Sharp Mx2310u User Guide

1-60
BEFORE USING THE MACHINE
Contents
9
Replace the cleaning tool.
(1) Rotate the cleaning instrument after putting 
it on the boss and hook its edge (the side 
where the cleaner is fixed) to the claw on 
the left side.
(2) Place the right-hand side of the cleaning 
instrument on the front side, spread across 
the top of the claw.
(3) Hook the cleaning instrument to the claw.
10
Close the front cover.
(1)
Boss
(2)
(3) 

1-61
BEFORE USING THE MACHINE
Contents
REPLACING THE TONER CARTRIDGES
Be sure to replace the toner cartridge when the message Change the toner cartridge. appears.
In copy mode
 If any one of the toner colours runs out (including black toner), colour printing will not be possible. If Y, M, or C toner runs 
out but Bk toner remains, black and white printing will still be possible.
 Be sure to install 4 toner cartridges (Y/M/C/Bk).
OK
Change the toner cartridge.
(       )
Ready to scan for copy.
(...

1-62
BEFORE USING THE MACHINE
Contents
1
Open the front cover.
Locations of colour toner cartridges
(A): Yellow (B): Magenta
(C): Cyan (D): Black
2
Pull the toner cartridge toward you.
Gently pull the toner cartridge horizontally toward you.
If the cartridge is pulled out abruptly, toner may spill out.
Example: Replacing the yellow toner cartridge
Hold the toner cartridge with both hands as shown and pull it 
out of the machine.
3
Remove a new toner cartridge from its 
package and shake it horizontally...

1-63
BEFORE USING THE MACHINE
Contents
5
Push the cartridge in until it locks 
securely in place.
Push the cartridge firmly in until it clicks into place.
6
Close the front cover.
After the toner cartridge is replaced, the machine automatically 
enters image adjustment mode.
Caution
Do not throw a toner cartridge into a fire. Toner may fly and cause burns.
Store toner cartridges out of the reach of small children.
If a toner cartridge is stored on end, the toner may harden and become unusable. Always...

1-64
BEFORE USING THE MACHINE
Contents
REPLACING THE WASTE TONER BOX
The waste toner box collects excess toner that is produced during printing. When the waste toner box becomes full, 
Replace used toner container. will appear. Follow the procedure below to replace the waste toner box.
1
Open the front cover.
2
Release the used waste toner box.
Move the lock of the waste toner box to the release position.
Release the lock of the waste toner box and let it fall forward as 
far as it will go as shown in...

1-65
BEFORE USING THE MACHINE
Contents
4
Place the box on a flat surface.
Place a sheet of newspaper on the surface before placing the 
box.
 Do not point the holes down as used toner will spill out.
 Do not discard the removed waste toner box. Store it in a plastic bag. The person in charge shall collect it for 
maintenance.
5
Install the new waste toner box.
Insert the box from above at a slant. (The direction opposite to 
when you removed it.)
6
Push the waste toner box into the 
machine.
Push the...

1-66
BEFORE USING THE MACHINE
Contents
REPLACING THE STAMP CARTRIDGE
If a stamp unit (AR-SU1) is installed on the automatic document feeder and the stamp has become faint, replace the 
stamp cartridge (AR-SV1).
Supplies
Stamp cartridge (2 in package) AR-SV1
1
Open the document feeder tray
2
Remove the stamp cartridge while 
pushing it downwards
3
Install a new stamp cartridge.
4
Close the document feeder tray. 

1-67
BEFORE USING THE MACHINE
Contents
This section explains the text entry screen.
FUNCTIONS OF THE MAIN KEYS
ENTERING TEXT
KeyDescription
 This changes the text entry screen from the lower case screen to the upper case screen. The upper case 
screen will continue to appear until the [Caps] key is touched again so that it is no longer highlighted. The 
[Caps] key is convenient when you wish to enter all capital letters.
 (This key will vary depending on your 
country or region.)
This key temporarily...

1-68
BEFORE USING THE MACHINE
Contents
Shows explanations of each key.
Use this to enter a previously stored text string such as .com.
Text strings are stored in the system settings.
☞7. SYSTEM SETTINGS Soft Keyboard Template Setting (page 7-66)
Touch this key to return to the previous setting screen without entering text.
Touch this key to enter the text that currently appears and return to the previous setting screen.
Search results will appear based on the entered characters.
 Some keys described...

2-1
This chapter provides detailed explanations of the procedures for using the copy function.
BEFORE USING THE MACHINE AS A 
COPIER
BASE SCREEN OF COPY MODE . . . . . . . . . . . . . .  2-3
COPYING SEQUENCE  . . . . . . . . . . . . . . . . . . . . . .  2-6
ORIGINALS  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  2-9
 CHECKING THE ORIGINAL SIZE . . . . . . . . . . .  2-9
PAPER TRAYS . . . . . . . . . . . . . . . . . . . . . . . . . . . .  2-11
BASIC PROCEDURE FOR MAKING 
COPIES
MAKING...