Toshiba Tec Bev4g Manual

4. TROUBLESHOOTING EO18-33025 
 
4.2 Print Quality
 
4-2 
4.2 Print Quality 
 
Problem  Possible Cause  Recovery Procedure 
Check if interface cable is well 
connected to the interface connector. Re-connect cable to interface. 
The serial port cable pin configuration 
is not pin to pin connected. Please replace the cable with pin to pin 
connected. 
The serial port setting is not consistent 
between host and printer. Please reset the serial port setting. 
The port specified in the Windows 
driver is not...

5. MAINTENANCE EO18-33025 
  5. MAINTENANCE
 
5-1 
5. MAINTENANCE 
WARNING! 
DO NOT USE a spray cleaner containing flammable gas for cleaning this product, as this may cause a fire.
 
This section presents the clean tools and methods to maintain your printer. 
1. Please use one of following material to clean the printer. 
•  Cotton swab ( Head cleaner pen ) 
•  Lint-free cloth 
•  Vacuum / Blower brush 
•  100%  ethanol  
2. The cleaning process is described as following 
Printer Part    Method...

5. MAINTENANCE EO18-33025 
 
5. MAINTENANCE
 
5-2 
Notes: 
1.  Do not touch printer head by hand. If you touch it careless, please use ethanol to clean it. 
2.  Please use 100% Ethenol. DO NOT use medical alcohol, which may damage the printer head. 
3.  Regularly clean the print head and supply sensors once change a new ribbon to keep printer 
performance and extend printer life. 
4.  Continuous printing will cause printer motor overheat. Printer will stop printing automatically about 
10~15 minutes...

6. SYSTEM MODE EO18-33025 
(Revision Date: Mar. 27, 2009) 
6.1 FIRMWARE DOWNLOAD
 
6-1 
6. SYSTEM MODE 
When the [FEED] button is held and the B-EV4 series is turned on, the printer is ready to start the 
system mode.    As the STATUS lamp turns in the following order every 1.5 seconds, release the 
[FEED] button while the STATUS lamp indicates your desired mode to go into it. 
Note: To go into the firmware download mode, release the [FEED] button and then immediately press it 
again. 
(1) Lights in...

6. SYSTEM MODE EO18-33025 
(Revision Date: Mar. 27, 2009) 
6.2 ABORT OF LABEL FORMAT AUTO CALL 
6-2 
6.2 ABORT OF LABEL FORMAT AUTO CALL 
When the STATUS lamp blinks in orange during the system mode, releasing the [FEED] button aborts a 
label format auto call. 
 
6.3 PARAMETER CLEAR 
When the STATUS lamp lights in orange during the system mode, releasing the [FEED] button performs 
a Parameter Clear. 
 
Parameter Initial Setting 
TONE ADJUST  +00 
FEED ADJUST  +0.0mm 
CUT POSITION ADJUST  +0.0mm...

6. SYSTEM MODE EO18-33025 
(Revision Date: Mar. 27, 2009)  6.4 SENSOR ADJUSTMENT
 
6-3 
6.4 SENSOR ADJUSTMENT 
Adjust the sensor to the proper position and set the label or tag paper. 
When the STATUS lamp lights in red during the system mode, releasing the  [FEED] button performs an 
auto sensor adjustment and measurement of the label length. 
For the details of the sensor adjustment, refer to the Owner’s Manual. 
6.5 DIAGNOSTIC TEST PRINT/DUMP MODE 
When the STATUS lamp lights in green during the...

 
 
 
 
 
 
 
 
 
E PRINTED IN JAPAN
EO18-33025