Panasonic Network Camera Recorder BB-HNP11A Operating Instructions

							Operating Instructions (Additional Features)
11
Converting the Recorded Images to MPEG files
1.Select a camera preview on the camera list.
 The selected camera is displayed in a blue frame.
2.Select the recorded images to convert to MPEG files on the recorded image 
page.
 The selected recorded images are displayed on the screen.
3. Select [Tools] [MPEG Conversion] on  the menu  bar.
 You can select [MPEG Conversion] from the menu displayed by right-
clicking the recorded image list. 
						

							Operating Instructions (Additional Features)
12
4.If you specify the time, set the start time and end time, and then click [OK].
 The Save as ... window is displayed.
5.Select the folder, enter the file name, and then click [Save].
 The MPEG conversion is started.
 If the MPEG conversion is complete, the following window is displayed.
Notes
 If you do not specify the time, all selected images are converted to MPEG 
files.
 The audio is not saved.
 The converted MPEG file can be played back in Windows Media® Player 
(Version 9.0 or later).
 If the convertion is cancelled, the file is not saved. 
						

							Operating Instructions (Additional Features)
13
Error message list
MessageCause and Remedy
There is insufficient free space on 
the Save Destination Disk or Save 
Destination Folder cannot be 
accessed. Delete unnecessary 
recorded images or confirm the 
Save Destination Folder to be 
accessed.The destination free disk space is 
insufficient. Can not access to the 
destination drive
Follow the instruction message.
Specify a local drive. Although 
mapping this folder to a network 
drive allows you to specify this 
folder, the program may not be 
performed normally due to your 
network environment, specifying a 
network drive is not 
recommended.Folders on the network could not be 
specified as the folder.
Follow the instruction message.
Select folder.The [Select Folder] was checked in the 
Searched Target of Search window, and a 
folder is not selected.
Select a folder on the Browse for Folder 
window to click [Browse].
Set the alarm or sensor at Camera 
Registration Information Window 
or change the Recording Method 
before you enable the Timer with 
Alarm and Sensor.Though Alarm/Sensor Recording is not 
selected on Camera Registration Information 
window, tried to enable the Timer with Alarm 
and Sensor.
Follow the instruction message.
Recording Method is not correct. 
Change the Recording Method 
before you enable the Timer.Invalid information has been set in the 
Recording Method.
Follow the instruction message.
This software disabled the timer 
which has Alarm or Sensor that 
has been replaced. Set the alarm 
or sensor at Camera Registration 
Information Window or change the 
Recording Method before you 
enable the Timer with Alarm and 
Sensor.Though the Timer with Alarm and Sonsor is 
selected on Timer Registration Information 
window, tried to disable Alarm/Sensor 
Recording on Camera Registration 
Information window.
Follow the instruction message. 
						

							Operating Instructions (Additional Features)
14
This software disabled the timer 
which Recording Method is not 
correct. Change the Recording 
Method before you enable the 
Timer.Invalid information has been set in the 
Recording Method.
Follow the instruction message. 
Message Cause and Remedy 
						

							Operating Instructions (Additional Features)
15
MEMO 
						

							
Panasonic Consumer Electronics Company, 
Division of Panasonic Corporation of North America
Printed in JapanPSQX3779ZB    KK0305YT1118
2005 Panasonic Communications Co., Ltd. All Rights Reserved.
The information in this document is subject to change without notice.
Copyright:This material is copyrighted by Panasonic Communications Co., Ltd., and may be reproduced 
for internal use only. All other reproduction, in whole or in part, is prohibited without the written 
consent of Panasonic Communications Co., Ltd.