Panasonic Ventilating Fan Fv 07vql3 Installation Instructions

Ventilating fan
11
Installation 
   (Between joist mounting installation) continued
4.Insert the fan body between joists.
    Make sure the fan body is level and square (perpendicular) 
   with the joists.
   Keep the flange and joists on same level.
5. Secure the installation bracket III to ceiling joist using
    long screws (M4X30).
6. Secure the fan body to ceiling joists using long screws
    (M4X30) in horizontal direction with installation bracket
    I and IV.
III
CAUTION:
(Fig. 21) (Fig. 20)...

Installation 
   (Between joist mounting installation) continued
III
12
7. Secure installation bracket I and IV to the fan body using
    short screw I (M4X12) and short screw II (M4X10).
10. Finish ceiling work. Ceiling hole should be cut at the edge
      of the frame.
(Fig. 22)
Fig. 24
8. Slide the circular duct onto the adapter and secure with 
     tape.Remove the junction box cover and secure conduit 
    to junction box knockout hole.(7/8 inch)
    Refer to wiring diagram on page 6.
    Using wire...

Plug connector Plug connector
Installation 
   (Between joist mounting installation) continued
III
13
11.  Insert a spacer to metal plate of the fan case and
       three spacers to the light unit.
14. Insert the lamp cover to the grill and attach the grill
       to the fan unit.
(Fig. 25)
Fig. 25
Fig. 26
Fan case
Light unitSpacer
Long screws
Receptacle 
II
Plug connector 
III
Plug connector 
II
Receptacle 
III
(Fig. 27)
Night lamp
Spacer
Insert the fluoresceut lamps and screw the night lamp 
into the...

14
Installing the ventilating fan in an existing construction 
requires an accessible area (attic or crawl space) above 
the planned location or existing ducting and wiring.To install the ventilating fan, follow the procedures 
described in Installation I.
Inspect duct work and wiring before proceeding
with installation.
Plan suitable location for ventilating fan. (next to 
ceiling joist).
Before installation, provide inspection and maint-
enance access at a location that will not interfere
with...

15
Maintenance   (Cleaning)II
Disconnect power source before working on unit. Routine maintenance must be done every year.
1. Never use gasoline, benzene, thinner or any other similar chemicals for cleaning the grille and the
    ventilating fan.
2. Do not allow water to enter motor.
3. Do not expose plastic parts to temperature over 140  F (60  C).
Remove grille. (Squeeze mounting spring and pull down)Wash and clean grille. (Use non-abrasive kitchen
detergent)
Remove dust and dirt from fan body using a...

5770 Ambler Drive, Mississauga, ON L4W 2T3
www.panasonic.ca
16
Product service
The unit should be serviced by qualified technicians only. No service information is provided for customers. Your
product is designed and manufactured to ensure a minimum of maintenance. However, should your unit ever
require service, a nationwide system of factory service centers and AUTHORIZED INDEPENDENT SERVICE
CENTERS is maintained to support your products warranty.
(In the U. S.A., call 1-866-292-7292 to locate the...