Acer Aspire One Model Nav Service Guide

Chapter 361
Removing the Speaker Module
1.See “Removing the Upper Cover” on page 54.
2.Remove the four (4) securing screws (two for each Speaker).
3.Disconnect the Speaker cable as shown.
StepSizeQuantityScrew Type
Speaker Module M2*4 4 

62Chapter 3
4.Lift out the left speaker while removing the Speaker cable from the cable channel. Ensure that the cable is free 
from all cable clips.
5.Lift the Speaker Module clear of the Lower Cover. 

Chapter 363
Removing the I/O Board
1.See “Removing the Upper Cover” on page 54.
2.Remove one (1) screw from the I/O Board.
3.Disconnect the I/O Board cable.
StepSizeQuantityScrew Type
I/O Board M2*3 1 

64Chapter 3
4.Remove the I/O Board by angling the board upwards and pulling it out of the connector bracket as shown.  

Chapter 365
Removing the Mainboard
1.See “Removing the Speaker Module” on page 61.
2.Remove the LVDS adhesive tape.
3.Disconnect the LVDS cable and remove the cable from the cable channel.
4.Disconnect the AC cable as shown. 

66Chapter 3
5.Remove the one (1) screw securing the Mainboard to the Lower Cover.
6.Lift the Mainboard from the side opposite the connector bracket, then remove it from the Lower Cover.
7.Remove the DC-in port from the Lower Cover.
StepSizeQuantityScrew Type
Mainboard M2*4 1 

Chapter 367
Removing the Thermal Module
1.See “Removing the Mainboard” on page 65.
2.Disconnect the Fan cable from the Mainboard.
3.Remove the three (3) securing screws from the Thermal Module.
StepSizeQuantityScrew Type
Thermal Module M2*4 3 

68Chapter 3
4.Lift the Thermal Module clear of the Mainboard. 

Chapter 369
Removing the LCD Module
IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and 
replacement of the LCD Module, ensure all available cable channels and clips are used and that the cables are 
replaced in the same position.
1.See “Removing the Mainboard” on page 65.
2.Turn the device over and pull the white antenna cable out of the cable channel. Make sure the cable is free of 
the cable clips indicated.
3.Use both hands to pull the white antenna cable...

70Chapter 3
4.Pull the black antenna cable through the Lower Cover and release it from the cable channel as shown.
5.Remove two (2) screws from the LCD Assembly.
6.Lift the LCD Assembly clear of the device.
StepSizeQuantityScrew Type
LCD Assembly M2*4 2