Smeg St337 Instruction Manual

 
 
User instructions   
 
 9 
NOTES AND REFERENCES  Only  run the soak program with half loads.  Options  cannot be used with the soak program. 
* Standard programme under EN 50242. 
**  See information sheet provided 
***  For 3 digit models, see display. 
**** IEC/DIN reference programme. 
***** Reference program for laboratories: Detergent: 
20g in the  dispenser  + 10g  in the 
door  or tablet.  Configuration : see photo in “Using the baskets”. 
(1) Program  consumption  and  duration  figures  have...

 
 
User instructions   
  
10    
                      
1.2  Washing programs   
  
 Before starting a washing program make sure that:  
·  The water supply tap is  open. 
·  The softener  container contains regenerating salt . 
·  The  correct amount of detergent  has been added to the 
dispenser. 
·  The baskets have been  correctly loaded. 
·  The  spray  arms  are  able  to  rotate  freely  and  without 
obstruction. 
·  The dishwasher door is securely closed.     
  
 OPTION SELECTION 
Options are...

 
 
User instructions   
 
 11 
 
QUICK TIME OPTION  Select  this  option  together  with  any  washing  progra m  (except  the  soak 
program)  to  SHORTEN the  cycle
.  To  activate  this  option,  press  button  
(light comes on) after selecting the program requir ed. 
The option is automatically deactivated at the end  of the program.
  
 
Flexi Tabs 
Press  buttons 6  +  8  (QUICK  TIME  PROGRAMS   button  + ENERSAVE  
option  button)   simultaneously  to  activate  the Flexi  Tabs  option;  the...

 
 
User instructions   
  
12  
 
SPREAD HALF LOAD 
Suitable  when  there  are not many  dishes  to  be  washe d,  it saves  energy 
and  reduces  the  program  duration.    Place  dishes  in  both  baskets  then 
load  the  detergent  dispenser  than  less than  the nor mal  amount  for a  full 
load.
  
 
DELAYED START  The  start  of  the  washing  program  can  be  delayed  to  program  the 
dishwasher to operate at the preferred time of day  (e.g. overnight).  Press 
the  PROGRAM DELAY  button to...

 
 
User instructions   
 
 13   
  
 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT  
·  Always try to run the dishwasher  fully loaded. 
·  Do not wash the dishes in running water. 
·  Use  the  washing  program  that  is  most  appropriate  for  each  type  of 
load. 
·  Do not carry out any preliminary rinsing. 
·  If available, connect the dishwasher to a hot water  supply up to 60°C. 
TO  CUT  DOWN  ON  DETERGENT  CONSUMPTION!  …  AND  PROTECT  
THE ENVIRONMENT  The  phosphates  contained  in...

 
 
User instructions   
  
14               
2.  Operating instructions      
Once  the  dishwasher  has  been  correctly  installed,  p repare  for  use  as 
follows: 
 ·   Adjust the water softening system; 
·   Add the regenerating salt; 
·   Add the rinse aid and detergent. 
   
2.1  Using the water softening system  
 
     The  amount  of  scale  contained  in  the 
water  (water  hardness  index)  can  cause  
whitish  staining  on  the  dry  dishes,  which  
tend  to  become  dull  over  time....

 
 
User instructions   
 
 15    
 
  
 
·  Do  not  use  table  salt   as  it  contains  insoluble  substances  which, 
over time, may damage the water softening system.  
·  When  necessary,  refill  the  regenerating  salt  contai ner before 
starting  the  washing  program .  In  this  way,  the  excess  saline 
solution  will  be  immediately  removed  by  the  water;  the  prolonged 
presence of salt water inside the tank may lead to corrosion.   
 
 Be  careful  not  to  confuse  the  salt  and...

 
 
User instructions   
  
16    
WATER HARDNESS TABLE  WATER HARDNESS 
SETTING German degrees (°dH) French Degrees (°dF) 
0 - 4 0 - 7 All lights off (no salt)  
5 - 15 8 - 25 One light on  
16 - 23 26 - 40 Two lights on  
24 - 31 41 - 60 Three lights on  
32 - 47 61 - 80 Four lights on  
48 - 58 81 - 100 Five lights on     Contact  your  local  water  board  for  information  on  the  hardness  of  your 
water supply. 
 
  After adjustment or display of the current setting , simply do not touch the...

 
 
User instructions   
 
 17 
 
 
ADDING THE RINSE AID  The  rinse  aid  helps  the  dishes  dry  faster  and  
prevents  the  formation  of  scale  deposits  and  
staining;  it  is  automatically  added  to  the  water 
during  the  final  rinse  cycle,  from  the  container 
situated on the inner side of the door.   
 
To add rinse aid:  ·  Open the door. 
·   Rotate the container cap anticlockwise by ¼ of a t urn and remove it. 
·   Add  the  rinse  aid  until  the  container  is  full  (app...

 
 
User instructions   
  
18 
 ADDING THE DETERGENT  To  open  the  detergent  dispenser  cap,  lightly  press  
the  button  P.  Add  the  detergent  and  close  the  cap 
carefully.  
During  the  washing  cycle,  the  dispenser  will  be 
opened automatically. 
 
       
  
 ·   When  a  program  with  hot  prewash  is  selected  (see  pr ogram  table), 
extra  detergent  must  be  placed  in  the  cavity G/H  (depending  on 
models). 
·  Use  only detergents specially formulated for dishwashers. F...