2012 Na Yamaha Super Tenere Manual

haha THROTTLE BODIES
7-10
 Do not apply cleaning solvent directly to 
any plastic parts, sensors, or seals.
 Do not directly push the throttle valves to 
open them.
 Be careful not to remove the white paint 
mark that identifies the standard throttle 
body. Do not turn the bypass air screws 
“a” ; otherwise, the throttle body synchroni-
zation will be affected.
▼▼▼▼ ▼ ▼▼▼ ▼▼▼▼▼ ▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼ ▼▼▼▼
a. Place the throttle bodies on a flat surface with 
the air filter case side facing up.
b....

haha THROTTLE BODIES
7-11
▲▲▲▲ ▲ ▲▲▲ ▲▲▲▲▲ ▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲ ▲▲▲▲
3. Adjust: Throttle bodies synchronizing
Out of specification   Replace the throttle 
bodies.
Refer to  “SYNCHRONIZING THE THROT-
TLE BODIES ” on page 3-8.
EAS21010
CHECKING THE THROTTLE BODY JOINTS
1. Remove: Air filter case
Refer to  “GENERAL CHASSIS ” on page 4-1.
 Throttle bodies
Refer to  “THROTTLE BODIES ” on page 7-6.
2. Check: Throttle body joints “1”
Cracks/damage   Replace.
3. Install:  Throttle bodies
Refer to...

haha THROTTLE BODIES
7-12
c. Close the valve on the injector pressure  adapter.
d. Apply air pressure with the air compressor.
e. Open the valve on the injector pressure  adapter until the specified pressure is 
reached.
NOTICE
ECA23P1070
Never exceed the specified air pressure or 
damage could occur.
f. Close the valve on the injector pressure adapter.
g. Check that the specified air pressure is held 
for about one minute.
Pressure drops   Check the pressure gauge 
and adapter.
Check the seals and...

haha THROTTLE BODIES
7-13
d. Start the engine.
e. Measure the fuel pressure. Faulty   Replace the fuel pump.
▲▲▲▲ ▲ ▲▲▲ ▲▲▲▲▲ ▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲ ▲▲▲▲
EAS23P1084
ADJUSTING THE THROTTLE POSITION 
SENSOR
WARNING
EWA23P1033
 Handle the throttle position sensor with 
special care.
 Never subject the throttle position sensor 
to strong shocks. If the throttle position 
sensor is dropped, replace it.
1. Check: Throttle position sensor
Refer to  “CHECKING THE THROTTLE PO-
SITION SENSOR ” on page 8-143.
2....

haha THROTTLE BODIES
7-14
b. Check that the throttle valves are fully closed.
c. Connect the accelerator position sensor to  the wire harness.
d. Connect the throttle cables to the throttle bod- ies.
e. Turn the main switch to  “OFF ”.
f. Simultaneously press and hold the left set  button  “1” and right set button  “2”, turn the 
main switch to  “ON ”, and continue to press 
the buttons for 8 seconds more.
TIP
“ dIAG ” appears on the odometer LCD.
g. Diagnostic code number  “d:14”  is selected.
h. Turn...

haha THROTTLE BODIES
7-15  

haha 8
ELECTRICAL SYSTEM
IGNITION SYSTEM ......................................................................................... 8-1
CIRCUIT DIAGRAM .................................................................................. 8-1
ENGINE STOPPING DUE TO SIDESTAND OPERATION ....................... 8-3
TROUBLESHOOTING .............................................................................. 8-4
ELECTRIC STARTING SYSTEM .................................................................... 8-7...

haha ABS (ANTI-LOCK BRAKE SYSTEM)........................................................... 8-79
CIRCUIT DIAGRAM ................................................................................ 8-79
ABS COMPONENTS CHART ................................................................. 8-81
ABS COUPLER LOCATION CHART ...................................................... 8-83
MAINTENANCE OF THE ABS ECU ....................................................... 8-85
ABS TROUBLESHOOTING...

haha   

haha IGNITION SYSTEM
8-1
EAS27090
IGNITION SYSTEM
EAS27110
CIRCUIT DIAGRAM
B/LB/L1
W1(GRAY)W3 W2
(BLACK)
BR2
WL
B1 W1
WL
B2 W2
Y2L/RB2LYB
BL/BBrR/WB4
Br
G/RB
(GRAY)L/R2B4
(YELLOW)
ChB
(GRAY)Ch3B
(GRAY)
LDg
B
(BLACK)LDg B5
(BLACK)
LChB
(GRAY)L1ChB4
(GRAY)
Dg B
(BLACK)Dg3B3
(BLACK)
B/GL/BLg/WBL/BB/GB5Lg/W
BB/WBB/W
L/WR2R/W2
RR1
B1 B2B4L/G
R/B1Y3W/L1R/W1B Br3R/BR/WL/WG/YBBrW/GB/WB/W2W/G
Br/LLR/W4G/Y
Br1L/B1R/Y1Y/B
Br/RL/YL/B
Br/RB/R1B/R
L/Y
B/Y(BLACK)
Br/ WBr4
L/Y
B/Y(BLACK)L
BR
GB1
L/B
YL/R3
W(BLACK)...