Sharp Xg E3000u Projector User Manual

E-31
Air Filter Maintenance
nThe air filter should be cleaned every 100 hours of use. Clean the
filter more often when the projector is used in a dusty or smoky
location.
nHave your nearest Authorized Sharp Industrial LCD Products Dealer
or Service Center exchange the filter  (PFILD0058CEZZ) when it is
no longer possible to clean it.
Cleaning and Replacing the Filter
46
Insert the tab on the end of
the filter cover into the filter
cover opening and press the
filter cover into position. Place the filter...

E-32
Lamp/Maintenance Indicators
Lamp
nThe Lamp has a finite operating life of 1,500 hours. The lamp life may differ, however, depending on the usage environment.
¥ When the lamp is nearing the end of its operating life, the picture and color quality will deteriorate. When the projector is
turned on after the lamp has been in use for more than 1,400 hours, the LAMP REPLACEMENT indicator will light red and
ÒLAMPÓ will flash in yellow on the screen to alert you that it is time to replace the lamp. At this...

E-33
Connection Pin Assignments
Analog RGB 1 Signal Input and Analog RGB 1 and 2 Output Terminal : 15-pin mini D-sub female connector
Computer Input
Analog
1. Video input (red)
2. Video input (green)
3. Video input (blue)
4. Reserve input 1
5. Composite sync (Mac only)
6. Earth (red)
7. Earth (green)
1
155
6
11 10
 8. Earth (blue)
 9. Not connected
10. GND
11. GND
12. Reserve input 2
13. Horizontal sync signal
14. Vertical sync signal
15. Reserve input 3
Analog RGB 2 Signal Input : 5 BNC
Computer Input...

E-34
1. PC control
The personal computer can be used to control the projector by connecting the two via an RS-232C cable (cross
type) (not supplied).
2. Communication conditions
Set the serial port settings of the computer to match that of the table below.
Signal format: Conforms to RS-232C standard.
Baud rate: 9,600 bps
Data length: 8 bits
Parity bit: NON
Stop bit: 1 bit
Flow control: None
3. Basic format
Commands from the computer are sent in the following order: command, parameter, and return code....

E-35
Examples:
For the RGB/VIDEO setting, select video and set the PAL mode.
Computer
®
¬
O     K     
  I      V      E      D     
Ñ     Ñ    Ñ     1     
®
¬
O     K      
 M     E      S      Y     
Ñ     Ñ    Ñ     2      
Switch to video screen
Set to PAL mode Unit
When BRIGHT of VIDEO IMAGE ADJUSTMENT is set to -10.
®
¬
O     K      
 V      A      B      R     
Ñ    Ñ     1 
     0      
Notes:
¥ RGB INPUT ADJUSTMENT can only be set in the displayed computer mode.
¥ The Ò130 ;`30Ó values for Lens...

E-36
Wired Remote Control Terminal Specifications
1. Specifications of wired remote control input
¥ 4.4¿ minijack
¥ External: +5V (1A)
¥ Internal: GND
2. Function and transmission codes
VOLUME UP
VOLUME DOWN
POWER ON 
POWER OFF
CURSOR UP
CURSOR DOWN
ADJUST UP
ADJUST DOWN
MUTE
MENU
VIDEO 1
VIDEO 2
RGB1
RGB 2
ENTER
LENS SELECT
CHANNEL CALL
BLACK SCREEN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
181
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1 C1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0 C2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1...

E-37
Specifications are subject to change without notice.
Specifications
Product Type
Model
Video system
Display method
LCD panel
Lens
Projection lamp
Contrast ratio
Video input signal
S-video input signal
Video (monitor) output signal
Horizontal resolution
Audio output
Computer RGB input signal
RS-232C input terminal
Mouse input terminal (for IBM/Mac)
Mouse input terminal (for PC98)
Speaker system
Rated voltage
Rated frequency
Power consumption
Operating temperature
Storage temperature
Cabinet
I/R...

E-38
3.7(95)
11.7(296)ø1.8(ø45) 3.5(89)
1.8(46)
8.2(208)
0.2(6) ø4.7(ø120)
4.8(121.1)
3.8(96.9)
0.2(4)
13.2(335)
14.8(377)
23.0(585)
6.5(165.5)
7.0(176.8)
14.0(355)
Dimensions
[Units: inches (mm)]
Rear View
Top View
Side View
Bottom ViewFront View
(Lens extended)
(Lens housed)
(Lens at upper shift)
(Lens at lower shift)