Ricoh Mp 161 Service Manual
Here you can view all the pages of manual Ricoh Mp 161 Service Manual. The Ricoh manuals for Printer are available online for free. You can easily download all the documents as PDF.
Page 91
85 8. Remarks This chapter describes how to maintain and operate the machine. Where to Put Your Machine This section provides precautions for installation, movement and disposal. Machine Environment Choose your machines location carefully. Environmental conditions greatly affect its performance. Optimum Environmental Conditions The following describes precautions when locating the machine. R CAUTION: R CAUTION: R CAUTION: Temperature: 10-32 °C (50-89.6 °F) (humidity to be 54% at 32 °C, 89.6 °F) ...
Page 92
Remarks 86 8 Environments to Avoid Locations exposed to direct sunlight or other sources of strong light (more than 1,500 lux). Locations directly exposed to cool air from an air conditioner or heated air from a heat- er. (Sudden temperature changes can cause condensation to form inside the machine.) Locations close to machines generating ammonia, such as a diazo copy machine. Places where the machine will be subject to frequent strong vibration. Dusty areas. Areas with corrosive gases....
Page 93
Where to Put Your Machine 87 8 Power Connection The following describes power supply. R WARNING: R CAUTION: R CAUTION: R CAUTION: R CAUTION: Make sure the plug is inserted firmly in the wall outlet. Voltage must not fluctuate by more than 10%. The wall outlet shall be installed near the machine and shall be easily accessible. Connect the machine only to the power source described on the inside front cover of this manual. Connect the power cord directly into a wall outlet and do not use an...
Page 94
Remarks 88 8 Access to the Machine Place the machine near the power source, providing the clearance areas shown. 1.Rear: 6 cm (2.4) or more 2.Right: 1 cm (0.4) or more 3.Front: 75 cm (29.6) or more 4.Left: 1 cm (0.4) or more Note ❒For the required space when options are installed, contact your service repre- sentative. When Not Used for a Long Time R CAUTION: Note the following: If the machine has not been used recently, it requires time to initialize so can- not start printing immediately. Leave the...
Page 95
Maintaining Your Machine 89 8 Maintaining Your Machine If the exposure glass, exposure glass cover, ARDF belt is dirty, copy clarity may be reduced. Clean these parts if they are dirty. R CAUTION: Important ❒Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get inside the machine or melt plastic parts, a failure might occur. ❒Do not clean parts other than those explicitly specified in this manual. Other parts should only be cleaned by your service...
Page 96
Remarks 90 8 Cleaning the Exposure Glass Cover This section describes how to clean the exposure glass cover. Cleaning the ARDF This section describes how to clean the ARDF. Clean 1 and 2. ARK026S
Page 97
91 INDEX A Add Toner indicator, 3 Adjusting the screens contrast , 6 ARDF , 1, 90 ARDF belt is dirty , 89 Authentication failure , 6 B Basic, 15 C Changing a Paper Size in the Optional Paper Tray Unit (Tray 2) , 73 Changing the Paper Size , 70 Changing the Paper Size in the Paper Tray (Tray 1) , 70 Cleaning the machine , 89 Combination Chart , 9 Combine , 15 Copies appear dirty , 13 Copies are too light , 13 D Display is off, 6 Duplex , 15 E Edit, 15 End fence , 70,...
Page 98
92GB GB B262-7654 P Panel Tone, 4 Paper is not fed from selected tray , 46 Paper jam , 81 Paper orientation , 67 Parts of image not copied , 13 Password not correct , 6 Power Connection , 87 Power Failure Report , 35 Power indicator , 35 Power supply , 87 Precautions when locating the machine, 85 Precautions when moving the machine, 86 Printed image is different from computer display , 46 Printed image is faded , 46 Printed image is in wrong orientation , 46 Printer driver...
Page 99
Declaration of Conformity “The Product complies with the requirements of the EMC Directive 89/336/EEC and its amending di- rectives and the Low Voltage Directive 73/23/EEC and its amending directives.” In accordance with IEC 60417, this machine uses the following symbols for the main power switch: a means POWER ON. c means STAND BY. Trademarks Microsoft ®, Windows® and Windows NT® are registered trademarks of Microsoft Corporation in the United States and/or other countries. TrueType is registered...