Acer Ferrari One Service Guide

Chapter 3101
3.Lay the cable into the retention guides and press down the adhesive tape.
Replacing the RTC battery
1.Insert the RTC battery into the holding clips.
Replacing the CPU
1.Place the CPU into the socket paying attention to the correct alignment of the locating triangle in the 
corner. 

102Chapter 3
2.Turn the CPU lock to the locked position.
Replacing the Thermal Module
IMPORTANT: Ensure all heat pads are in place before replacing the Thermal Module.
The following TIM material and dimensions (mm) are approved for use:
1.Remove all traces of thermal grease or pad adhesive from the CPU and thermal module using a lint-free 
cloth or cotton swab and Isopropyl Alcohol, Acetone, or other approved cleaning agent. 
CPU TIM PSX-D 18.3*12.3mm
Vram TIM T-Flex-320 13*9*05mmPCHNB TIM FSL-BS...

Chapter 3103
2.Place the thermal module on the main board.
3.Tighten the two (2) captive screws (blue call outs) and replace the three (3) screws (red call outs) of the 
thermal module.
4.Connect the fan cable to the main board.
StepScrewQuantityScrew Type.
Thermal Module 
Assembly2*3 3 

104Chapter 3
Replacing the Mainboard
1.Place the main board into the lower cover on an angle first aligning the I/0 ports.
2.Replace the one (1) screw.
3.Connect the speaker connector.
StepScrewQuantityScrew Type.
Main Board Assembly 2*3 1 

Chapter 3105
Replacing the LCD Module
1.Thread the antenna cables through to the bottom side of the lower cover and place in the retention 
guides.
 
2.Place the hinges down on the lower case and ensure correct positioning of the antenna cables and the 
LCD cable and replace the two (2) screws.
StepScrewQuantityScrew Type.
LCD Module Assembly 2*5 2 

106Chapter 3
3.Replace the LCD cable connector.
4.Press down the LCD cable connector protective cover.
Replacing the I/O Board
1.Place the I/O board into the lower cover on an angle first aligning the I/O ports.  

Chapter 3107
IMPORTANT:Ensure that the WLAN/3G switch and the Bluetooth switch are properly aligned in the plastic 
slide switch covers in the lower cover. 
NOTE: You will feel the spring tension in the lower case sliders when the switches have been properly 
engaged.
2.Replace the one (1) screw.
StepScrewQuantityScrew Type.
IO Board Assembly 2*5 1 

108Chapter 3
3.Reconnect the DC cable to the I/O board.
4.Lay the DC cable into the retention guide and press down the adhesive tape.
5.Reconnect the DC cable to the main board. 

Chapter 3109
6.Reconnect the card reader cable. 
Replacing the Bluetooth Module
1.Place the Bluetooth module into position ensuring the board fits into the slot in the speaker module. 

11 0Chapter 3
2.Reconnect the Bluetooth cable.
Replacing the Button Board
1.Place the button board on the upper cover.