Acer Aspire One Model Nav Service Guide
Have a look at the manual Acer Aspire One Model Nav Service Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 720 Acer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Chapter 361 Removing the Speaker Module 1.See “Removing the Upper Cover” on page 54. 2.Remove the four (4) securing screws (two for each Speaker). 3.Disconnect the Speaker cable as shown. StepSizeQuantityScrew Type Speaker Module M2*4 4
62Chapter 3 4.Lift out the left speaker while removing the Speaker cable from the cable channel. Ensure that the cable is free from all cable clips. 5.Lift the Speaker Module clear of the Lower Cover.
Chapter 363 Removing the I/O Board 1.See “Removing the Upper Cover” on page 54. 2.Remove one (1) screw from the I/O Board. 3.Disconnect the I/O Board cable. StepSizeQuantityScrew Type I/O Board M2*3 1
64Chapter 3 4.Remove the I/O Board by angling the board upwards and pulling it out of the connector bracket as shown.
Chapter 365 Removing the Mainboard 1.See “Removing the Speaker Module” on page 61. 2.Remove the LVDS adhesive tape. 3.Disconnect the LVDS cable and remove the cable from the cable channel. 4.Disconnect the AC cable as shown.
66Chapter 3 5.Remove the one (1) screw securing the Mainboard to the Lower Cover. 6.Lift the Mainboard from the side opposite the connector bracket, then remove it from the Lower Cover. 7.Remove the DC-in port from the Lower Cover. StepSizeQuantityScrew Type Mainboard M2*4 1
Chapter 367 Removing the Thermal Module 1.See “Removing the Mainboard” on page 65. 2.Disconnect the Fan cable from the Mainboard. 3.Remove the three (3) securing screws from the Thermal Module. StepSizeQuantityScrew Type Thermal Module M2*4 3
68Chapter 3 4.Lift the Thermal Module clear of the Mainboard.
Chapter 369 Removing the LCD Module IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and replacement of the LCD Module, ensure all available cable channels and clips are used and that the cables are replaced in the same position. 1.See “Removing the Mainboard” on page 65. 2.Turn the device over and pull the white antenna cable out of the cable channel. Make sure the cable is free of the cable clips indicated. 3.Use both hands to pull the white antenna cable through the Lower Cover. Continue removing the cable from the cable channel as shown.
70Chapter 3 4.Pull the black antenna cable through the Lower Cover and release it from the cable channel as shown. 5.Remove two (2) screws from the LCD Assembly. 6.Lift the LCD Assembly clear of the device. StepSizeQuantityScrew Type LCD Assembly M2*4 2