Smeg St337 Instruction Manual

 
 
User instructions   
 
 29 
        ADJUSTING THE UPPER BASKET 
The  height  of  the  top  basket  can  be  adjusted  to  all ow  large  dishes  or 
pans to be placed in the bottom basket.  
The  adjustment  procedure  may  be  type  A  or  B,  depending  on  the 
dishwasher model purchased. 
           Version A: pull-out with adjustment in two positions. 
·   Pull out both the basket guides. 
·   Remove the stops, first releasing them as shown in  the diagram. 
·   Pull out the basket. 
·   Fit...

 
 
User instructions   
  
30 
3.  Cleaning and maintenance  
 
Before carrying out any work, always unplug the app liance from the 
electrical supply or switch off the all-pole disconnection device. 
 
3.1  General warnings and recommendations   Avoid the use of acidic or abrasive detergents.  Clean  the  outer  surfaces  and  door-lining  of  the  dis hwasher  regularly 
using  a  soft  cloth  moistened  with  water  or  with  a  n ormal  detergent 
suitable  for  painted  surfaces.  Clean  the  door...

 
 
User instructions   
 
 31   CLEANING THE FILTER UNIT  ·  It  is  advisable  to  periodically  inspect  the  centre   filter C and,  if 
necessary,  to  clean  it.  To  remove  the  filter,  grip  the  tabs,  turn  them  
anticlockwise and lift upwards; 
·   push  the  centre  filter  D from  the  underside  to  remove  it  from  the 
micro-filter: 
·   separate  the  two  parts  which  make  up  the  plastic  f ilter  by  pressing 
the body of the filter in the zone shown by the arr ows; 
·   remove...

 
 
User instructions   
  
32  
  
 
BEFORE  STARTING  THE  DISHWASHER  AFTER  PROLONGED 
DISUSE: 
 
·  Check  that  there  are  no  deposits  of  sludge  or  rust  inside  the  water 
pipe: if there are, allow the water to run from the water supply tap for 
a few minutes. 
·  Plug the power cord  back into the socket. 
·  Reconnect the water intake hose and open the tap ag ain. 
 
 
 
TROUBLESHOOTING MINOR PROBLEMS 
 
In some cases it is possible to remedy minor problems by referring to the 
following...

 
 
User instructions   
 
 33  
  
 
If the dishes fail to dry or remain dull, check tha t: 
 
·  there is rinse aid inside the special container; 
·  the rinse aid dispenser setting is correct; 
·  the  detergent  used  is  of  good  quality  and  has  not  l ost  its 
effectiveness  (for  example,  through  incorrect  storage,  with  the  box 
left open). 
 
If the dishes show signs of streaking, staining, et c., check that: 
 
·  the rinse aid dispenser setting is not too high. 
 
If there are...

 
 
User instructions   
  
34 
4.  Troubleshooting 
 
  The  dishwasher  is  able  to  indicate  a  series  of 
malfunctions  by 
illuminating  a  number  of  lights  simultaneously  (see   key  below); “E”  or 
“Err”  (depending on the model) also appears on the displa y in the event 
of a malfunction.
 
 
FAULT DESCRIPTION 
E1  
Acquastop failure 
The  anti-flooding  system  has  been  activated  (for  th e 
relevant  models  only).  The  system  is  tripped  in  case 
of water leaks. Contact the...

 
 
User instructions   
 
 35 
 
FAULT DESCRIPTION 
E7  
Turbine flow-regulator malfunction  
(for the relevant models only)  
The appliance is not able to measure the amount 
of  water  loaded  accurately.  Interrupt  the  program 
and  switch  off  the  dishwasher.  Switch  the 
dishwasher  back  on,  program  it  again  and  start 
the  washing cycle.  If  the  problem  persists, contact  
the after-sales service. 
E8  
Alternate washing system malfunction 
Interrupt  the  program  and  switch  off...

 
 
User instructions   
  
36 
  
TECHNICAL DATA  
Width 597 ¸ 599 mm 
Depth measured flush with the  outer edge of the control panel 550 mm 
Height (depending on models) from 820 mm to 890 mm from 860 mm to 930 mm 
Capacity 14 Standard place settings 
Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) 
Electrical characteristics See rating plate