Acer Ferrari One Service Guide

Chapter 341
External Modules Disassembly Flowchart
Screw List
StepScrewQuantityPart No.
HDD Module M3*3.5(silver) 4 86.TPK07.001
3G Module M2*4 1 86.W0107.003
WLAN Module M2*5 1 86.TG607.004
Disconnect power
and signal cables
from system
Remove
Battery
Turn off system
and peripherals
power
Remove
DIMMRemove
HDD
Remove
Lower Covers
Remove
WLAN Board
Remove
Dummy Card
Remove
3G Board
Remove
SIM Card 

42Chapter 3
Removing the Battery Pack
1.Turn the computer over. 
2.Slide the battery lock/unlock latch to the unlock position. 
3.Slide and hold the battery release latch to the release position (1), then slide out the battery pack from the 
main unit (2). 
12 

Chapter 343
Removing the Dummy Card
1.Press the dummy card to allow it to spring out.
2.Remove the dummy card.
Removing the SIM Card
1.See “Removing the Battery Pack” on page 42.
2.Press the SIM card to allow it to spring out. 

44Chapter 3
3.Pull the SIM card out and store carefully.
Removing the Hard Disk Drive Module
1.See “Removing the Battery Pack” on page 42.
2.Loosen the two (2) captive screws on the HDD Cover.
3.Remove the HDD Cover from the inside edge. 

Chapter 345
4.Grasp the black tab.
5.Lift up on the black tab to pull the HDD out but do not remove completely. Flip the HDD over to allow 
access to the HDD cable.
CAUTION: Do not pul the HDD out before disconnecting the HDD cable.
6.Grasp the HDD cable connector tab and pull up. 

46Chapter 3
7.Remove the HDD cable from the HDD.
8.Remove the four (4) screws of the HDD rails. 
9.Remove the rails from the HDD.
Removing the 3G Module
1.See “Removing the Battery Pack” on page 42.
StepScrewQuantityScrew Type.
HDD Disassembly 3*3.5 (silver)  4 

Chapter 347
2.Loosen the three (3) captive screws in the Memory Cover.
3.Lift the Memory Cover out from the rear edge.
4.Remove the cables from the 3G module. 

48Chapter 3
5.Remove the one (1) screw from the 3G module.
6.Remove the 3G module.
StepScrewQuantityScrew Type.
3G Disassembly 2*4 1 

Chapter 349
Removing the DIMM Module
1.See “Removing the Battery Pack” on page 42.
2.Loosen the three (3) captive screws in the Memory Cover.
3.Remove the Memory Cover from the rear edge.
4.Pull open the two memory side clips. 

50Chapter 3
5.Lift the memory card out.
6.Repeat steps 4) and 5) for the second memory card.