Steinberg Halion 3 Manual

Included Instruments
Trium 
121Trigger Mode
Defines the trigger behavior for new notes.
•Normal triggers a new note when the previous note gets stolen. The
sample and the envelope of the new note are triggered from the start.
To minimize discontinuities, use the Fade Out parameter of the zone.
•Resume does not always trigger a new note.
If the new note stays within the same zone, the envelope is retriggered, but
resumes at the level of the stolen note. The pitch of the zone is set to the
new note.
If the...

Included Instruments
Trium 
122Cutoff
Controls the modulation depth of the filter cutoff modulation.
Osc1/2/3 Wave
These parameters control the modulation depth of the waveform modulation of
the three main oscillators.
NOTE
These controls are only available if the selected oscillator type supports
waveform modulation.
Mod Wheel Settings
Vib Freq
Controls the frequency of the second LFO that is used for pitch modulation
(vibrato).
Vib Depth
Controls the depth of the pitch modulation (vibrato).
Cutoff...

Included Instruments
Trium 
123•HP24, 18, 12, and 6 are high-pass filters with 24, 18, 12, and 6 dB/oct.
Frequencies below the cutoff are attenuated.
•BR12 and BR24 are band-reject filters with 12 and 24 dB/oct. Frequencies
around the cutoff are attenuated.
•BR12+LP6 and BR12+LP12 are combinations of a band-reject filter with 12
 dB/oct and a low-pass filter with 6 and 12 dB/oct, respectively. Frequencies
around and above the cutoff are attenuated.
•BP12+BR12 is a band-pass filter with 12 dB/oct plus a...

Included Instruments
Trium 
124Filter Envelope Section
Attack
Controls the attack time of the filter envelope.
Decay
Controls the decay time of the filter envelope.
Sustain
Controls the sustain level of the filter envelope.
Release
Controls the release time of the filter envelope.
Amplifier Section
Level
Controls the overall volume of the sound.
Velocity
Controls the level modulation from velocity. At 0, all notes are played with the
same level.
Amplifier Envelope Section
Attack
Controls the attack time...

Included Instruments
Voltage 
125Arp Page
This page contains the same parameters as the FlexPhraser.
RELATED LINKS
FlexPhraser on page 76
Voltage
Voltage is a two-oscillator and noise synthesizer that can be used for synth basses, but it
also allows you to create any kind of classic monophonic and polyphonic synth sound. With
the integrated arpeggiator and step sequencer, you can create anything from sequencer lines
to stepped chords.
The two oscillators and the noise generator are followed by a 24 dB...

Included Instruments
Voltage 
126Oscillator Section
Oscillator 1/2 Waveform
Sets the waveform for the oscillator. You can choose between saw, triangle, and
square.
Oscillator 1/2 Level
Controls the level of the oscillators.
PWM
PWM (pulse width modulation) is only available for the square waveform. Activate
this option if you want to be able to let the LFO modulate the width of the wave.
Osc 2 Coarse
Detunes the second oscillator by +/-12 semitones.
Osc 2 Fine
Detunes the second oscillator by +/- 100...

Included Instruments
Voltage 
127Distortion
Adds tube-like distortion to the signal.
Envelope Amount
Controls the cutoff modulation from the filter envelope.
Cutoff Velocity
Controls the cutoff modulation from velocity.
Cutoff Key Follow
Adjusts the cutoff modulation using the note number. Increase this parameter
to raise the cutoff with higher notes. At 100 %, the cutoff follows the played pitch
exactly.
Amplifier Section
Level
Controls the overall volume of the sound.
Velocity
Controls the level...

Included Instruments
Voltage 
128Glide
Allows you to bend the pitch between notes that follow each other. You achieve
the best results in Mono mode.
Fingered
Activate this parameter to glide the pitch only between notes that are played
legato.
Mono
Activates monophonic playback.
Retrigger
This option is only available in Mono mode. If Retrigger is activated, a note that
was stolen by another note is retriggered if you still hold the stolen note when
you release the new one.
This way, you can play trills...

Included Instruments
Voltage 
129LFO Section
Freq
Controls the frequency of the modulation, that is, the speed of the LFO.
Sync
If Sync is activated, the frequency is set in fractions of beats.
Cutoff
Controls the modulation depth of the filter cutoff modulation.
Pitch
Controls the modulation depth of the pitch modulation.
PWM
Controls the modulation depth of the pulse width modulation of the square
oscillators.
Mod Wheel Section
Vib Freq
Controls the frequency of the second LFO that is used for pitch...

Included Instruments
Voltage 
130Filter Envelope Section
Attack
Controls the attack time of the filter envelope.
Decay
Controls the decay time of the filter envelope.
Sustain
Controls the sustain level of the filter envelope.
Release
Controls the release time of the filter envelope.
Amp Envelope Section
Attack
Controls the attack time of the amplifier envelope.
Decay
Controls the decay time of the amplifier envelope.
Sustain
Controls the sustain level of the amplifier envelope.
Release
Controls the...