliably. YesCable change resolved issue.X03 NoReplace the optical drive. (Mechanical damage to optical drive, if found) J03 (J05) 6. Test write data to compatible CD and DVD media. Verify burned media is recognized and reads reliably. YesIssue resolved. NoReplace the optical drive. (Mechanical damage to optical drive, if found) J03 (J06)
MacBook Pro (15-inch, Mid 2009) Symptom Charts — Mass Storage 90 2010-12-15 Optical Drive Not Recognized/Mount Unlikely cause: LCD, speakers, fan, camera, microphone Quick Check SymptomQuick Check Optical Drive Not Recognized/ Mount • Discs inject and eject, but do not appear in Finder 1. Use Apple System Profiler ATA section to see if the optical drive appears. 2. Serial-ATA section of Apple System Profiler will show any media inserted. 3. Check Finder Preferences: General and make sure “CD’s, DVD’s and iPods” is checked under “Show these items on the Desktop.” 4. Check both CD and DVD media. If only one type of media is recognized, there might be a laser related issue. (J99) Deep Dive CheckResultActionCode 1. Is optical drive listed in the device tree for SATA devices in System Profiler? YesIssue resolved. NoGo to step 2. 2. Verify all connections between logic board, flex cable, optical drive are secure. Visually inspect cables and connectors for any debris, damage, or bent pins. Is optical drive now listed in System Profiler? YesIssue resolved. NoReplace any damaged cables and retest. If connections are good and with no visible cable damage, go to step 3. X03 3. Disconnect optical drive by lifting SATA cable at logic board and connecting a known-good drive. Is optical drive now listed in System Profiler? YesSATA port functional, reconnect user’s optical drive & SATA cable. Go to step 4. NoReplace logic board. M19 4. Install and test with replacement optical drive SATA flex cable. Is optical drive now listed in System Profiler? YesCable change resolved issueX03 NoReplace the optical drive. (Mechanical damage to optical drive, if found) J03 (J05)