Panasonic Sirius Satellite Radio Cr Srf100 Operating Instructions

CR-SRF100/CR-SRT10040
9. Diagrams & Installation
9.1. General System Diagrams
WITHOUT  FM  MODULATOR
17233_SGould  08/15/02  14:46  Page 40 

CR-SRF100/CR-SRT10041
WITH  FM  MODULATOR
WITHOUT CDU … WITH SIRIUS ENABLED RADIO HEAD UNIT
17233_SGould  08/15/02  14:46  Page 41 

42
9.2. General Connection Diagram
CR-SRF100/CR-SRT100
CDU Display
OR
f
CR-SRF100 
CL-SRA100 or equivalent
(sold separately)
M2C457\b18 W\fr\fng Harness
17233_SGould  08/15/02  14:46  Page 42 

CR-SRF100/CR-SRT10043
9.2. General Connection DiagramContinued
\f
\f !#$ 
% \f
\f
&
(
#) 

\f*

#



CR-S RT100 
CL-SRA100 or equivalent
(sold separately)
M2C457\b19 W\fr\fng Harness
17233_SGould  08/15/02  14:46  Page 43 

CR-SRF100/CR-SRT10044
9.3. Installation
POINTS:
• The receiver must be installed inside the vehicle…not in direct contact with the elements (e.g., rain, 
snow). It should be securely fastened to the vehicle. 
17233_SGould  08/15/02  14:46  Page 44 

CR-SRF100/CR-SRT10045 • The antenna should be installed on the vehicle’s roof with the 2 wires separating and going around 
the rear window before entering the vehicle and going to the receiver. The antenna is fastened to 
the roof top with self-adhesive tape located on the bottom of the antenna housing.
To obtain optimum adhesion, the bonding surface must be clean, dry and well unified. Typical surface
cleaning solvents are isopropyl alcohol/water mixture (rubbing alcohol) or heptane. However, if...

CR-SRF100/CR-SRT10046• The FM modulator should be mounted under the dash board…as close as possible to the 
existing radio / head unit.
• The Control Display Unit (CDU) should be installed at a convenient location on the dash board. 
It should be installed where it will not  cause driver distraction. It is mounted with “dual-lock 
fastening tape” (included in the kit). However, it should not be mounted where it will be exposed to 
direct and extended sun light (i.e., do not mount it on top of the dash...

CR-SRF100/CR-SRT10047 Your product is designed and manufactured to ensure the minimum of maintenance.  Use a soft cloth for
routine exterior cleaning. Never use benzine or other solvents.
Direct access channel 184 is provided by Sirius Satellite Radio to confirm proper installation of all the 
system components.
If the receiver acquires channel 184, the system is installed / working properly. If all components are
working as described in this manual, however you are experiencing difficulty with...

CR-SRF100/CR-SRT10048
3.  RECEIVER ERROR
If communication between the receiver and CDU stops for approximately 6-9 seconds, then a “RECEIVER
ERROR” message is displayed).
Action: Check the electrical harness between the CDU and the receiver.
4.  NO SUBSCRIPTION
If the CDU determines that there is no subscription to the Sirius service, then the message  “CALL 888-
539-SIRIUS TO SUBSCRIBE”  will scroll twice on the display.    Pressing any key will then cause the Sirius
ID to be displayed.   Further key...

CR-SRF100/CR-SRT10049
7. POWER UP AND HEARING STATIC ON SYSTEM WITH FM MODULATOR
If you power the SSR system up and are using an FM modulator and you only hear static, your radio  might
be on the wrong FM station. The radio must be on the same FM station that the SSR system is set to.
Action: Check that your radio is tuned to the correct FM frequency.
(Please see the section on the setup operation to view or change the required FM modulator frequency).
6. POWER UP AND HEARING AN  “OVER THE AIR” STATION …...