Alpha Tool.Com.HK Limited Stone Cutter ECCKIT User Manual

11
ALPHA® ECOCUTTER STAND SCHEMATIC (ECC-STAND)
DRAWING NO.PART  NO.DESCRIPTIONQUANTITY
1200020Front Saw Stand1
2200021Rear Saw Stand1
3200022Wheel/Brake Assembly 1
4200026Saw Stand Screw Set1
5200024Wing Screw (2 pc set)1
—200023Saw Stand AssemblyALL   

12




 ALPHA® ECOCUTTER TABLE (ECC-TABLE)
After removal of all cutting table components from packing, check for ea\
ch item listed 
below:
 COMPONENTS:
1. Assembled Table (Part No. 200013)
2. Angle Guide Assembly (Part No. 200018)
3. Rip Guide Assembly (Part No. 200017)
4. Hose Holder Assembly (Part No. 200001)
5. Universal Wrench (Part No. 200019)
6. Brush (Part No. 200025)

Figure-13
  CAUTION!
WHEN REMOVING ECOCUTTER TABLE FROM CARTON, 
DO NOT LIFT BY RAIL TUBE.  ALWAYS USE SIDE HANDLE.
See page...

13
 INSTRUCTIONS ON REMOVING THE ECOCUTTER TABLE FROM BOX
Step 1.
Step 2.
Figure-14
Figure-15
Figure-16
Step 3.
RECOMMENDED METHOD   

14
  CAUTION!
 
NON-RECOMMENDED METHODS
Please note the following illustrations carefully before assembling tabl\
e to stand.
DO NOT LIFT TABLE BY RAIL TUBE.
  TABLE WILL BE DAMAGED 
IF HANDLED IMPROPERLY.
 INSTRUCTIONS ON HANDLING THE ECOCUTTER TABLE
Figure-17   

15
RECOMMENDED METHOD
Step 1.
Step 2.
Figure-18
Figure-19   

16
Step 3.
Step 4.
RECOMMENDED METHOD
Figure-20
Figure-21   

17
 ASSEMBLING TABLE TO STAND
1. Place stand in open position.
 Set caster wheel locks to the locked position by pressing latch down as shown in Figure 
22 and Figure 23.
Figure-22
Locked Position
Figure-23   

18
Wing Screw Clearance Hole
Location Pins
Stand
Figure-26
2. Pick up table by sides and place on stand. 
Figure-24Figure-25
 * Follow the recommended steps on pages 15 and 16   

19
3. After placement of the table onto the 
stand, adjust table so the side extension 
support slider tube fits outside of the 
location pins of both sides of the stand 
as shown in Figure 27.
Figure-27
Location Pins
Side Extension Support Slider Tube
4.  Align wing screw clearance hole with 
threaded hole of table cross support. 
(See Figure 28).
5.  Insert and tighten wing screw to a hand 
tight condition as shown in Figure 29.
6.  Repeat process for opposite side to 
complete the stand assembly....

20
 INSTALLATION OF THE HOSE HOLDER TO THE SAW BASE
1.  Position and align the hose holder to the saw base as shown in Figure 30, making note 
of the threaded hole locations.
Saw Base
Threaded Holes
Hose Holder
Figure-30
Figure-31
2.  Install supplied phillips screw 
and washer and hand tighten 
with screw driver as shown in 
Figure 31.