Toshiba Strata Xii, Strata Xx General Description Manual

OPERATING PROCEDURES 
SECrrlON 100-020-400 
JANUARY 1984 
has already received or originated another 
call. Your request is 
will be called again 
station becomes idle. 
02.16.0 Call Holding 
- 02.16.1 To hold a call: not cancelled. You 
the next time the 
1) While connected to an. outside call, depress 
the m key. 1) While connected to the outside line, depress 
the I] key. 
l The CO line LED will flash at the l-hold l The CO line LED will flash at the con- 
rate. ference rate. 
02.16.2 To release a...

OPERATING PROCEDURES 
SECTION 100-020-400 
JANUARY 1984 
4) 
Speak at a normal voice level in the direction 
of telephone. . Line does not appear on your EKT. 
1) You 
will hear a single long tone, followed by 
an announcement. 
l The INT LED will flash at the l-called rate. 
2) Lift the handset to acknowledge the announce- 
ment (you cannot receive a call on a non- 
appearing line unless you are off-hook). 
l Call will be transferred when the announcer 
goes on-hook. 
@The INT LED will flash at the...

OPERATING PROCEDURES 
SECTION 100-020-400 
JANUARY 1984 
station can access the connection (thereby 
disconnecting you) by using the Call Pick-up 
feature. 
4) 
Speak at a normal voice level in the direction 
of telephone. 
- 5) Depress the m key when the call is com- 
pleted (if you depressed the ( key earlier). c) Depress the bx1 key after the party 
answers.* *- 
l CO LEDs will flash at the l-use rate and : 
all parties will be conferenced. 
I 
“If you receive a busy tone or no answer, 
return to the...

3) Depress one of the m keys or dial a 2-digit 
address code (codes run consecutively from 
10 through 29 or 49, depending upon the type 
and amount of optional memory provided; 
AD numbers reside at 10 ti 16). 
4) Dial the telephone number to be stored (16 
digits maximum).*** 
5) Depress the m key to record number in 
memory. 
6) Repeat the above steps with every number to 
be stored (up to 40). 
7) Return the handset to on-hook. 
8) Write down the address codes and telephone 
numbers for future...

OPERATING PROCEDURES 
SECTION 100-020-400 
JANUARY 1984 
02.23.4 
To respond to a DND override signal: 
1) Depress the m key. 
2) Speak to the override station. 
_ 02.23.5 To use executive override (program- 
mable option) 
: 
Overrides the CO line privacy feature, and is able 
to enter any existing conversation within the 
system. Only two stations can be programmed 
for this feature. 
1) You may enter any conversation on any 
CO/PBX line by simply depressing the 
appropriate key. 
l A warning tone,...

03.12?1, To transfer a CO line call (line appears 
on called. station) 
: 
1) Depress the number key corresponding to the 
station to be called. 
l The CO line will be placed on hold auto- 
matically and the CO LED will flash at 
the l-hold rate. 
2) You will hear a single ring tone.* 
3) Announce the call when the ring tone ends. 
4) Hang up when the announcement is completed. 
l You will be recalled after a specified period 
of time if the call is not picked-up. 
*NOTES: 
1. If you receive a busy or no...

OPERATING PROCEDURES 
SECTION 100-020-400 
JANUARY 1984 
Tone signailing over an EKT can be accom- 
plished by dialing 
q after the station num- 
ber. 
04.11.2 To receive an intercom call: 
_ 1) 
2) 
3) 
You will hear a ringing signal (1 second on-3 
seconds off). 
Lift the handset and speak to the caller. 
Hang up when the call is completed. 
04.12.0 Outside Calls 2) You will hear intercom dial tone. 
04.12.1 To make an outside call: 
1) Lift the-handset. 
2) 
You will hear intercom dial tone. 
3) 
Dial...

1) Establish a standard 2-station intercom call. 
2) Flash the hookswitch. 
l You will hear intercom dial tone. 
l The existing call will be on-hold., 
3) Dial the number of the desired station. 
4) Flash the hookswitch after the party answers.* 
l All parties will be conferenced. 
5) Repeat to add another station. (Four stations, 
including yours, is maximum.) 
6) Hang up when the call is completed. 
“The called party must come off-hook or 
depress the ( key. If you receive a busy 
tone or no answer,...