Apple ibook g4 14 inch mid 2005 User Manual
Here you can view all the pages of manual Apple ibook g4 14 inch mid 2005 User Manual. The Apple manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 101
iBook G4 (14-inch Mid 2005) Take Apart - 100 Optical Drive 5. Warning: Handle the optical drive at the sides only. Do not touch or press anywhere else on the drive. Without pinching any cables, tilt up the optical drive and lift it out t\ he drive.
Page 102
101 - iBook G4 (14-inch Mid 2005) Take Apart Optical Drive 6. Remove the two identical 3-mm long screws that hold the bracket to the optical drive. 7. Remove the cable bracket. Note: When reassembling the computer, transfer the cable bracket to the replacement drive. 8. Peel off the tape from the optical drive, and use a black stick to disconnect the ribbon cable. Note: When reassembling the computer, transfer the ribbon cable to the replacement drive.
Page 103
iBook G4 (14-inch Mid 2005) Take Apart - 102 Optical Drive 9. Remove the 4.5-mm long screws that hold the mounting bracket to the optical drive. Although the three screws are the same length, the screw that secures the bracket to the bezel is a different shape (no collar), while the other two have collars. Important: When reassembling the computer, transfer the mounting bracket to the replacement drive. Replacement Warning: Make sure you use the collar-less screw to secure the mounting bracket...
Page 104
103 - iBook G4 (14-inch Mid 2005) Take Apart Optical Drive 10. With the pointed end of a black stick, press lightly on the three tabs, and tilt the bezel up and off of the drive.
Page 105
iBook G4 (14-inch Mid 2005) Take Apart - 104 Optical Drive 11. Install the replacement optical drive, and reassemble and test the computer. Replacement Note: When installing the replacement optical drive, align the front of the drive bezel to the outer edge of the frame first. Make sure the scre\ w holes align. Check that the felt at the slot opening is even and not mashed.
Page 106
105 - iBook G4 (14-inch Mid 2005) Take Apart How to Remove a Stuck Disc from the Slot-Load How to Remove a Stuck Disc from the Slot-Load Drive The following instructions explain how to remove a disc that is stuck in the slot-load optical drive. Important: When a disc becomes stuck in the slot-load optical drive, it makes the drive unusable. Make sure you have a replacement drive available. Tools This procedure requires the following tools: • ESD wriststrap and mat • #0 Phillips screwdriver • Black...
Page 107
iBook G4 (14-inch Mid 2005) Take Apart - 106 How to Remove a Stuck Disc from the Slot-Load Procedure 1. Remove the four identical screws that hold the top cover to the drive. 2. Slide the top cover approximately 2 mm toward the back of the drive. Lift up the top cover to remove it.
Page 108
107 - iBook G4 (14-inch Mid 2005) Take Apart How to Remove a Stuck Disc from the Slot-Load 3. Check the placement of the disc. It is either clamped to the turntable at the center of the disc, or it is wedged under one or more posts at the outer edge of the disc. 4. Holding the edge of the disc, press on the center clamp or hold the posts steady as you remove the disc from the drive. Important: Do not touch any key components located near the disc. 5. Replace the top cover on the drive so that the...
Page 109
iBook G4 (14-inch Mid 2005) Take Apart - 108 Display Module Display Module Tools • Soft cloth • #0 Phillips screwdriver • Black stick (or other nonconductive nylon or plastic tool) Note: To organize the screws you remove from the computer, use a tray with divided compartments (such as a plastic ice cube tray). Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield
Page 110
109 - iBook G4 (14-inch Mid 2005) Take Apart Display Module • Memory card • Bottom case • Bottom shield • DC-in board • Top case • Top shield • Modem • AirPort Extreme/Bluetooth card (or just the Y-shaped card holder) Procedure 1. With the computer on a soft cloth, note the routing of the thin, black microphone cable and the LVDS (low voltage data signal) cable. 2. Disconnect the microphone cable from the logic board near the hard drive. 3. Pull up the flexible tab to disconnect the LVDS cable from...