Projectiondesign Evo2sx+ Projector User Manual
Here you can view all the pages of manual Projectiondesign Evo2sx+ Projector User Manual. The Projectiondesign manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 31
english 1 The projector may from time to time need cleaning. Never open the unit, as this will void any warranties. Refer service and repair to qualified personnel only. The projector is using lamps that have a limited life time. Please refer to the LAMP CHANGE section below for further details. Only the exterior of the unit may be cleaned. Use a damp cloth. Make sure no liquids enter the inside of the projector Vacuum clean all the air vents (A) regularly to maintain sufficient...
Page 32
english 2 The INDICATOR on the keypad will turn red when lamp life expires. Change the lamp when lifetime expires. Always replace lamp with the same type and rating. Always disconnect the power cord and wait until the projector has cooled down (60 minutes) before opening the lamp cover. WARNINGBe careful not to touch the protective glass when replacing the lamp house, this may cause the protective glass to overheat and break while in use. WARNINGBe...
Page 33
S TECHNICAL DATA Technical data shown are for the following versions : SX+, HD720-3 and HD720-2. Different specifications apply accordingly. Where HD720 only is referenced, data are valid for both -2 and -3 versions. Resolution1400 x 1050 (native) SXGA+, 4 : 3 aspect ratio1280 x 720 (native) HD720, 16 : 9 aspect ratio Display technologySingle chip DLP™ technology by Texas Instruments® Display deviceLVDS DMD™ with DarkChip™ technology Computer CompatibilityUXGA, SXGA+, SXGA, XGA, SVGA, VGA, PC, MAC, SGI...
Page 34
TECHNICAL DATA Power90-260 VAC, 50-60 Hz, 270W ConformanceCE, FCC B, CSA(C,US) CCC Temperature operating0-40°C / 32-104°F, 0-1500 m / 0-4950 ft0-35°C / 32-95°F, 1500-3000 m / 4950-9900 ft Temperature storage-20 - 60°C / -4 - 140°F Humidity operating20-90% RH, non-condensing Humidity storage10-95% RH, non-condensing
Page 35
CONNECTORS/STECKER/CONNECTEURS/CONECTADORES/CONNETTORI/KONTAKTER S-VideoG/YComputer DVIComputer VGARS-22RC inLAN PIN MINI DIN FEMALEPHONO/RCA FEMALEDVI-D1 HIGH DENSITY DSUB FEMALE PIN DSUB FEMALE,mm stereo mini jack RJ 1 GNDSTEM GREEN: G/Y1 TMDS Data 2-1 Analog R in1 NCTIP: 5V DC1TX+ 2 GNDSHIELD: GND2 TMDS Data 2+2 Analog G in2 RXDRING: SIGNAL2TX- 3 Luma3 TMDS Data 2/4 Shield3 Analog B in3 TXDSTEM: GND3RX+ 4 Chroma4 Not used4 AGND4 NC4GND 5 Not...
Page 36
english 0 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 m 0 3.30 6.60 9.90 13.20 16.50 19.80 23.10 26.40 29.70 33 .00 ft m 6.00 5.50 5.00 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0 ft 20.0 18.0 16.0 14.0 12.0 10.0 8.0 6.0 4.0 2.0 0 Projection distance Image width Screen diagonal 25.0 20.0 15.0 10.0 5.0 0 7.50 7.00 6.50 6.00 5.50 5.00 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0 Zoom lens 1.75 - 2.2 : 1 ftm 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0 15.0 12.5...
Page 37
english TECHNICAL DATA 0 1.00 2.00 3.00 4.00 5.00 6.00 7.00 8.00 9.00 10.00 m 0 3.30 6.60 9.90 13.20 16.50 19.80 23.10 26.40 29.70 33 .00 ft m 6.00 5.50 5.00 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0 ft 20.0 18.0 16.0 14.0 12.0 10.0 8.0 6.0 4.0 2.0 0 Projection distance Image width Screen diagonal 25.0 20.0 15.0 10.0 5.0 0 7.50 7.00 6.50 6.00 5.50 5.00 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0 Zoom lens 1.9 - 2.4 : 1 ftm 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50...
Page 38
english DECLARATIONS T FCC FCC regulations provide that changes or modifications not expressly approved by the party responsible manufacturer could void your authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation....
Page 40
userguide • benutzer handbuch • guide d’utilisateur • guía del usario • manuale d’uso • bruksanvisning *601-0082-01*