Alpina Cultivator 8214-2213-87 Crono 82R2-H Instructions Manual
Here you can view all the pages of manual Alpina Cultivator 8214-2213-87 Crono 82R2-H Instructions Manual. The Alpina manuals for Cultivator are available online for free. You can easily download all the documents as PDF.
Page 41
41 ENGLISHGB 1 SYMBOLS The following symbols can be found on the rotary cultivator/in these instructions. These will provide a reminder of the care and attention that is required during operation. If any symbol is missing, has been damaged or is illegible, it must immediately be replaced with a new one. This is what the symbols mean: Warning! Read the owner’s manual before operating the machine. Warning! Rotating blade. Warning! This symbol highlights impor- tant text in these instructions. Risk of...
Page 42
42 ENGLISHGB • Wear tightly fitting clothes and heavy-duty shoes which completely cover the feet. • The tank should only be half full when operat- ing on slopes. Petrol can leak out. • The engine must be stopped in the following circumstances: • When the machine is left unattended • Before the machine is filled up with petrol • Always make sure you have a good footing, es- pecially on slopes. • Check that no one is in front of you or beside you when starting the blades. Keep a steady grip on the...
Page 43
43 ENGLISHGB 3.5 Throttle cable1. Install the throttle cable on the engine if not al- ready installed. See the engine supplier’s man- ual. 2. Pull up the cable under the support’s (5:E) up- per section and over the screws in fig. 7. 3. Install the cable in the throttle. See fig. 11. 3.6 CablesPull up the cables under the cover under the sup- port’s (5:E) upper section and over the screws in fig. 7. Then install the ends into the relevant con- trol as follows: 1. Install the cable ends into the relevant...
Page 44
44 ENGLISHGB 4.10 Oil draining (1:L)The screw is removed when used engine oil is to be drained. 4.11 Auxiliary wheel (1:M)The auxiliary wheel is intended to assist transport of the machine and has two positions. The auxiliary wheel must be folded up when carrying out work. The auxiliary wheel must be down when transporting. The auxiliary wheel is folded up and down as fol- lows: 1. Pull out the auxiliary wheel stay to the left in the driving direction of the machine. See fig. 2. 2. Raise the...
Page 45
45 ENGLISHGB Oil-mixed petrol designed for 2-stroke engines must never be used. Filling Read and understand all safety instruc- tions. If the engine has been running, wait a few minutes until it has cooled before filling up. Fill carefully to prevent the spillage of fuel. Move the rotary cultivator at least 3 me- tres from the filling site before starting. Fill as follows: 1. Clean around the fuel cap. 2. Unscrew the filler cap. 3. Fill using a funnel or use a filler can with spout to prevent...
Page 46
46 ENGLISHGB 7 MAINTENANCE WARNING!Repairs must be carried out by the dealer. Otherwise the guarantee becomes invalid. WARNING!Before carrying out repairs and maintenance, the spark plug con- nection must be disconnected. 7.1 Periodic maintenanceBefore each operation • Check for fuel leaks. • Check that all screws are tightened. After each operation • Clean the rotary cultivator. • Check for fuel leaks. Every 25 operating hours and every 3 months • Check, clean or replace the air filter. • Check that...
Page 47
47 ENGLISHGB 8 SERVICE Authorised service stations carry out repairs and servicing. They always use genuine spare parts. Under no circumstances may parts oth- er than genuine spare parts be used. This is a requirement stipulated by the Testing Authority. The machine is ap- proved and tested with these parts. If the machine requires servicing, repair or maintenance that entails dismantling of the cover, this must be performed by an authorised service station. The manufacturer reserves the right to...
Page 48
48 FRANÇAISFR 1 SYMBOLES Les symboles suivants se retrouvent sur le motoc- ulteur/dans les présentes instructions. Ils servent d’aide-mémoire et attirent l’attention sur les pré- cautions d’utilisation de la machine. Remplacer immédiatement tout symbole manquant, endom- magé ou devenu illisible. Explication des symboles : Attention ! Lire le mode d’emploi avant d’utiliser la machine. Attention ! Lame en rotation. Attention ! Ce symbole met en évidence certaines instructions particulièrement im-...
Page 49
49 FRANÇAISFR • Démarrer le moteur prudemment en procédant selon les instructions de ce mode demploi. Au- cune partie du corps ne doit entrer en contact avec les rotors. • Ne jamais démarrer le moteur dans un espace clos. Le gaz carbonique contenu dans les gaz déchappement du moteur est toxique et présente un danger mortel. • Utiliser des vêtements collants et des chaus- sures robustes qui couvrent tout le pied. • Pour la conduite sur pentes, le réservoir ne doit être rempli quà moitié. Risque de...
Page 50
50 FRANÇAISFR 2. Installer le guidon au moyen de la vis (7:H) avec deux rondelles et boulons et de la molette (7:1) avec 4 rondelles et vis (7:J). Orienter les ondulations des rondelles (7:K) vers l’intérieur. Vérifier que les vis traversent également la plaque de renfort (6:F). 3. Installer la traverse du guidon (8:L) au moyen des vis et écrous. 4. Monter le carter (1:I) et le visser par dessous à laide de quatre boulons. 3.4 CarterMonter le carter (1:I) en serrant par le bas les vis fournies....