Panasonic Network Camera BB-HCM381A BB-HCE481A Getting Started Manual

Operating Instructions
103
When you set [E-mail] for Transfer Method
Select [E-mail], and click [Next>]. The following page is displayed.
 Clicking [

Operating Instructions
104
Setting Description
SMTP Server IP 
Address or Host 
Name
*1
 If you set a server IP address, set 4 numbers (0—255) and 
3 periods such as 192.168.0.253. Note that 0.0.0.0 and 
255.255.255.255 are not available. Or set a host name 
(1—255 characters).
 You can set an IPv6 address.
Port No.  Enter the number (1—65535). Usually set to 25.
Reply E-mail 
Address
*2 Set the senders E-mail address. We recommend you to 
set the administrators E-mail address.
Destination E-
mail...

Operating Instructions
105
How to 
authenticateThe authentication method can be selected: 
[No authentication], [POP before SMTP authentication] or 
[SMTP authentication].
POP server authentication may be required by your ISP. In 
that case, set POP before SMTP authentication.
 No authentication: No authentication when sending an e-
mail.
 POP before SMTP authentication: Some SMTP servers 
that send e-mails do not have an authentication feature. 
Therefore, the camera uses the authentication of a POP...

Operating Instructions
106
8.Confirm the settings, and click [Save].
 The new settings are saved.
 When finished, Success! is displayed.
9.Click [Go to Trigger page].
 The Trigger page is displayed.
Note
 If you click [Save] on the Trigger page, all buffered images on the SD memory 
card are deleted.
 If you are buffering images to the internal memory, the following operations also 
delete all buffered images.
– Turning off or restarting the camera.
– Updating the camera.
– Resetting the camera to...

Operating Instructions
107
4.3 Buffering or Transferring Images by Alarm 
Signal
You can buffer the camera images, transfer to an FTP server or send E-mails using 
alarm as a trigger.
The Trigger page allows you to enable image buffer/transfer by E-mail or FTP.
Note
 If you are recording images to the SD memory card, refresh interval slows 
down.
 To buffer/transfer images by alarm signal, an alarm must be connected to the 
external I/O (see page 164).
1.Click [Trigger] on the Setup page.
2.Click a No....

Operating Instructions
108
4.Set the time, and click [Next>].
 Clicking [

Operating Instructions
109
5.Set the Lens Position When Triggered setting, and click [Next>].
 Clicking [].
 Clicking [

Operating Instructions
110
7.Set the image buffer frequency, and click [Next>].
 Clicking [

Operating Instructions
111
8.Select the transfer method, and click [Next>].
 Clicking [

Operating Instructions
112
When you set [FTP] for Transfer Method
Select [FTP], and click [Next>]. The following page is displayed.
 Clicking [