Panasonic Sirius Satellite Radio Cr Srf100 Operating Instructions

CR-SRF100/CR-SRT10030
7.5. Channel Mode
The channel mode provides user access to all available channels in sequential order.
(also called “all channels” mode)
ENTERING CHANNEL MODE
You enter channel mode by pressing the [CHANNEL]button. The system indicates entering channel mode by
illuminating the channel mode indicator located next to the channel button. No special message display occurs.
EXITING CHANNEL MODE
You exit channel mode by entering a different mode. There are several ways to do this …
•...

CR-SRF100/CR-SRT10031
7.6. Preset Mode
The Sirius satellite system has a preset mode that allows the user to change channels within custom stored
presets. The system has the ability to store up to eighteen presets (18 channel numbers assigned to buttons),
six individual presets in three groups.
ENTERING PRESET MODE
A user enters preset mode by pressing the[PRESET]button.
When you enter preset mode, the system indicates entering preset mode by illuminating the preset mode
indicator located next to the...

CR-SRF100/CR-SRT10032
EXITING FROM PRESET MODE
You exit preset mode by entering a different mode. There are several ways to do this …
• press the [CHANNEL]button to enter CHANNEL mode.
• press the [CATEGORY]button to enter CATEGORY mode.
• enter SETUP mode.
The system indicates exiting preset mode by turning off the preset mode indicator located next to the pre-
set button.
SELECTING GROUPS OF PRESETS
If the preset mode screen is being displayed, further presses of the [PRESET]button cycles through the...

CR-SRF100/CR-SRT10033
CHANNEL SELECTION WITHIN PRESET MODE
As the [SEL]knob is rotated, the system increments or decrements to the next preset.  It will scroll 
through all 18 preset channels (group 1 –  preset 1) through (group 3 – preset 6) starting from the current
preset group.
After reaching the end of the presets, further turning of the [SEL]knob will wrap abound the preset groups
such that if [SEL]is rotated:
• clockwise past (group 3 – preset 6) …  (group 1 – preset 1) will be selected.
•...

8. System Components & Specifications
There are 5 basic components to the system:
1. SSR Receiver
2. Antenna (Sold Separately)
3. Controller / Display Unit (Included in CR-SRF100)
4. FM Modulator (Included in CR-SRF100)
5. Receiver Wiring Harness
6. Installation Instructions Guide Supplied Hardware 
7. Mounting Screws for Receiver (4)
8. Dual-lock Fasteners for Control Display unit (2 sets)
CR-SRF100/CR-SRT10034
17233_SGould  08/15/02  14:46  Page 34 

CR-SRF100/CR-SRT10035
8.1. SSR Receiver … (CR-ZX0161Z)
SPECIFICATIONS:
• Operating Temperature Range: -40∞C to +85 ∞C
• Power Supply: 12VDC (9 – 16VDC), Negative Ground 
• Max RMS Current Consumption less than 2.0A   @  25 ∞C  14v
• Peak Current Consumption less than 2.5A   @  25 ∞C  14v
• Dimensions: 195mm(L)  x  141mm(W)  x  32mm(H)
• Weight: 1.1 kg 
• Frequency Range … S-Band: 2319.75MHz   to   2332.75MHz 
• Audio Output Level: 2 Vrms differential (1 Vrms single ended)
• Signal to Noise Ratio: -95db...

CR-SRF100/CR-SRT10036
8.2.Control Display Unit (CDU) …(CY-CX0160Z)
SPECIFICATIONS:
• Operating Temperature Range: -40∞C to +85∞C
•  Power Supply: +5.8 VDC
•  Nominal Current Consumption 360 mA
•  Dimensions: 149mm(L)  x  47mm(W)  x  33mm(H)
•  Weight: 0.25 kg
•  Display output: 2 line  x  16 character VFD display output.
•  Indicator output: 3 separate LEDs
•  Lead type & length: 2 meters long – 6-wire (24 AWG) – with shielding.
•  Connector type: 8 position plug
17233_SGould  08/15/02  14:46  Page 36 

CR-SRF100/CR-SRT10037
8.3. FM Modulator … (CY-ZX0160Z)
SPECIFICATIONS:
• Operating Temperature Range: -40∞C to +85∞C
• Power Supply: 12VDC (9 – 16), Negative Ground
• Max RMS Current Consumption 90 mA
• Dimensions: 87mm(L)  x  106mm(W)(“ear-to-ear”)  x  22mm(H)
• Weight: 0.25 kg
• Frequency Range: 10 frequencies
(88.7 MHz  --> 90.5 MHz  in 0.2 MHz increments)
• RF Output Power: -25dB
• Max Input Audio: 2 Vrms
• Signal to Noise Ratio: > 45dB
• Stereo Separation: > 50dB
• Lead 1 (Antenna Input) type &...

CR-SRF100/CR-SRT100 38
8.4. Receiver Wiring Harness…(M2C457018)
SPECIFICATIONS:
• Connector 1 (CDU connector): 8 position plug
• Wire type & length: 4 meters – 6-wire (22 AWG) – with shielding.
• Connector 2 (I/O Connector): 20 circuit automotive connector
• Connector 3 (left audio input): white RCA female connector (0.4 meter wire length)
• Connector 4 (right audio input): red RCA female connector (0.4 meter wire length)
• Connector 5 (FM Modulator control): 2-wire connector (0.65 meter wire length):
20...

CR-SRF100/CR-SRT10039
8.5. Receiver Wiring Harness…(M2C457019)



	









 











(Included with CR-SRT100 Kit)
SPECIFICATIONS:
• Connector 1 (CDU connector): 8 position plug
• Wire type & length: 6 meters – 6-wire (22 AWG) – with shielding.
• Connector 2 (I/O Connector): 20 circuit automotive connector
• Connector 3 (left audio input): white RCA female connector (0.4 meter wire length)
• Connector 4 (right audio input): red...