ZyXEL Router Prestige 334 User Manual

Prestige 334 User’s Guide
Chapter 20 Menu 2 WAN Setup 210
CHAPTER20
Menu 2 WAN Setup
This chapter describes how to configure the WAN using menu 2.
20.1  Introduction to WAN
This chapter explains how to configure settings for your WAN port.
20.2  WAN Setup
From the main menu, enter 2 to open menu 2.
Figure 93   Menu 2 WAN Setu
The following table describes the fields in this menu.
               Menu 2 - WAN Setup
          MAC Address:
          Assigned By= Factory default
          IP Address= N/A...

Prestige 334 User’s Guide
211 Chapter 20 Menu 2 WAN Setup 

Prestige 334 User’s Guide
Chapter 21 Menu 3 LAN Setup 212
CHAPTER21
Menu 3 LAN Setup
This chapter covers how to configure your wired Local Area Network (LAN) settings.
21.1  LAN Setup
This section describes how to configure the Ethernet using Menu 3 — LAN Setup. From the 
main menu, enter 3 to display menu 3.
Figure 94   Menu 3 LAN Setup
21.1.1  General Ethernet Setup
This menu allows you to specify filter set(s) that you wish to apply to the Ethernet traffic.  You 
seldom need to filter Ethernet...

Prestige 334 User’s Guide
213 Chapter 21 Menu 3 LAN Setup
21.2  Protocol Dependent Ethernet Setup
Depending on the protocols for your applications, you need to configure the respective 
Ethernet Setup, as outlined below.
• For TCP/IP Ethernet setup refer to the Internet Access Application chapter.
• For bridging Ethernet setup refer to the Bridging Setup chapter.
21.3  TCP/IP Ethernet Setup and DHCP
Use menu 3.2 to configure your Prestige for TCP/IP.
To edit menu 3.2, enter 3 from the main menu to...

Prestige 334 User’s Guide
Chapter 21 Menu 3 LAN Setup 214
Use the instructions in the following table to configure TCP/IP parameters for the LAN port.
Size of Client IP 
PoolThis field specifies the size, or count of the IP address pool.
First DNS Server
Second DNS 
Server
Third DNS Server
The Prestige passes a DNS (Domain Name System) server IP address (in the order 
you specify here) to the DHCP clients. 
Select From ISP if your ISP dynamically assigns DNS server information (and the 
Prestiges WAN IP...

Prestige 334 User’s Guide
215 Chapter 21 Menu 3 LAN Setup
21.3.1  IP Alias Setup
IP alias allows you to partition a physical network into different logical networks over the 
same Ethernet interface. The Prestige supports three logical LAN interfaces via its single 
physical Ethernet interface with the Prestige itself as the gateway for each LAN network.
Figure 97   Physical Network & Partitioned Logical Networks
You must use menu 3.2 to configure the first network. Move the cursor to the Edit IP Alias...

Prestige 334 User’s Guide
Chapter 21 Menu 3 LAN Setup 216
IP Subnet MaskYour Prestige will automatically calculate the subnet mask based on the IP 
address that you assign. Unless you are implementing subnetting, use the subnet 
mask computed by the Prestige.
RIP DirectionPress [SPACE BAR] and then [ENTER] to select the RIP direction. Options are 
Both, In Only, Out Only or None.
Ve r s i o nPress [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-
1, RIP-2B or RIP-2M.
Incoming...

Prestige 334 User’s Guide
217 Chapter 21 Menu 3 LAN Setup 

Prestige 334 User’s Guide
Chapter 22 Internet Access218
CHAPTER22
Internet Access
This chapter shows you how to configure your Prestige for Internet access .
22.1  Introduction to Internet Access Setup 
Use information from your ISP along with the instructions in this chapter to set up your 
Prestige to access the Internet. There are three different menu 4 screens depending on whether 
you chose Ethernet, PPTP or PPPoE Encapsulation. Contact your ISP to determine what 
encapsulation type you should use....

Prestige 334 User’s Guide
219Chapter 22 Internet Access
Figure 99   Menu 4 Internet Access Setup
The following table describes the fields in this menu.
                    Menu 4 - Internet Access Setup
         ISPs Name= MyISP
         Encapsulation= Ethernet
         Service Type= Standard
           My Login= N/A
           My Password= N/A
           Retype to Confirm= N/A
           Login Server= N/A
           Relogin Every (min)=  N/A
         IP Address Assignment= Dynamic
           IP Address=...