Zanussi Zrg 314 Sw User Manual
Here you can view all the pages of manual Zanussi Zrg 314 Sw User Manual. The Zanussi manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.
Page 41
Important! Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. To remove the frost, do these steps: 1. Switch off the appliance. 2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. 3. Leave the door open. 4. When defrosting is completed, dry the interior thor- oughly and refit the plug. 5. Switch on the appliance. 6. Set the temperature regulator to obtain the maximum coldness and run the appliance for two or three hours using this...
Page 42
ProblemPossible causeSolution The product temperature is too high.Let the product temperature decrease to room temperature before storage. The room temperature is too high.Decrease the room temperature. Water flows on the rear plate of the refrigerator.During the automatic defrosting proc- ess, frost defrosts on the rear plate.This is correct. Water flows into the refrigerator.The water outlet is clogged.Clean the water outlet. Products prevent that water flows into the water collector.Make sure that...
Page 43
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to Installation. 3. If necessary, replace the defective door gaskets. Con- tact the Service Center. Technical data ZRG314SWZRG714SW Dimension Height850 mm850 mm Width550 mm550 mm Depth612 mm612 mm Rising Time 11 h11 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the Safety Information carefully for your...
Page 44
Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. En- sure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate levelling is ensured by one or...
Page 45
1. Remove the plug from the power socket. 2. Tilt back the appliance carefully so that the com- pressor cannot touch the floor. 3. Unscrew both adjustable feet. 4. Unscrew the screws of the door bottom hinge. Re- move the hinge. Put over the pin in the direction of the arrow. 5. Unscrew and install the screw on the opposite side. 6. Install the hinge on the opposite side. 7. Screw both adjustable feet.8. Unscrew both screws on the rear side. 9. Push back the top and lift it from the fixing elements.10....
Page 46
Reversibility of the freezer door 180˚ Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if...