Sony Projector Vpl Hs3 User Manual

31 GB Menu Lists
Using the Menus
Note
For input signals from the HDMI connector, “Dot Phase,” “H 
size” and “Shift” are not adjustable.
SET SETTING MENU SETTING
V  Position Adjusts the vertical position of the picture 
in wide screen mode. As the setting 
increases, the picture moves up. As the 
setting decreases, the picture moves 
down. 
Note
This item is adjustable only when “Zoom” or 
“Subtitle” is selected
, or when “Full Through” 
or “Normal Through” is selected for video 
(50Hz) or progressive...

GB 32Menu Lists
Using the Menus
INSTALL SETTING
INFORMATIONThis projector has 34 types of preset data for input 
signals (the preset memory). When the preset signal is 
input, the projector automatically detects the signal 
type and recalls the data for the signal from the preset 
memory to adjust it to an optimum picture. The 
memory number and signal type of that signal are 
displayed in the INFORMATION menu. 
You can also adjust the preset data through the INPUT 
SETTING menu.
This projector also has...

33 GB Menu Lists
Using the Menus
You can automatically adjust to obtain the clearest 
picture when projecting a signal from the computer.
1 Project a still picture from the computer.
2 Press the APA (Auto Pixel Alignment) 
button.
When the picture is adjusted properly, “complete!” 
appears on the screen.
Notes
 When “Smart APA” is set to “On,” the APA function is 
automatically activated.
 Press the APA button when the image appears on the whole 
display area of the computer. If there are black edges...

GB 34Troubleshooting
Others
Troubleshooting
Power
The power is not 
turned on.cWait for about one minute 
before turning on the power.
 (1 page 24)
cClose the lamp cover securely.  
(1 page 36)
cClose the air filter cover 
securely.  (1 page 38)
This section describes how to solve the 
problems, how to replace a lamp and air 
filter, etc.
Picture
No picture.cCheck that the proper 
connections have been made. 
 (1 page 9)
cSelect the input source correctly 
using the INPUT button. 
 (1 page 23)
cSet the...

Others
35 GB Troubleshooting
Indicators
The LAMP/COVER or TEMP/FAN indicator on the 
control panel lights up or flashes if there is any trouble 
with your projector.
Warning Messages
Use the list below to check the meaning of the 
messages displayed on the screen.
Caution Messages
Use the list below to check the meaning of the 
messages displayed on the screen.
Sound
No sound.cCheck that connecting cables are 
properly connected. (1 page 9)
cAdjust “Volume” in the 
PICTURE SETTING   menu 
(1 page 29), or...

Others
GB 36Replacing the Lamp
The lamp used for the light source has a certain life. 
When the lamp dims, the color balance of the picture 
becomes strange, or “Please replace the LAMP.” 
appears on the screen, the lamp is exhausted. Replace 
the lamp with a new one (not supplied).
Use LMP-H150 Projector Lamp as the replacement lamp.
When replacing the lamp after using the 
projector
Turn off the projector, then unplug the power cord. 
Wait for at least an hour for the lamp to cool 
completely.
Caution...

Others
37 GB Replacing the Lamp
6 While pushing the projector cover toward 
you by holding both sides of the cover on 
the lens side, close the cover until it clicks.
7 Connect the power cord and set the 
projector to standby mode.
8 Press the following buttons on the remote 
control in the following order for less than 
five seconds each: RESET, 

Others
GB 38Replacing the Air Filter
The air filter should be replaced periodically. When 
“Please replace the filter.” appears on the screen, 
replace the air filter immediately. 
Notes
 Replacing the air filter is very important to maintain the high 
efficiency of the projector and to prevent a malfunction. When 
the replacement message appears on the screen, replace the air 
filter without delay.
 When removing the air filter from the projector, be careful that 
no dust or object gets into the...

Others
39 GB Specifications
System
Projection system
3 LCD panels, 1 lens, projection 
system
LCD panel 0.62-inch TFT LCD panel, 1,245,816 
pixels (415,272 pixels × 3)
Lens 1.2 times zoom lens (manual) 
f15.7–20mm/F.2.0–2.3
Lamp 150 W UHP type
Projection picture size
Range: 40 to 150 inches (measured 
diagonally)
Color system NTSC
3.58/PAL/SECAM/NTSC4.43/
PAL-M/PAL-N system, switched 
automatically/manually
Acceptable video signals
15 kHz RGB/component 50/60 Hz, 
Progressive component 50/60 Hz, 
DTV...

Others
GB 40Specifications
Optional accessories
Signal interface unit IFU-HS1
Projector Lamp LMP-H150 (for replacement)
Air filter PK-HS1FL (for replacement)
Signal interface cables SIC-HS10/SIC-HS20/SIC-HS30
Projector Stand SU-HS2
Safety regulations 
UL60950, CSA No. 950, FCC class B, IC class B, 
EN60950 (NEMCO), CE, C-Tick, CCC
Projection Distances for a 1080i/720p 
format signal and computer’s signal
When projecting using “Side Shot” 
adjustment only
For a 1080i format signal
Unit: m (feet)
For a...