Smeg Sac399x8 Manual

Instructions for the user
43
Removing the internal glass panel:
•  Remove the internal glass panel by
pulling the rear part gently upwards,
following the movement indicated by the
arrows (1).
•  Then pull the front of the glass panel
upwards (2).
•  Doing this detaches the 4 pins attached to
the glass from their slots in the oven door.
Removing the middle glass panels:
(pyrolytic models)
•  There are two middle glass panels in
pyrolytic models, attached using 4 small
locks. Remove the middle panels by...

Instructions for the installer
44
12. INSTALLING THE APPLIANCE
12.1 Electrical connection
The identification plate bearing the technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason. 
The appliance must be connected to earth in compliance with electrical system
safety regulations. 
If the appliance is connected to the power supply network by means of a fixed
connection, install a multipolar cut-out device on the power supply line, in...

Instructions for the installer
45
12.2 Cable replacement
Should the supply cable need replacing,
remove the back guard by unscrewing the
screws to gain access to the terminal.
Replace the cable. The cable cross-
section must be no less than 1.5 mm² (3 x
1.5).
Make sure that the cables (for the oven or
any hob) follow the best route in order to
avoid any contact with the oven.
WARNING: The tightening torque of the screws of the terminal supply wires
must be 1.5 - 2 Nm. 

Instructions for the installer
46
12.3 Inserting the fastening bushings
To fasten the appliance
correctly to the unit, insert the
bushings provided onto the
front (as shown in the figure).
Once the appliance is in place,
fasten it to the unit using the
screws. The bushing enables
the screw to be angled by
approximately 30°.
After fastening the appliance,
cover the bushing with the caps
provided. 

Instructions for the installer
47
12.4 Positioning the oven
Never use the oven door to lever the oven into place when fitting. Avoid exerting
too much pressure on the oven door when open.
It is recommended to install the oven with the help of a second person.
The base on which the oven is resting must be complete as shown in the
illustrations below.
The oven is designed for
mounting into any piece of
furniture as long as it is heat-
resistant. The adjacent figure
shows the indicative overall
dimensions...

Instructions for the installer
4812.4.1 Positioning under a work top
         
12.4.2 Installing in tall units
                   
583-585
490-500
560 60
35-40
583-585
560
914775219/ A