Yamaha Rx5 Manual

362. Use the -1/NO and +1/YES keys or the DATA ENTRY slider to change the Attack
Rate.Range: 01—99.
PARAMETER 2: DECAY 1 RATE1. To select Decay 1 Rate, press “2”
2. Use the -1/NO and +1/YES keys or the DATA ENTRY slider to change the Decay
1 Rate.
Range: 01—99.
PARAMETER 3: DECAY 1 LEVEL1. To select Decay 1 Level, press “3”
2. Use the -1/NO and +1/YES keys or the DATA ENTRY slider to change the Decay
1 Level.
Range: 01—60.
PARAMETER 4: DECAY 2 RATE1. To select Decay 2 Rate, press “4”.2. Use the -1/NO and...

37 

38 

39
JOB #09: RECALL EDlT
FUNCTIONTo recall the last voice that was in the Voice Edit buffer.This function uses a second memory as a “back-up” function. It is used only while you
are actually editing, BEFORE storing a voice and exiting the Edit Mode. It covers you in
three possible situations.
1. You were editing a voice, then accidentally selected another voice for editing
BEFORE storing the first voice. You can use this Job to recall the first voice.
2. You had already edited and stored a voice. You then...

40 

41
JOB #02: PARAMETER ASSIGN
FUNCTIONTo edit the pitch, level, attack and decay parameters of any
selected instrument key.This function works independently of the Edit Voice functions. It “offsets” the parameters
of ANY voice assigned to a selected instrument key. If a new voice is assigned to the
same key, it will be offset exactly the same amount as the previous voice. The LCD will
show both the offset amount, and the actual parameter value (a combination of the
parameter values set using this job and...

42Decay 1 and Decay 2 Rates are equally affected. Refer to EDIT VOICE JOB #03 for an
explanation of these parameters. Decay 1 Level is NOT affected by this function.
Range: + 63(offset). Actual Decay Rate range is 01/+99 (actual Decay Rates cannot
be offset outside these limits).
NOTE: Long decays create “looping”. Refer to EDIT VOICE JOB #03 for comments
about this.
JOB #03: MULTI VOICE
FUNCTIONTo assign any selected voice to instrument keys A thru L,
then program a sliding scale of parameters to these...

433. Press START to enter the level step setting. On the LCD the word “step” will briefly
change to “set!” then return to “step”.
lThe original level will be retained at key A. Keys B through L will increase or decrease
in level, according to a positive or negative level step setting.
NOTE: The Multi Step function cannot alter a voice’s level beyond the upper and lower
limits of its level range (as set by the EDIT VOICE or KEY PARAMETER ASSIGN
functions). If a voice’s level is already set at or near...

44
OPERATION1. Press KEY ASSIGN and select JOB #05. The LCD will show the last Accent Level
that was selected in this Job. Example: Accent 1.
2. Press the instrument key for which the Accent Level is to be set.
3.Accents are set by first pressing either ACCENT 1 or ACCENT 2, then using the-1/NO and +1/YES keys or the DATA ENTRY slider to set the corresponding Accent
Level.
Range: + 31. The voice level range is 0—31. If the Accent Level setting PLUS the
original voice level setting exceeds 31 or is less...

45