Apple ibook g4 14 inch mid 2005 User Manual
Here you can view all the pages of manual Apple ibook g4 14 inch mid 2005 User Manual. The Apple manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 131
iBook G4 (14-inch Mid 2005) Take Apart - 130 Frame Frame Tools No tools are required for this procedure. Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • Memory card • Bottom case • Bottom shield • DC-in board • Battery transfer board
Page 132
131 - iBook G4 (14-inch Mid 2005) Take Apart Frame • Fan • Top case • Sleep light board • Top shield • Display module • I/O Bezel • RJ11 modem cable • Hard drive • Modem • AirPort Extreme/Bluetooth card • Optical drive • Heatsink • Vent cover • Logic board Procedure With all preliminary steps completed, the frame is the remaining part. 1. Remove any remaining tape from the frame.
Page 133
iBook G4 (14-inch Mid 2005) Take Apart - 132 Frame 2. Turn over the frame and remove the tape from the other side. 3. Reassemble and test the computer.
Page 134
133 - iBook G4 (14-inch Mid 2005) Take Apart Display Rear Housing Display Rear Housing Tools • Soft cloth • Torx T6 screwdriver or 5/32 hex driver • Black stick (or other nonconductive nylon or plastic tool) Note: To organize the screws you remove from the display assembly, use a tray with divided compartments (such as a plastic ice cube tray). Replacement Note: If the tape you remove from this assembly is worn and cannot be reused, use new Kapton tape (Apple part number 922-5025). Part Location
Page 135
iBook G4 (14-inch Mid 2005) Take Apart - 134 Display Rear Housing Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • Memory card • Bottom case • Bottom shield • DC-in board • Top case • Top shield • Modem • AirPort Extreme/Bluetooth card • Display module Procedure 1. With the display face down on a soft cloth, remove the four 7-mm long hex screws (two from each side) from the display module.
Page 136
135 - iBook G4 (14-inch Mid 2005) Take Apart Display Rear Housing 2. Starting at a corner of the display, use a black stick to pry up the bezel from the display housing. Carefully work the black stick around the outer perimeter and corners of the bezel. 3. Lift off the display assembly from the display housing.
Page 137
![Page 137
iBook G4 (14-inch Mid 2005) Take Apart - 136
Display Rear Housing 4. Install the replacement display rear housing, and reassemble and test the computer.
Replacement Note: Make sure the replacement housing is clean and free of dust.
Make sure that no cables can be pinched as you place the LCD panel assem\
bly into
the housing.Verify that the screw holes are aligned before installing th\
e screws.](http://img.usermanuals.tech/thumb/462/38817/w300_ibook-g4-14-inch-mid-2005-136.png "Page 137
iBook G4 (14-inch Mid 2005) Take Apart - 136
Display Rear Housing 4. Install the replacement display rear housing, and reassemble and test the computer.
Replacement Note: Make sure the replacement housing is clean and free of dust.
Make sure that no cables can be pinched as you place the LCD panel assem\
bly into
the housing.Verify that the screw holes are aligned before installing th\
e screws.")
iBook G4 (14-inch Mid 2005) Take Apart - 136 Display Rear Housing 4. Install the replacement display rear housing, and reassemble and test the computer. Replacement Note: Make sure the replacement housing is clean and free of dust. Make sure that no cables can be pinched as you place the LCD panel assem\ bly into the housing.Verify that the screw holes are aligned before installing th\ e screws.
Page 138
137 - iBook G4 (14-inch Mid 2005) Take Apart Display Clutch Cover Display Clutch Cover Tools • Soft cloth • #0 Phillips screwdriver • Black stick (or other nonconductive nylon or plastic tool) Note: To organize the screws you remove from the display assembly, use a tray with divided compartments (such as a plastic ice cube tray). Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • Memory card • Bottom case • Bottom shield • DC-in board • Top...
Page 139
iBook G4 (14-inch Mid 2005) Take Apart - 138 Display Clutch Cover Procedure 1. Note the placement of tape on the display shield. 2. Peel up the long strip of white tape where it covers the clutch cover screw on the right.
Page 140
![Page 140
139 - iBook G4 (14-inch Mid 2005) Take Apart
Display Clutch Cover
3. Near the right and left sides of the clutch, remove the two 12-mm long screws that
secure the clutch cover to the hinge assembly.
Replacement Note: Note that one of the screws (left side of the clutch when the
display is oriented as shown) also has a washer. Be sure to reinstall i\
t before
installing the clutch cover screw.](http://img.usermanuals.tech/thumb/462/38817/w300_ibook-g4-14-inch-mid-2005-139.png "Page 140
139 - iBook G4 (14-inch Mid 2005) Take Apart
Display Clutch Cover
3. Near the right and left sides of the clutch, remove the two 12-mm long screws that
secure the clutch cover to the hinge assembly.
Replacement Note: Note that one of the screws (left side of the clutch when the
display is oriented as shown) also has a washer. Be sure to reinstall i\
t before
installing the clutch cover screw.")
139 - iBook G4 (14-inch Mid 2005) Take Apart Display Clutch Cover 3. Near the right and left sides of the clutch, remove the two 12-mm long screws that secure the clutch cover to the hinge assembly. Replacement Note: Note that one of the screws (left side of the clutch when the display is oriented as shown) also has a washer. Be sure to reinstall i\ t before installing the clutch cover screw.