Home > ADT Security Services > Home Security > ADT Security Services iCenter 8132 User Manual

ADT Security Services iCenter 8132 User Manual

Here you can view all the pages of manual ADT Security Services iCenter 8132 User Manual. The ADT Security Services manuals for Home Security are available online for free. You can easily download all the documents as PDF.

Page 51

Internet Features (Contd) 
51 
 
User Feedback 
User Feedback 
Name:  
  
Email Address:   
  
Type of Feedback  Suggestion 
  
Category  iCenter/iCenter-i W eb Interface – Custom 
Content 
 
 Other:  
  
Comment: 
(250 characters max.)  
 
 
 
 
 
Logout
LogoutLogout Logout 
    
The LOGOUT
LOGOUTLOGOUT LOGOUT button allows you to leave the iCenter.alarmnet.com Internet site.  
Pressing the LOGOUT button displays the following:  
You have been logged out.   
Click Here to Close Your Browser 
  

Page 52

Internet Features (contd) 
52 
 
  
 
  

Page 53

 
53 
 
                                                 Advanced System Features 
 
Introduction to Advanced System Features 
While most of the commonly used security functions are available from 
ICenter/iCenter-i’s advanced user interface, there are some less used, advanced 
features that can either be accessed through Touchpad Emulation mode on the 
iCenter/iCenter-i or a standard Custom English Touchpad.  To program your 
system’s advanced features, refer to you Control Panel User Guide. 
Touchpad...

Page 54

Trouble Conditions (Contd) 
54 
 SCREEN ACTION 
 
 3.  Press the CONSOLE MODE button on the 
More Choices screen.  The Touchpad 
screen is displayed. 
  

Page 55

 
55 
 
Summary of Audio Notification 
 
SOUND CAUSE  DISPLAY 
Loud, Interrupted* 
Touchpad & 
External Fire Alarm  FIRE is displayed; descriptor of zone in 
alarm is displayed. 
Loud, Continuous* 
Touchpad & 
External Burglary/Audible Emergency 
Alarm  ALARM is displayed; descriptor of zone in 
alarm is also displayed. 
One Short Beep 
(not repeated) 
Touchpad only a.  System disarm   
b.  System arming attempt 
with an open zone. 
c.  Bypass verify  a.  DISARMED/READY TO ARM is 
displayed.  
b.  The...

Page 56

Summary of Audio Notification (Contd) 
56 
 
**  Entry warning may consist of three short beeps or slow continuous beeping, as 
programmed by your installer. 
***  Loss of system battery power is not indicated or annunciated by the Touchpad 
(warnings are for loss of AC power only). 
  

Page 57

 
57 
 
Summary of iCenter/iCenter-i LED Operation 
iCenter/iCenter-i LED Operation 
iCenter/iCenter-i has four LEDs labeled - WEB, ARMED, READY and MESSAGE. 
WEB and MESSAGE LEDs are yellow. ARMED LED is red and READY LED is 
green. Each LEDs on and off state has different meanings during different 
operations.  
Following states use LEDs to represent different sub-states. 
• Normal (Idle) State 
• Software Download State 
• Software Download State - Failure Modes 
Each LED can have four different...

Page 58

Summary of iCenter/iCenter-i LED Operation (Contd) 
58 
 
LED Operation When Software Download
LED Operation When Software DownloadLED Operation When Software Download LED Operation When Software Download Fails
 Fails Fails  Fails 
    
There are the following sequences providing the extra failure information: 
1.  CRC failure 1 (calculated CRC does not match CRC provided with binary) 
• WEB, ARMED, READY and MESSAGE – all FAST BLINK for 3 seconds, 
following 
• WEB, ARMED, READY and MESSAGE ON for 3...

Page 59

 
59 
 
iCenter/iCenter-i Setup 
 
How to Access iCenter/iCenter-i Setup Options 
Setup allows you to adjust the touch screen contrast and/or adjust the 
iCenter/iCenter-i speaker volume.  You may also select the time interval that must 
pass prior to iCenter/iCenter-i going into screen saver mode (screen goes blank). 
Additionally, you may enter the Use
UseUse User Setup
r Setupr Setup r Setup screen, Advanced Setup
Advanced SetupAdvanced Setup Advanced Setup screen, or 
Clean Screen
Clean ScreenClean...

Page 60

iCenter/iCenter-i Setup (contd) 
60 
 SCREEN ACTION 
 
How to Adjust the Touch Screen Contrast 
You may adjust the touch screen contrast as follows: 
If… Then… 
you want to increase contrast  press the slide bar above the current contrast 
setting. 
you want to decrease contrast  press the slide bar below the current contrast 
setting. 
if another adjustment or selection is to be 
made go to the corresponding paragraph in this 
section. 
If no additional adjustment or selection is to be 
made press the...
Start reading ADT Security Services iCenter 8132 User Manual

Related Manuals for ADT Security Services iCenter 8132 User Manual

All ADT Security Services manuals