Smeg Sca7123 Manual

33
Instructions for the user
Removing the internal glass:
 Remove the internal glass pane
by pulling it towards you,
following the movement
indicated by the arrows. Doing
this dislodges the 4 pins
attached to the glass from their
slots in the oven door 
Removing the middle glass
panes:
 Multifunction models have a
single middle pane. Remove the
middle pane by lifting it upwards 
Cleaning:
 Now it is possible to clean the
external glass and the panes
removed previously. Use
absorbent kitchen roll paper....

34
Instructions for the user
10.5 What to do if.
The oven display is full 
off  Check the mains power supply.

upstream from the oven feed line is in the
“ON” position.
The oven does not 
heat up Check whether the “showroom” mode has
been set, for further details see paragraph
“Secondary menu” at page 19.
The controls do not 
respond. Check whether the “child lock-out function”
mode has been set, for further details see
paragraph “Secondary menu” at page 19.
The cooking times are 
longer than those...

35
Instructions for the installer
11. INSTALLING THE APPLIANCE
11.1 Electrical connection
The I.D. plate with technical data, registration number and brand name is
positioned visibly on the oven door frame.
The plate must not be removed. 
The appliance must be connected to earth in compliance with electrical
system safety regulations. 
If a fixed connection is being used fit power line with an omnipolar circuit
breaker with a contact opening gap equal to or greater than 3 mm, in an
easily accessible...

36
Instructions for the installer
11.2 Positioning the oven 
The oven is designed for mounting into any piece of furniture as long as it
is heat-resistant. Proceed acording to the dimensions shown in Figures 1,
2 and 3. For installing under a work top, follow the dimensions given in
Figure 1-3. When installing under worktops incorporating combined hobs,
a gap of at least 110 mm must be left from any side wall, as shown in
figure  1.
When installing in tall units, comply with the dimensions shown in...

37
Instructions for the installer
It is recommended to install the oven with the help of a second person.
WARNING: When the oven has been extracted from the packing base,
avoid resting the product on the ground as this could cause deformation of
the drip trays. If necessary during handling, replace the oven in the
packing base.