Acer Aspire One Model Nav Service Guide

Chapter 391
Replacing the I/O Board
7.Replace the LVDS adhesive tape.
1.Replace the I/O Board by lining up the board with 
the connector bracket as shown.2.Connect the I/O cable.
3.Secure the I/O Board by replacing one (1) screw. 

92Chapter 3
Replacing the Speaker Module
Replacing the Bluetooth Module
1.Secure the Speaker Module by replacing four (4) screws.
2.Connect the Speaker cable as shown.
1.Attach the Bluetooth Board to the casing. Press 
down to secure it in place.2.Connect the Bluetooth to Mainboard cable. 

Chapter 393
Replacing the Bridge Board
1.Notice the connectors located on the underside of the Bridge Board. Reconnect the Bridge Board by lining the 
board up with the connectors as shown.
NOTE: Press down firmly to ensure the two connectors are properly seated.
2.Secure the Bridge Board using two (2) screws. 

94Chapter 3
Replacing the LED Board
Replacing the Touchpad Board
1.Place the Touchpad Board in the device, while pressing down on the FFC to adhere it to the Upper Cover. 1.Place the LED Board in the device.
2.Secure the LED Board using one (1) screw. 

Chapter 395
2.Secure the Touchpad Board using two (2) screws.
3.Connect the Touchpad cable and lock the connector. 

96Chapter 3
Replacing the Upper Cover
1.Place the Upper Cover on the Lower Cover. Press down firmly to ensure that the covers are locked together.
2.Secure the Upper Cover using seven (7) screws. 

Chapter 397
3.Reconnect the following cables to the Mainboard.
Connect A to the Mainboard. Secure the locking latch on A as shown.
Connect B to the Mainboard. Secure the locking latch on B as shown.
B
A 

98Chapter 3
Replacing the Keyboard
1.Turn the computer over. Insert the Keyboard FPC in 
to the Mainboard connector.2.Close the FPC locking latch as shown.
3.Turn the Keyboard over and slide it in the direction of the arrow. Press down around the edges of the Keyboard 
to engage the locking latches.
4.Secure the Back Cover using eleven (11) screws. 

Chapter 399
Replacing the WLAN Module
Replacing the DIMM Module
1.Replace the WLAN card.
2.Secure the WLAN module using one (1) screw.3.Connect two (2) antenna cables to the WLAN 
module.
1.Line the DIMMcard up with the slot. 2.Push the DIMM card down until there is an audible 
click. 

100Chapter 3
3.Replace the DIMM cover by first lining up the guide 
hooks on the top edge. 4.Press down on the cover to lock all guide hooks. The 
cover should be flush with the device.
5.Secure the DIMM cover using one (1) screw.