Trane Rtaaiom3 Manual
Here you can view all the pages of manual Trane Rtaaiom3 Manual. The Trane manuals for Cooler are available online for free. You can easily download all the documents as PDF.
Page 21
21RTAA-IOM-3 Nameplates The RTAA outdoor unit nameplates are applied to the exterior and interior surface of the Control Panel door (Figure 1). A compressor nameplate is located on each compressor. On remote evaporators, the nameplate is located on the Terminal Box. Outdoor Unit Nameplate The outdoor unit nameplate provides the following information: – Unit model and size description. – Unit serial number. – Identifies unit electrical requirements.– Lists correct operating charges of R-22 and...
Page 22
22RTAA-IOM-3 Figure 8 Model Number Coding System RTAA200GXB01A0D0BDEG01 2 123 4 567 8 9 01 2 3 4 5 6 7 8 9 0 (Digit position for above) Where digits are assigned the following meanings: Digit Character No. Value Description 1, 2, 3 Unit Type/Function RTA Rotary (Series “R”) Air Cooled Chiller 4 Development Sequence A “A” Dev. Sequence 5, 6, 7 Unit Nominal Tons 130 130 Tons 140 140 Tons 155 155 Tons 170 170 Tons 185 185 Tons 200 200 Tons 240 240 Tons 270 270 Tons 300 300 Tons 340 340 Tons 370 370 Tons...
Page 23
23RTAA-IOM-3 Storage Extended storage of the outdoor unit prior to installation requires the following precautionary measures: 1. Store the outdoor unit in a secure area. 2. At least every three months (quarterly), check the pressure in the refrigerant circuits to verify that the refrigerant charge is intact. If it is not, contact a qualified service organization and the appropriate Trane sales off ice.
Page 25
25RTAA-IOM-3 General The following instructions are, for the most part, applicable to both packaged units and units with the remote evaporator option. Specific exceptions are noted. The most significant difference in the installation of the two systems is the requirement for interconnecting piping with the remote evaporator option. For this reason, these installation procedures are covered separately in the following section, Installation - Mechanical, Remote Evaporator Interconnecting Piping....
Page 26
26 RTAA-IOM-3 Figure 9 Dimensions and Clearances for RTAA Packaged Unit – 130 to 200 Ton RTAA-SU-1000E
Page 27
27 RTAA-IOM-3 Figure 10 Dimensions and Clearances for RTAA Packaged Unit – 240 - 300 Ton RTAA-SU-1001C
Page 28
28 RTAA-IOM-3 Figure 11 Dimensions and Clearances for RTAA Packaged Unit – 340 to 400 Ton RTAA-SU-1002C
Page 29
29 RTAA-IOM-3 Figure 12 Dimensions and Clearances for RTAA Outdoor Unit with Remote Evaporator Option RTAA-SU-1003A
Page 30
30 RTAA-IOM-3 Figure 13 Dimensions and Weights for Remote Evaporator Option RTAA-SU-1004A NOTES: 1. TOLERANCE ± 1/8” UNLESS OTHERWISE SPECIFIED. 2. ALLOW 8’-8” ON EITHER END FOR TUBE REMOVAL.