Home > AEG > Fridge freezer > AEG S 83200 Cmb0 User Manual

AEG S 83200 Cmb0 User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual AEG S 83200 Cmb0 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							• Regularly examine the drain in the refrigerator for defrosted water. If necessary, clean
    the drain. If the drain is blocked, water will collect in the bottom of the appliance.
    Installation
    For electrical connection carefully follow the instructions given in specific paragraphs.
    • Unpack the appliance and check if there are damages on it. Do not connect the appli-
    ance if it is damaged. Report possible damages immediately to the place you bought it.
    In that case retain packing.
    • It is advisable to wait at least four hours before connecting the appliance to allow the oil
    to flow back in the compressor.
    • Adequate air circulation should be around the appliance, lacking this leads to overheat-
    ing. To achieve sufficient ventilation follow the instructions relevant to installation.
    • Wherever possible the back of the product should be against a wall to avoid touching or
    catching warm parts (compressor, condenser) to prevent possible burn.
    • The appliance must not be located close to radiators or cookers.
    • Make sure that the mains plug is accessible after the installation of the appliance.
    •
    Connect to potable water supply only. 
    8)
    Service
    • Any electrical work required to do the servicing of the appliance should be carried out by
    a qualified electrician or competent person.
    • Do not remove the LED light cover. Contact the nearest After Sales Service Force to re-
    place the LED light board, if it is necessary.
    • This product must be serviced by an authorized Service Centre, and only genuine spare
    parts must be used.
    Environment Protection
    This appliance does not contain gasses which could damage the ozone layer, in either its
    refrigerant circuit or insulation materials. The appliance shall not be discarded together
    with the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-
    pliance shall be disposed according to the applicable regulations to obtain from your local
    authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-
    er. The materials used on this appliance marked by the symbol 
     are recyclable.
    8) If a water connection is foreseen.
    Safety information31
     
    						
    							CONTROL PANEL
    1
    7
    6
    5
    2
    3
    4
    1Fridge temperature colder button
    2Fridge temperature warmer button
    3ON/OFF button
    OK button
    4Freezer temperature warmer button
    5Display
    6Freezer temperature colder button
    7Mode button
    It is possible to change predefined sound of buttons to a loudly one by pressing togeth-
    er MODE 
    7 and MINUS 6 for some seconds. Change is reversible.
    Display
    9
    8
    7
    10
    1
    6
    5
    3
    2
    4
    1Fridge temperature indicator
    2Holiday function
    3Extra humidity function
    4Fridge Off
    5Freezer temperature indicator
    6Alarm indicator
    7Drink Chill function
    32Control panel
     
    						
    							8FROSTMATIC function
    9COOLMATIC function
    10Child Lock function
    Switching on
    To switch on the appliance do these steps:
    1. Connect the mains plug to the power socket.
    2. Press the appliance ON/OFF button if the display is off.
    3. The alarm buzzer could operate after few seconds.
    To reset the alarm refer to High temperature alarm.
    4. If dEMo appears on the display, the appliance is in demonstration mode. Refer to
    What to do if....
    5. The temperature indicators show the set default temperature.
    To select a different set temperature refer to Temperature regulation.
    Switching off
    To switch off the appliance do these steps:
    1. Press the ON/OFF button for 5 seconds.
    2. The display switches off.
    3. To disconnect the appliance from the power disconnect the mains plug from the power
    socket.
    Switching off the fridge
    To switch off the fridge:
    1. Press the Mode button until the corresponding icon appears.
    The Fridge Off indicator flashes.
    The fridge indicator shows dashes.
    2. Press the OK button to confirm.
    3. The fridge Off indicator is shown.
    Switching on the fridge
    To switch on the fridge:
    1. Press the fridge temperature regulator.
    Or:
    1. Press the Mode button until the corresponding icon appears.
    The Fridge Off indicator flashes.
    2. Press the OK button to confirm.
    3. The fridge Off indicator goes off.
    To select a different set temperature refer to Temperature regulation.
    Temperature regulation
    The set temperature of the fridge and of the freezer may be adjusted by pressing the tem-
    perature regulator button.Control panel
    33
     
    						
    							Set default temperature:
    • +5°C for the fridge
    • -18°C for the freezer
    The temperature indicators show the set temperature.
    To restore the set default temperature switch off the appliance.
    The set temperature will be reached within 24 hours.
    Fluctuations of some degrees around set temperature are normal and does not mean any
    fault in the appliance.
    After a power failure the set temperature remains stored.
    Child Lock function
    To lock the buttons from unintentional operation select the Child Lock function.
    To switch on the function:
    1. Press the Mode button until the corresponding icon appears.
    2. The Child Lock indicator flashes.
    3. Press the OK button to confirm.
    The Child Lock indicator is shown.
    To switch off the function:
    1. Press the Mode button until the Child Lock indicator flashes.
    2. Press the OK button to confirm.
    3. The Child Lock indicator goes off.
    Extra Humidity function
    If you need to increase the humidity in the refrigerator, we suggest activating the Extra
    Humidity function.
    To switch on the function:
    1. Press the Mode button until the corresponding icon appears.
    The Extra Humidity indicator flashes.
    2. Press the OK button to confirm.
    The Extra Humidity indicator is shown.
    To switch off the function:
    1. Press the Mode button until the Extra Humidity indicator flashes.
    2. Press the OK button to confirm.
    3. The Extra Humidity indicator goes off.
    COOLMATIC function
    If you need to insert a large amount of warm food, for example after doing the grocery
    shopping, we suggest activating the COOLMATIC function to chill the products more rapidly
    and to avoid warming the other food which is already in the refrigerator.
    To switch on the function:
    34Control panel
     
    						
    							1. Press the Mode button until the corresponding icon appears.
    The COOLMATIC indicator flashes.
    2. Press the OK button to confirm.
    The COOLMATIC indicator is shown.
    The COOLMATIC function shuts off automatically after approximately 6 hours.
    To switch off the function before its automatic end:
    1. Press the Mode button until the COOLMATIC indicator flashes.
    2. Press the OK button to confirm.
    3. The COOLMATIC indicator goes off.
    The function switches off by selecting a different fridge set temperature.
    Minute Minder function
    The Minute Minder function is to be used to set an acoustic alarm at the preferred time,
    useful for example when a recipe requires to cool down a mixture for a certain lenght of
    time, or when a reminder is needed in order not to forget the bottles placed in the freezer
    for fast cooling.
    To switch on the function:
    1. Press the Mode button until the corresponding icon appears.
    The Minute Minder indicator flashes.
    The Timer shows the set value (30 minutes) for a few seconds.
    2. Press the Fridge Temperature button to change the Timer set value from 1 to 90 mi-
    nutes.
    3. Press the OK button to confirm.
    The Minute Minder indicator is shown.
    The Timer start to flash (min).
    At the end of the countdown the Minute Minder indicator flashes and an audible alarm
    sounds:
    1. Remove any drinks contained in the freezer compartment.
    2. Press OK button to switch off the sound and terminate the function.
    It is possible to deactivate the function at any time during the countdown:
    1. Press the Mode button until the Minute Minder indicator flashes.
    2. Press the OK button to confirm.
    3. The Minute Minder indicator goes off.
    It is possible to change the time during the countdown and at the end by pressing the
    Fridge Temperature colder button or the Fridge Temperature warmer button.
    FROSTMATIC function
    To switch on the function:
    1. Press the Mode button until the corresponding icon appears.
    The FROSTMATIC indicator flashes.
    2. Press the OK button to confirm.Control panel
    35
     
    						
    							The FROSTMATIC indicator is shown.
    This function stops automatically after 52 hours.
    To switch off the function before its automatic end:
    1. Press the Mode button until the FROSTMATIC indicator flashes.
    2. Press the OK button to confirm.
    3. The FROSTMATIC indicator goes off.
    Place the fresh food to be frozen in the FROSTMATIC basket.
    The function switches off by selecting a different freezer set temperature.
    High temperature alarm
    An increase in the temperature in the freezer compartment (for example due to an earlier
    power failure) is indicated by:
    • flashing the alarm and freezer temperature indicators
    • sounding of buzzer.
    To reset the alarm:
    1. Press any button.
    2. The buzzer switches off.
    3. The freezer temperature indicator shows the highest temperature reached for a few
    seconds. Then show again the set temperature.
    4. The alarm indicator continue to flash until the normal conditions are restored.
    When the alarm has returned the alarm indicator goes off.
    Door open alarm
    An acoustic alarm will sound if the fridge door is left open for a few minutes. The door
    open alarm conditions are indicated by:
    • flashing Alarm indicator
    • acoustic buzzer
    When normal conditions are restored (door closed), the alarm will stop.
    FIRST USE
    Cleaning the interior
    Before using the appliance for the first time, wash the interior and all internal accessories
    with lukewarm water and some neutral soap so as to remove the typical smell of a brand-
    new product, then dry thoroughly.
    Do not use detergents or abrasive powders, as these will damage the finish.
    36First use
     
    						
    							DAILY USE
    Storage of frozen food
    When first starting-up or after a period out of use, before putting the products in the com-
    partment let the appliance run at least 2 hours on the higher settings.
    In the event of accidental defrosting, for example due to a power failure, if the power has
    been off for longer than the value shown in the technical characteristics chart under rising
    time, the defrosted food must be consumed quickly or cooked immediately and then re-
    frozen (after cooling).
    Thawing
    Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compart-
    ment or at room temperature, depending on the time available for this operation.
    Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking
    will take longer.
    Air cooling
    The ClimaTech technology let food cool quickly
    and a more uniform temperature in the compart-
    ment.
    This device allows for rapid cooling of foods and a
    more uniform temperature in the compartment.
    CleanAir Control filter
    Your appliance is equipped with a carbon filter behind a flap in the rear wall of the air dis-
    tributing box.
    The filter purifies the air from unwanted odours in the fridge compartment meaning that
    the storage quality will be further improved.
    Daily use37
     
    						
    							Movable shelves
    The walls of the refrigerator are equipped with a
    series of runners so that the shelves can be posi-
    tioned as desired.
    Bottle rack
    Place the bottles (with the opening facing front)
    in the pre-positioned shelf.
    If the shelf is positioned horizontally, place only
    closed bottles.
    This bottle holder shelf can be tilted in order to
    store previously opened bottles. To obtain this re-
    sult, pull the shelf up so it can rotate upwards and
    be placed on the next higher level.
    38Daily use
     
    						
    							Positioning the door shelves
    To permit storage of food packages of vari-
    ous sizes, the door shelves can be placed at
    different heights.
    To make these adjustments proceed as fol-
    lows:
    gradually pull the shelf in the direction of
    the arrows until it comes free, then reposi-
    tion as required.
    FreshBox drawer
    This device allows rapid cooling of foods and more
    uniform temperature in the drawer.
    To switch on the function:
    1. Switch on the COOLMATIC function.
    2. The COOLMATIC indicator comes on.
    3. Slide upward the flap as shown in the figure.
    To switch off the function:
    1. Slide down the flap.
    2. Switch off the COOLMATIC function.
    3. The COOLMATIC indicator goes off.
    The function switches off automatically after few
    hours.
    Daily use39
     
    						
    							ProFresh Mode
    If the compartment is not needed as FreshBox, the
    settings can be changed in order to have it just as
    a low temperature drawer.
    To switch on the function:
    1. Slide upward the flap as shown in the figure.
    To switch off the function:
    1. Slide down the flap.
    QuickChill of Drinks
    This function allows rapid cooling of drinks.
    To switch on the function:
    1. Remove or place upward the FreshBox drawer
    and put the bottle rack in front of the Quick-
    Chill slots as shown in the figure.
    2. Switch on the COOLMATIC function.
    3. The COOLMATIC indicator comes on.
    4. Slide upward the flap as shown in the figure.
    To switch off the function:
    1. Slide down the flap.
    2. Switch off the COOLMATIC function.
    3. The COOLMATIC indicator goes off.
    The function switches off automatically after few hours.
    40Daily use
     
    						
    All AEG manuals Comments (0)

    Related Manuals for AEG S 83200 Cmb0 User Manual