Singer Serger Professional 5 Manual

 
   
   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
   
Three-Thread Overedge (wide with decorative thread) 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Three-Thread Overlock (wide-decorative) page 1 
Using decorative threads can duplicate the  look of fine braids and bindings often 
found only in ready-to-wear.  It is easy to  embellish sewing projects with decorative 
thread.  Threads such as texturized nylon  thread, crochet thread, pearl cotton, yarn 
and more easily slide through the eye of the l ooper.  Select...

 
 
ATD: 
Auto Tension Dial  
            “B” 
Left Cover Stitch 
Needle “C” Unthreaded and 
Remove Needle 
Middle Cover Stitch 
Needle “D” Unthreaded and 
Remove Needle   
Right Cover Stitch 
Needle “E” Unthreaded and 
Remove Needle 
Overedge Left  
Needle “A” (Orange)       Threaded 
Overedge Right  
Needle “B”  Unthreaded and 
Remove Needle 
Upper Looper 
(Green)  Looper Engaged 
and Threaded 
Lower Looper 
(Red)    Threaded 
Chain Stitch Looper  
(Brown)    Unthreaded  
Upper Knife     Engaged 
Seam...

 
  5. Turn the handwheel toward you until the lower looper extends 5-10mm  
       (approximately ½ inch ) from the needle plate edge.  
 
 
 
  6. Thread the looper area of the ma chine following the green color coded  
       thread guides 4-9. 
 
 
 
 
 
 
 
 
 
 
 
 
 
  
  
  7. Thread the hole in the U pper Looper from front to back k.  Pull about 4  
                 inches of thread through the loope r and place to the back of the  
                 throat plate....

 
 
  6. Thread the looper area of the mach ine following the red color coded  
       thread guides 4-10.  
 
  7. Place the thread slighty from left and  
      to the ri ght of threading guide  f. 
 
  8. Place the thread slightly from the  
               fr ont and to the back of threading 
               guide  g. 
 
  9. Place the thread through  h, i ,and  j. 
 
 
  
 
 
  10. Thread the looper eye (A) from front  to back.  Pull about 4 inches of thread. 
                 Position thread into V...

 
 Three-Thread Overlock (wide-decorative) page 8 
 
   
  
 
  5. Continue to thread point s 4-8.  Slip the thread into the middle slot of the  
      thread guide  g.  Go over the take up lever  h.  Continue by slipping the  
               thread into the middle  slot of the thread guides i and  j.  
 
  6. Before threading the eye of the needl e, make sure the thread is behind
   
               the thread guide located on the  bottom of the needle clamp. 
 
 
 
 
 
 
 
 
 
 
 
 
 
    
 
 
 
 
  7....

 
   
  
  
                   
 
                                   
Chapter 5: 
           Three-Thread Flatlock            
               (narrow and wide)