Acer Aspire One Model Nav Service Guide

Chapter 381
CAUTION: Align the cable with the camera module. If the cable is misaligned, the camera module may shift 
causing the camera to sit in the wrong location.
4.Lay the cable across the LCD Panel in the area indicated between the green lines. Press down to adhere the 
cable. 

82Chapter 3
Replacing the WLAN Antennas
1.Place the antenna pad in the bracket.2.Run the cable along the cable channel, which is 
highlighted between the green lines.
3.Adhere the foil tabs to the white antenna cable.4.Place the antenna pad in the bracket.
5.Run the cable along the cable channel, which is 
highlighted between the green lines.6.Adhere the foil tabs to the black antenna cable. 

Chapter 383
Replacing the Microphone Set
1.Replace the Microphone set and fold over the foil tab.
2.Run the cable along the cable channel while adhereing the foil tabs. The cable channel is highlighted between 
the green lines.
3.Secure the last foil tab near the bottom left of the bracket. 

84Chapter 3
Replacing the LCD Panel
1.Place the LCD Panel in the LCD Bracket.
2.Secure the LCD Assembly using four (4) screws.
3.Run the LVDS cable in the cable channel while replacing the foil tabs. 

Chapter 385
Replacing the Camera Board
CAUTION: Do not handle the Web Camera Board with excessive force.
1.Attach the Web Camera Board to the inside of the bracket. Press down to secure the board in place.
2.Connect the Camera cable as shown. 

86Chapter 3
Replacing the LCD Bezel
1.Place the LCD Bezel on the LCD Assembly. Press down on all sides to make sure the bezel is fitted securely.
2.Secure the LCD Bezel using two (2) screws and two (2) screw caps. 

Chapter 387
Main Module Reassembly Procedure
Replacing the LCD Module
1.Place the LCD Module on the Lower Cover.
2.Secure the LCD Module using two (2) screws.
3.Run the black antenna cable through the cable channel and pull it through the casing as shown.  

88Chapter 3
4.Run the white antenna cable through the cable channel and pull it through the casing as shown. 
5.Turn the device over and continue running the white antenna cable through the cable channel. Make sure the 
cable is secured under the cable clips indicated. 

Chapter 389
Replacing the Thermal Module
IMPORTANT: Ensure all heat pads are in place before replacing the Thermal Module.
The following thermal pads are approved for use:
•Eapus XR-PE
1.Align the screw holes on the Thermal Module and Mainboard and replace the module.
2.Secure the Thermal Module using three (3) screws.
3.Connect the fan to mainboard cable. 

90Chapter 3
Replacing the Mainboard
1.Place the DC-in port in the Lower Cover.2.Replace the Mainboard by lining up the connector 
bracket before replacing completely.
3.Secure the Mainboard using one (1) screw.4.Connect the AC cable.
5.Run the LVDS cable along the cable channel as 
shown.6.Connect the LVDS cable to the Mainboard.